2018 CHRYSLER PACIFICA Complaints

My van completely shut off, and all lights on the gear shifter stopped working. Yes, it is available for inspection until the gear shifter is replaced, as recommended by the dealership. The van lost power just as I lifted my foot off the brake to proceed into an intersection. This sudden shutdown created a traffic backup behind me and could have put me and others in danger had I entered the intersection. The issue has only occurred once for my husband while driving but has not been officially reproduced or confirmed by a dealer or service center. Yes. I took the van to the dealer, who suggested replacing the battery and the shifter. I replaced the battery and ordered the shifter, but the second failure occurred after the new battery was installed. In addition, I’ve noticed a continuous clicking sound coming from the van after it is turned off, which does not stop for approximately 5 minutes. There were no warning lights or messages before the failure. After the van shut down, the “start assist” light came on, and it did not turn off until about four days after the battery replacement.

The shifter nob will not turn on and move out of park. When I open the glove box and tap on the CAN-C Bus star connector the nob will then turn on. Other issues also with electrical throughout van dealing with the CAN-C such as driving and then it shifts very hard. And door not closing on the side.

Vehicle will start but the shifter will work. It threw a check engine light and check hybrid system code. You cannot get the vehicle out of gear and the shifter will not light up. After shutting the vehicle off and on 3 times it erased and acted like it never happened. This is the third time it has happened. What’s bad you can drive somewhere and be stuck there for hours not knowing if you need a tow or it’s going to reset again. Don’t know if something my happen while driving as well.

Electrical adaptive, cruise control, forward collision warning, and shifter all malfunctioned. It is available for inspection. There was failure to accelerate at an intersection which almost caused vehicle to be rear ended. The error codes have been pulled and shown by O’Reillys auto parts. The vehicle is pending inspection by an independent mechanic. The adaptive cruise control the Ford collision, warning and service shifter warning lamps all appeared shortly before this problem occurred.

The transmission KICKS into 2nd gear at times and it feels like I've been rear ended. Also sometimes when that happens the car will accelerate on it's own, I am surprised that I haven't hit anything or anybody when that happens. And other times it will cut out altogether and loses power. This is definitely a safety issue. I can't understand why Chrysler will not do anything about this issue. It can be very dangerous. This has been going on for the 4 years that I have had the van.

Auto start/stop alarm displays in dash. Have taken it to two different dealerships and they say they can find no problem. They car hesitates when stepping on the gas. There have been incidences when the car stalls all together. We have now noticed that the issue is more prominent when the weather temperature is hot like over 90 degrees but especially if the temperature is over 100 degrees. Also just recently within past few weeks the car will stall but keeps going though you cannot accelerate, however, you do not lose steering ability. You have to pull off the road and shut the car down and restart it and then all components work properly. Again this is happening when weather temperatures run high. This has been an issue last year as well. I called Chrysler and got a Star Case # 91330213 but then we stopped having the problem. Most likely because it got cooler but we are having issues again this year now. What is interesting is that the dealerships say they cannot find any code being set off because at times the auto start/stop alarm will reset and then they say they do not see an issue. Yet we know there has been an issue & continues to be an issue.

While slowing to a stop at a traffic light, the engine stalled unexpectedly. The start/stop system did not restart the engine when I released the brake pedal. Accessories (radio, lights, etc.) remained powered, but I could not shift the vehicle into neutral. After approximately 20 minutes, I was able to restart the engine; however, the transmission remained unresponsive and the engine could not be shut off using the ignition button. I was unable to shift to neutral or turn the steering wheel. Message on dash indicated shifter module required service, and indicated that the vehicle was not in park when attempting to turn off vehicle. The vehicle was only turned off by disconnecting the 12-volt battery. The vehicle was towed to a Chrysler dealership and diagnostics completed, showing error codes with the shift module. They were unable to recreate the problem and advised replacing the shift module. When inquiring about recall V53, the dealership service department indicated that this recall had been repaired on the vehicle in 2020. These symptoms match those described in Chrysler Recall V53 (NHTSA Campaign 19V-348) for 2017–2019 Chrysler Pacifica vehicles equipped with start/stop systems, which involves a loose battery ground connection. My VIN is not currently listed in the recall as it was reportedly corrected in 2020, but the issue created a hazardous situation by stalling in traffic, disabling shifting, and preventing engine shutdown. This could have resulted in a crash if traffic conditions were different. Please investigate whether additional 2018 Chrysler Pacifica vehicles not currently included in Recall V53 should be covered or if this is a recurring safety issue with the engine start-stop (ESS) on 2017-2019 Chrysler Pacifica vehicles.

This vehicle experience is intermittent installing or fails to restart after the engine shut down I verified there are currently no open recalls and I believe this may be related to a known PCM or emissions related issue

The battery of my hybrid electric minivan was damaged during a recent factory recall, and Chrysler is refusing to correct the problem. Instead, they’re trying to charge me for a new battery. Here’s the background. I recently received a recall notice (73B) for my 2018 Chrysler Pacifica hybrid minivan that warned of a possible vehicle fire. I was advised not to recharge the van and to park outside and away from structures. In January, I took the van to Russ Darrow Chrysler in the Milwaukee Auto Mall to address the issue. The check engine light came on shortly after the recall work was complete (trouble codes U0412 and P0BBE). I took the van back to the dealership as soon as possible. I was told there was a serious problem with the high-voltage battery and that it may need to be replaced. Chrysler refused to authorize the repair, so the dealership cleared the codes and released the van back to me. On [XXX], the van lost all power while my wife was merging onto a busy highway. She managed to pull over, and we had the van towed back to the dealership. The van has now been at the dealership for over 4 months. Chrysler is still refusing to fix the problem. I have since learned that there are many customers experiencing similar battery failure following the 73B recall. The Pacifica Forums (link below) details over 80 customers experiencing nearly identical battery failures after bringing their vehicles in for this recall. My safety and the safety of others are at risk. The symptoms my vehicle is exhibiting are precisely the kinds of faults the recall's software update is supposed to detect. By refusing to provide the full remedy, the manufacturer has left an unresolved fire hazard as well as the risk associated with the sudden loss of propulsion. Thank you, [XXX] [XXX] Link: [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Quirk Chrysler Dodge Jeep RAM Of Dorchester refused to perform Recall 73B/24V-536 on my restricted-title Pacifica (reconstructed), citing Chrysler policy. That policy doesn’t exist in the recall bulletin. I need the BPCM software update and any necessary battery replacement under the recall.