2018 CHRYSLER PACIFICA Complaints

On [XXX] I brought my 2018 Chrysler Pacifica to Matt Bowers for some warranty work and to check a front end creaking noise that was most prominent and unstable feeling while in reverse with the wheel turned. They performed the warranty work and notified me that the noise I was hearing was from the cv axles and that they didn't need to be replaced immediately but would need replacement if they got worse and noted that it was very low mileage for this issue. (Around 40,000 miles) The noise continued but has gotten worse lately and has felt much more unsettling in reverse so I brought it to a local mechanic to confirm it was in fact the cv axles. He confirmed the axles need to be replaced and also told me he thought there was a recall relating to cv axles on the Pacifica. I looked it up and found Safety Recall U80 / NHTSA 18V-493 front halfshaft which covers Chrysler Pacificas manufactured between 2/22/2018 to 6/11/2018 with MDH of [XXX] My Pacifica's manufacture date is June of 2018 and has a MDH of [XXX] which falls within the scope of the recall. I called the FCA recall center on [XXX] at 1-800-853-1403 and was told I wasn't covered under the recall. I have no service lights on but have cv axles that are severely prematurely worn on my vehicle which only has about 60,000 miles affecting the overall safety and performance. My vehicle falls under the listed recall and Chrysler has failed to make this issue right. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The vehicle display reads "Service Charging System" and switches into limp mode where the vehicle is prevented from driving faster than 15 mph. After leaving the van sit for a time, it drives ok. I took the van to a Chrysler dealership twice after this happened, and the dealership could not resolve the issue. After the second time this happened, the dealership contacted an engineer at Chrysler to try and resolve the problem, but they could not. Chrysler says the problem stems from the charger that is being used, but the error/limp mode occurs not after using a charger. I am concerned that the vehicle will switch over to limp mode at any time presenting a safety risk.

The transmission gives out and loses power to the wheels. This is very unsafe!! Was taking a left turn and lost all power and was almost hit. This happens all the time but the other day was almost my last……

When driving slow or even coasting, between 5 to 20 MPH, the transmission SLAMS, KICKS, CLUNKS with speed up little bet . You don't even have to have your foot on the gas, it just does it. It's also happened when accelerating from a low speed, like from 10 Mph to 30 mph. And happen at the freeway when leaving the gas to lower the speed will kicks and Speed ??up a little and one time in Crossroads my foot over the break the engine was off then i released my foot the engine start I couldn't take left because the light came red so i put it on reverse didn't move then forward same the transmission doesn't respond then i put it on parking and wait then put it reverse and moved that's i was blocking one line of my left to right side.(( Its look like with all Incident the transmission shut off and on or shift it self to N then return back D ))

The #5 cylinder keeps having a misfire sometimes causing failure of the vehicle to get up and move when needed in an emergency Situation this being a family van make even putting children in danger at times. After inspection by myself a Mechanic that even taught College Automotive repair, I have also taught Jet engine repair I find this concerning. Is what is happening is the head gasket is leaking coolant into the #5 Cylinder and we all know water will not admit a spark. Rust can be seen on the Valves and top of Piston cylinder upon inspection. This is a well know issue across the United States and Chrysler Dealers and manufacturers, their mechanics, parts and service departments also know this. This is poor workmanship inferior parts. But the most concerning is not being able to get a response out of the vehicle to get out of the way in an emergency situation and that the owners of Chrysler Corporation do not care. With the cost the consumers paid for these Vehicles it should not have to fall on them due to the inferior parts and workmanship of the manufacturing Company. The Average Consumer cannot afford to fix this issue, and some are still paying for their Pacifica's Immediate action should be taken with this problem as many Babies, Children and adult lives are being put at risk. I would recommend to stop driving these vehicles immediately until the problem is resolved. Accident waiting to happen possibly causing bodily harm.

Tried to start car. When start button was pressed the dash lit up like a Christmas tree. Multiple error messages. FCW unavailable, power steering unavailable, fuel door open, park brake unavailable, park sense unavailable, Service hybrid electric system, power steering unavailable. The gear indication, both on dash and by shifter was flashing. The car would not turn off. I had to open hood and disconnect 12v battery for the car to power off. Waited 10 seconds and connected 12v and it power on, but the check engine light is still active

Bought my 2018 Chrysler Pacifica used on December 8, 2022, with 70,649 miles on it. I have had issues with a hard shift in my power train. It doesn't do it when transmission is cold and it doesn't do it all the time. My engine light comes on, but it doesn't show any codes for the hard knock. It has been to 2 different dealers including Chrysler on several occasions without the issue being resolved.

Received message that Start/Stop component was not working. A few weeks later, check engine light came on. Brought to mechanic, was told to replace main and auxiliary battery. Paid to replace those and two days later, got both the start/stop message and the check engine light again. Brought back to mechanic who, upon finding countless other consumers who have had the same issue, found a blown head gasket with coolant leaking into the engine. Our vehicle has only 44k miles on it and is at risk of overheating while driving and the engine may be damaged.

The seatbelt looks as though it has been cut partially through by the fixed seatbelt guide on the middle row of seats. Those seatbelts hold in place two car seats for a young child and an infant. The seatbelts rarely get moved because we keep the car seats secured to the two middle row seats. The seat belts were briefly inspected by a service advisor at the Chrysler dealership, Taris, who stated that it looks like it could have been done by the seatbelt guide. The first time I noticed it was just on the driver side back in 2022. When I noticed an identical cut on the passenger side about a week to two weeks ago, I knew that there was a problem, and I also noticed that there is a secondary cut starting on driver's side because in March we had another baby and placed a new car seat base on the driver side seat. The driver side seat belt is now locked into place and cannot be viewed unless the side interior panel is removed. That has not been done at this time.

The check engine light came on and the vehicle experienced a slight loss of power. Later the Start/Stop indicator light cam on with a message saying it has malfunctioned. Upon driving the van continues to have issues going up hills and accelerating from a stopped position. The check engine light remains steady without blinking.