2021 FORD ESCAPE Complaints

1) Flapping noise from left front brake. New car with less than 3,300 miles on it. Taken to dealer. Found to have BOTH front brake rotors warped. 2) Dealer STILL has not contacted us about parts availability for recall on brakes (Nov 2021) Please note that this is the 3rd complaint filed on the same vehicle. Other complaint numbers are 11452046 and 11452039.

Felt sudden, hard bang under left foot while driving approx. 40 MPH. Car then lost control. Driver steered to right to get off road, hitting a curb in the process. Found broken left front axle when finally able to stop the car. There were NO obstacles or potholes to cause this accident (photos).

Passenger wiper arm comes loose and does not maintain position, causing wiper to either not work at all or misalign and cross the driver side wiper. Result is impaired visibility. Both episodes occurred in winter weather. Have had two episodes so far (1/12/22, 2/11/22) both requiring dealer service to re-align wipers to factory spec and tighten. On 2/11/22 both wipers became entangled during freeway driving, destroying both wiper blades and causing dangerous driving conditions due to poor visibility in rainy conditions. On 1/12/12 the dealer's service adviser showed owner location of the screw that holds wiper, and advised that when it comes loose, here's how to tighten it then come to dealer for it to be returned to factory spec. On 2/11/22 the dealer's service tech blamed driver for using windshield wipers "with powerful motors" when it is rainy/icy outside.

I was coming to a stop at a red light when my brakes began to get hard to the point to where I couldn’t press them down. I then rear ended another vehicle. It seems to me that the power brakes might have failed. After crashing my brakes seem to go back to normal but still felt abnormally stiff. There was no injuries in the accident. The car is under an open recall stating this exact problem. I contacted our local dealer the day I found out about the recall and they told me that the car was to drive and parts would not be available until the 2nd Quarter of 2022. The recall also states that it only happened under certain circumstances. I will not be driving the vehicle until after recall is fixed because it is an unsafe vehicle to drive due to not knowing when the brakes might fail again.

I rented this Ford Escape from Avis this month and ran into what could have been an incredibly dangerous safety issue due to a massive oversight in the car's design. I installed a small booster seat in the passenger side back seat for my 10 year-old son. He got in the seat and attached his seat belt, which he has done hundreds of times before in our own car. About 1 hour into a 2-hour freeway trip, a notification went off on the dashboard, telling me that a seat belt in the back had come undone. My son tried frantically to reattach the buckle but was unable. I had to exit the freeway and park on the side of the road. When I tried to reattach the buckle, I saw why there was a problem: He had inserted the buckle into the CENTER receptacle, not the passenger-side one. The receptacle didn't click, as it was probably designed not to do, but because the metal of the buckle has a slight angle to it, there was enough tension for it to temporarily hold. However even a minor accident could have been fatal because my son wasn't property strapped in. There are several issues here. First, the dash indicator should have been designed to tell me that there was weight on the right rear seat but no buckle was attached to that receptacle. Second, the center receptacle did not immediately reject the right-most buckle; instead, the bent angle of the buckle's metal temporarily held it in place and made my 10 year-old believe he was strapped in. Finally, the receptacles themselves have no play from side-to-side. This, plus the angle of the buckle's metal, means that when a booster seat is installed, there is not enough room to fully attach the buckle into the receptacle without exerting a LOT of force to push the receptacle to the left. I can't imagine the buckle can be attached at all with a larger child seat. The image I attached shows why this is; attaching a car seat requires exerting enough force to bend the metal holding the receptacle in order to attach the buckle.

The contact owns a 2021 Ford Escape. The contact received a recall notification for NHTSA Campaign Number: 21V922000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

My daughter was coasting and the person in front of her slammed on their brakes causing her to slam on hers. Her collision warning did not go off until after she hit the car in front of her so she had didn't have enough time to stop. We pulled off into a parking lot and called the police to inspect the cars. Two weeks later there was a recall on the back brake pads. She ended up getting a ticket for impeding traffic which ended up costing $150.00 plus $5.50 for fees. I also have damage to the grille and bumper on my car that needs to get fixed.

While driving on the interstate a fire started under the hood and shortly after smoke entered the driver cabin. Luckily I was able to pull over and get out of the vehicle before the fire reached the driver cabin. It is going to be investigated by a company hired by AAA, the appraiser from the insurance company was not able to find a cause due to the fire damage being too bad. The first warning message was engine coolant overtemperature and a couple of others followed.

The contact owns a 2021 Ford Escape. The contact received a recall notification for NHTSA Campaign Number: 21V922000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The Electric Motor Cooling Pump failed and shut down the engine without warning. It occurred the first time on Route 1 at night and about two weeks later it occurred three consecutive times as I was driving on a local street. I was able to restart the car but was told by the dealership to have it towed to them, where it remains now while waiting for the part to arrive (which is on national back order). My safety and the safety of others was put at risk when I lost all power and only through sheer luck was I able to pull over safely. This problem was diagnosed at the dealership.