2013 FORD EXPLORER Complaints

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that while driving at an undisclosed speed, the front driver’s side A-pillar trim detached. Additionally, the front passenger’s side A-pillar trim was loose, and the driver’s side A-pillar trim was temporarily repaired using duct tape. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was unavailable.

The contact owns a 2013 Ford Explorer. The contact stated that while driving 40 MPH and coming to a stop at a red traffic light, the messages "Power Steering Failure" and "Service Advancetrac" were displayed. The contact was able to drive to the residence; however, the steering wheel was jerking slightly from left to right while driving. The vehicle was taken to an independent mechanic, where it was diagnosed, and the mechanic determined that the failure was related to NHTSA Campaign Number: 14V286000 (Steering). The contact was referred to the dealer for assistance and was informed that the VIN was not included in the recall. Additionally, the contact stated that the rearview camera was intermittently inoperable while reversing. The vehicle was not repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 150,000.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated while driving approximately 50 MPH, the front driver’s side A-pillar trim detached. The local dealer was contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 65,000.

The contact owns a 2013 Ford Explorer. The contact stated that while driving at an undisclosed speed, the A-pillar trim on both sides of the windshield started to detach. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The local dealer was contacted and confirmed that parts were not yet available. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The approximate failure mileage was 140,000.

The molding flew off my car when I was driving 60 miles an hour … very lucky it didn’t cause an accident as I had to swerve into oncoming traffic when it flew off. It happened in Sept 2024 October 25th is when when we brought it in to ford Geneva, NY They said it was a special order and needed to be ordered and would call when it arrived Never heard back Recently called to follow up Said it still didn’t come in and will call with no resolution to date.

The contact owns a 2013 Ford Explorer. The contact stated that on several occasions while in reverse(R), the camera image fluctuation on and off, and the image then froze intended and the back over prevention camera became inoperable. Additionally, the message to "Contact the Dealer" was displayed. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was approximately 78,000.

My problem is with my back up camera. The sides are reversed when it comes on. Left is right and right is left. This is a serious safety defect that may cause an accident one day.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (STRUCTURE); however, the part to do the recall repair was not yet available. The contact stated that while driving at undisclosed speeds, the passenger’s side A-pillar trim detached from the vehicle. The vehicle was taken to the dealer. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was unknown.

The contact owns a 2013 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the vehicle was taken to a local dealer, and the front A-Pillar trims were removed to avoid a failure. The contact stated that the vehicle was left with the A-pillar trims unattached. The local dealer was contacted on several occasions; however, parts were not available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.

Why is it taking Ford years to fix body molding for a recall. It would appear they are not going to comply with the recall and hope they wait long enough they can age out the vehicles and there won’t be any left. I don’t understand why N.H.T.S.A is night having FORD comply with the recall.