2019 FORD EXPLORER Complaints

My wrench light came on in my 2019 Ford Explorer with 2.3L engine last week. It caused my vehicle to have lack of acceleration during launch and shudder while driving. When my son and I took off from a stop, it was very slow when crossing traffic. Made appointment with Ford dealership to have it looked at the next morning. After car was parked and restarted, wrench light went off. Kept appointment and told them a mechanic friend said it sounded like the torque converter (which my mother who has a 2019 Ford Edge just had replaced the week before!). Explained this to the dealership, they said it didn't sound like that was it. 4 wheel drive module was corrupt so they updated it and told me I may need a new transmission in the near future. Today, my light came on again while taking my son to school and caused lack of acceleration while pulling onto the highway and I took it to the dealership while it was lit up. Codes P0767 and P2704 showed and they told me it was I needed a new transmission due to my torque converter failing. I checked into it and Customer Satisfaction Program 20N07 does not include my car even though it is doing the exact same thing and was assembled in Chicago in January 2019 (timeframe of the program and location). I just don't understand how my car doesn't fall under that program when it is DOING THE EXACT SAME THING with only 67,200 miles on it. This is a serious safety concern. So thankful that there was not heavy traffic when I pulled onto the highway.

The contact owns a 2019 Ford Explorer. The contact stated that the horn was inoperable. There was no warning light illuminated. The dealer was notified of the failure and an appointment was scheduled to perform a diagnostic test. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 74,000.

The contact owns a 2019 Ford Explorer. The contact stated that while driving at an undisclosed speed, the exterior B-Pillar trim detached. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. After investigating the failure, the contact related the failure to NHTSA Campaign Number: 24V031000 (Structure). The manufacturer was notified of the failure but provided no assistance because the recall did not include the B-Pillar. The failure mileage was 96,000.

Drivers door will not lock. It will only lock if you push it down but doesn’t lock when taking off like it’s supposed to for safety.

Needs a full transmission replacement and only have 80,000 miles on it. Bought new from dealership in 2019.

Operator law enforcement was idling for an extended time in this vehicle. He was found unconscious in the vehicle and diagnosed with acute carbon monoxide poisoning. He was hospitalised for 4 days, and suffers continuing neurological deficits. Post-incident testing by engineer instructed by operator indicated two improper or incomplete welds on exhaust system, allowing exhaust to pool under vehicle and enter passenger compartment through HVAC fresh air intake. Post-incident testing recreated rising CO levels in passenger compartment. Vehicle has also been inspected by manufacturer. There were no warning lamps or messages.

VEHICLE SHIFTS ROUGH. I WAS TOLD BY FORD THAT I NEED TO REPLACE MY BATTERY EXCEPT I DO NOT HAVE ANY BATTERY ISSUES AT ALL. ALSO WHEN I PUT MY VEHICLE IN PARK IT ROLLS FORWARD A LITTLE.

The contact owns a 2019 Ford Explorer. The contact stated that the front windshield was slightly detached from the vehicle. While driving at various speeds there was a whistling sound coming from the windshield. The vehicle was taken to an auto body shop where it was diagnosed that there was mold along the sides of the windshield panel causing the windshield to detach. The vehicle was not repaired. The manufacturer was made aware of the failure, and it was confirmed that there was no recall on the VIN for the failure. The contact was referred to the NHTSA Hotline for assistance. The approximate failure mileage was 50,000.

My 2019 Ford Explore XLT wouldn’t shift right, kinda hesitated to lock. My RPM were jumping like crazy. My mechanic replaced my torque converter and throttle body. Now my vehicle drives fine but when you stop at a stop light it shakes you to death. Then it sputters when trying to accelerate. So back to the shop it went because that can cause an accident. Not to mention if it stalks while driving. My mechanic says my torque converter is [XXX] again. After paying $4000 to have my transmission basically rebuilt a year later I’m back in the same boat. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The trim that is on either side of the front windshield has come loose. The one on the driver side came loose while I was on the interstate and struck the vehicle behind me. It caused the driver to lose control and spin out. Fortunately, it did not cause a collision, but it could have caused a loss of life, we were travelling at highway speeds. The trim on the passenger side was still on the vehicle, but it had popped loose and was sticking up at an odd angle. I removed it to prevent the same thing from happening.