2019 FORD EXPLORER Complaints

The contact owns a 2019 Ford Explorer. The vehicle was taken to the local dealer to be repaired under NHTSA Campaign Number: 26V101000 (Suspension). While retrieving the vehicle, the vehicle failed to start. The contact heard the mechanic revving the engine of the vehicle. The dealer determined that the fuel pump and fuel pump module needed to be replaced, and that the failure was not related to the recall repair. The vehicle was not repaired. The manufacturer was contacted and determined that the failure was not related to the recall. The failure mileage was approximately 50,000.

The contact owns a 2019 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the driver's side windshield exterior A-Pillar trim had started to detach while driving. The dealer was notified of the failure, but the vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was approximately 150,000.

Ford had a recall on a Explorer's roof rack covers...In 2021 the dealer glued down the covers. Over time the glue has gone bad and both roof racks are loose causing concern. I recently found out that there was a fix for this. It was installing Christmas tree push clips into cover to secure them. I recently went to the dealer (Sayville Ford, [XXX] ) and inquired about this and adviser stated not recall on file since it was done in 2021. Both roof rack covers are defective. Structure: Body Recall date 2021-05-04 Recall no. 21V316000 Ford Motor Company (Ford) is recalling certain 2016-2019 Explorer vehicles. The retention pins could loosen and allow the roof rail covers to detach from the vehicle. Hide details Recall consequence A detached roof rail cover can create a road hazard, increasing the risk of a crash. Recall action Dealers will install push-pins and replace any damaged rail clips and roof rail covers, as necessary, free of charge. The interim owner notification letter was mailed on June 22, 2021. Owner notification letters (remedy available) were mailed on October 1, 2021. Owners may contact Ford customer service at [XXX] . Ford's number for this recall is 21S22. My vehicle never had push pins inserted according to this recall. Please advise on any help in this matter. I wait your response. Thank You [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The a-pillar applique trim, which borders the left and right side of the front windshield of my 2019 Ford Explorer has been under recall since January 2024. I've taken it to Bill Utter Ford in Denton, Texas, on four separate occasions to ask for it to be repaired. Generally stated, every six months since the recall. They tell me its too bad, there are np arts to repair it. Question, how can you all allow 2 years to pass and not force them to do something? On March 29, 2026, the drivers side piece came flying off at 30 miles per hour. Luckily no one was behind me. Now my windshield has no protection trim. Further, I cut my right hand trying to force the broken pieces back in.

The B post on the driver side flew off while driving. This is has been an ongoing issue. Ford has fixed them before and they keep causing issues on both the driver and passenger side. The exterior panel does not stay connected to the truck. It flew off at highway speeds, causing the air and rear tailgate to malfunction after it pulled a wire out. This is a huge safety issue ford refuses to acknowledge.

My ford dealer will not check 4 wheel alignment at no charge to me. I have two articles that it is mandatory to do a 4 wheel alignment after replacing the rear toe arms on my 2019 ford explorer.

The contact called on behalf of the owner of a 2019 Ford Explorer. The contact received notifications of NHTSA Campaign Numbers: 24V031000 (STRUCTURE) and 26V101000 (SUSPENSION). The contact stated that after the vehicle was stopped at a traffic light, the vehicle stalled. The battery warning light was illuminated. The contact was able to restart the vehicle. The contact stated that the failure was occurring every other day. The vehicle was taken to an independent mechanic. The independent mechanic replaced the Manifold Absolute Pressure (MAP) sensor and an unknown sensor; however, the failure persisted. The contact stated that on a separate occasion, while the vehicle was idling, the vehicle stalled. The vehicle was restarted. The contact stated that while the temperature gauge was midway, the vehicle stalled. The battery warning light was illuminated. The contact stated that whenever the temperature gauge was midway, the vehicle would stall. The vehicle was taken to another independent mechanic who replaced a fractured spark plug and the timing chain. The vehicle was repaired; however, two months after the last repair, the failure reoccurred. The manufacturer was not made aware of the failure. The failure mileage was approximately 130,000.

Similar to NHTSA Recall Number 24V031, driver's "B-pillar" trim (top edge) has detached and loose, and is only secured in-place by remaining anchors/attachments. In inspecting underlying substrate, it appears that a mechanical anchor is missing AND adhesive exhibits cohesive failure (remainder adhesive on both supporting/underlying substrate and backside of trim.

Torque converter failed and had to be replaced within 60000 miles. Know issue to ford but they continue to charge $4,000 to have it repaired. Rear main seal leaks oil within 80,000 miles. Know issue to ford and they continue to charge $3,800 to have it repaired.

I am writing to formally report an issue regarding Safety Recall 24S02 on my 2019 Ford Explorer, which is incorrectly shown as completed by Cornerstone Ford in Elk River, Minnesota. This recall involves the exterior A-pillar trim on 2011–2019 Ford Explorer vehicles and is a documented Ford safety campaign (24S02 / 24V031). According to Ford’s records and Cornerstone Ford’s reporting, Recall 24S02 is flagged as completed on my vehicle on Jun 2025; however, the actual recall repair has never been performed. It appears only on an estimate repair invoice from July 2025, and I have text message correspondence from the dealer dated December 19, 2025, stating that the part had arrived, yet no recall work was scheduled or completed. Notice on Invoice (attached): [Primary]: S100 - RECALL RECALL RECALL - C/S: NO REMEDY AVAILABLE YET-24S02 EXTERIOR A PILLAR APPLIQUE INSPECTION I am unable to take it to a different dealership because it has been flagged as completed. I contacted Ford's Customer service, and they are taking the dealership's word.