2017 FORD EXPLORER Complaints

My Explorer had Recall 21S32 completed at the dealership on April 1st. The remedy for recall 21S32 was insufficient. Within a month and a half I began hearing a metal clanking noise coming from the rear of the Explorer when I went over bumps. Very quickly the clanking became a lot of frequent loud squeaking. I brought it back to the dealership and they immediately heard the noise and were able to diagnose the problem as coming from the driver side rear wheel knuckle bushing. The service manager and the master technician both agreed that the suspension problem are a direct result of the recall work that was completed. While the Toe-link recall work was done correctly, the new torque placed on the knuckle bushing directly relating to the recall work has caused it to fail. It is obvious that the underlying defect caused the rear wheel knuckle to fail, leaving the vehicle unstable. Ford corporate is refusing to resolve the secondary structural damage caused by their defective safety component and their Safety Department refuses to provide a timeline for assistance.

Received recall 25V347 in June of 2025. They still say the parts are not available. The driver side B-pillar trim came loose a few months ago. The dealer (lithia ford, Boise, ID) said I would have to pay over $600 to have them repair it and the money would not be refunded when the recall parts are available. Not having the parts available for over a year is unreasonable.

Regarding Safety Recall Notice 25S53 / NHTSA Recall 25V347, I received the recall literature June 2025. This past week, a trim piece in this recall came off the vehicle while in motion. This is a safety hazard and can cause accidents. Upon reaching out to Ford, NO remedy is available and might have something (might) November 2026. That is too long to wait for other pieces to fall off and possibly create accidents. I can't understand why it has taken over a year now to come up with a remedy. Obviously they are aware of the seriousness of this failure, and this should be addressed ASAP!

My 2017 Ford Explorer XLT with approximately 236,000 miles has an ongoing EVAP/fuel vapor system problem that causes the vehicle to hesitate, stumble, and attempt to stall. The problem occurs most frequently after refueling and also when the fuel level is low. The check-engine light comes on repeatedly, and despite numerous repair attempts, the issue has not been corrected. Repairs and parts replaced have included the purge valve, EVAP-related sensor(s), charcoal canister(s), and associated tubing. Significant money has been spent diagnosing and repairing this condition, but the symptoms continue. After filling the fuel tank, the engine may run rough, hesitate, lose power, and attempt to stall. This creates a safety concern because the vehicle can unexpectedly lose power or stall while driving, entering traffic, slowing for intersections, or operating in other traffic situations. The condition has persisted despite replacement of multiple EVAP system components. Based on the repeated failures and inability to permanently correct the issue, I believe this may indicate a defect affecting other vehicles of the same model year. I am requesting that this issue be investigated due to the potential safety risk associated with engine hesitation, loss of power, and stalling.

The contact owns a 2017 Ford Explorer. The contact received notifications of NHTSA Campaign Numbers: 24V031000 (Structure) and 25V347000 (Structure); however, the parts to do the recall repairs were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that the driver's side A-pillar trim had detached, and the passenger's side A-pillar trim was loose and lifting. Additionally, the rear passenger's side door trim had detached. The dealer was made aware of the failure but confirmed that parts were not yet available to repair the vehicle. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 80,000.

The contact was the manager at a used auto dealer, and the inventory included a 2017 Ford Explorer. The contact stated that the driver's side exterior A-pillar trim had detached and fell off the vehicle. The contact received notification of NHTSA Campaign Number: 25V347000 (Structure); however, the part for the recall repair was unavailable. The dealer was contacted; however, the contact was informed that parts for the recall repair was unavailable. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 99,000.

The contact owns a 2017 Ford Explorer. The contact stated that while driving at an undisclosed speed, there was smoke coming from underneath the hood with the Check Engine warning light illuminated. The vehicle was driven to the shoulder of the road, and the contact inspected the vehicle and became aware of smoke coming from underneath the vehicle. The failure reoccurred while the contact and the contact's minor children were traveling. A nearby Police Officer assisted the contact. The contact informed the officer that the vehicle was recently purchased from a CarMax. The contact was advised to take the vehicle to the nearby CarMax. The vehicle was taken to CarMax, where the vehicle was diagnosed with engine failure. The contact was informed that the engine had severe fluid leaks. The vehicle was repaired. The vehicle was shipped back to the residence a month later. The failure reoccurred and was a persistent failure. The contact stated that the vehicle was taken back to CarMax twelve times due to the failure. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 86,000.

I am writing regarding recall 24s02, a pillar trim piece coming off. They did come of about a year ago. Woodland Ford ordered the recalled parts in January 2025. I am very frustrated at this point as is the dealership. We paid a lot of money for this vehicle and the car looks like something from a shady used car lot. Not a good look! This problem has gone on for way too long. I don’t want to hear excuses like supply chain issues or needing millions of these parts made to complete the job. These excuses are ridiculous. Ford should not be allowed to make any new Explorers and no new ones can’t be sold until this recall is resolved. They must have the parts mentioned to put on new Explorers as they are being built. I would like a pair of those for my vehicle. Also I would like Ford heavily fined and each customer paid $10k for their trouble. Our car was 60k so I think this request is reasonable. Don’t tell me to take it to dealer for temporary repairs. Those are not satisfactory and any mechanic will say the repair is unsatisfactory.

The contact owns a 2017 Ford Explorer. The contact received notification of NHTSA Campaign Number: 25V347000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that the front driver's and passenger's-side B-pillar trims had detached. The failure prevented the windows from rolling down and rendered the trunk inoperable due to an electrical short. The dealer was made aware of the failure but confirmed that parts were not yet available. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 105,000.

Rear suspension toe links have failed after prior recall repair in Canada in May of 2022. The vehicle is now registered in the US and the recall repair has failed causing driving, suspension, and extreme tire wearing.