2017 FORD F-150 Complaints

Rear view camera shuts off intermittently or shows a degraded image while backing up which creates a safety hazard because I almost crash into objects or other vehicles due to limited visibility.

The contact owns a 2017 Ford F-150. The contact stated while driving approximately 70-75 MPH, the windshield wipers started moving extremely slow until ceasing to operate. The contact stated that the windshield wipers then regained functionality but operated at a slower speed. The contact stated that the failure progressed over time and the windshield wipers became inoperable. The vehicle was not taken to the dealer to be diagnosed or repaired. The manufacturer was made aware of the failure and confirmed there was no recall on the VIN related to the failure. The failure mileage was approximately 166,000.

My truck is going me a P0720 code which tells me that my Shaft Output Sensor is bad. It is built into my lead frame. This is a known issue with F150’s I have seen. My transmission is clunky and downshifting randomly.

The mounting bolt for the lower control arm at the driver's front wheel sheared off causing the mounting on the frame to tear away completely. Wheel came off axis and loss of steering.

Truck rapidly shifted from fifth to third gear, causing the truck to jolt and lock the rear tires. This has occurred at least three times since a recall was performed on the truck’s computer several months ago. After it happened today, the truck produced the following codes: P0720 and U0102. This could be detrimental when driving at high speeds on the highway. Truck can be inspected if requested. A local Ford dealer has been informed about the issue and stated that the recall would not have caused it. No inspections have been performed due to the inconsistent occurrence of this issue.

The contact owns a 2017 Ford F-150. The contact stated that upon starting the vehicle, the engine made an abnormal rattling sound. There was no warning light illuminated. The vehicle was taken to a local independent mechanic, where it was diagnosed and determined that the cam phasers had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 68,000.

The contact owns a 2017 Ford F-150. The contact stated that while attempting to reverse out of the garage, the vehicle shut off and failed to restart. There was no warning light illuminated. The vehicle was towed to a local dealer where the vehicle was diagnosed, and the contact was advised that the timing chain and the cam phasers were faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 50,000.

The contact called on behalf of his grandson who owns a 2017 Ford F150. The contact stated that while his grandson was driving at slower speeds, the vehicle shuddered abnormally. No warning light was illuminated. The vehicle was taken to a local independent mechanic where it was diagnosed and determined that the torque converter had failed. The contact was advised to take the vehicle to a local dealer for assistance or a transmission specialty center. The vehicle was not repaired due to the cost. The manufacturer was notified of the failure and referred contact to the NHTSA Hotline for assistance. The failure mileage was approximately 175,000.

The contact owns a 2017 Ford F-150. The contact stated that the vehicle was making an abnormal rattling sound on cold starts. There was no warning light illuminated. The vehicle was taken to the dealer, where it was diagnosed that the cam phasers needed to be replaced. The dealer replaced the cam phasers; however, the failure recurred. The vehicle was not repaired. The contact related to the failure to Ford Campaign Number: 21N03. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 43,000.

I had a slight oil leak that was getting worse over time. It got to the point one day, I was seeing minimal smoke coming out from the hood and wheel wells. I was on my way home from work one day, and as soon as I got off the interstate, as soon as I stopped at the stop light, the whole hood was covered with smoke billowing out everywhere, and the scent of fire. I quickly shut the truck off and grabbed my fire extinguisher, thinking my truck was on fire. I took it to a local shop I’m familiar with, and he said both valve covers were warped, and there is a TSB out from Ford about this issue. The valve covers, over time, will warp, causing oil to slosh out onto the hot exhaust manifold, and everything else. He said they have had multiple 3.5 EcoBoost motors in, and everytime they have an oil leak, it’s a warped valve cover. He told me that Ford makes a replacement valve cover with a different material, but I see this as a MAJOR fire risk! Oil getting out and combusting on an exhaust manifold, that’s not safe at all, and could easily ignite. It really upsets me that Ford will make the new part, but not recall the vehicle to fix the issue. I had to pay $1,700 to have it all fixed and safe. I have a Foster Child and it jeopardizes his safety, along with my wife and I.