2017 FORD F-150 Complaints
View complaints related to 2017 FORD F-150. The complaints found here are submitted by actual consumers with first hand experience. There are more than 1,380 complaints submitted for the 2017 FORD F-150. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.
-
2017 FORD F-150- Baker Coty, OR
Went to hit the brakes and they went all the way to the floor and come to find out the brake line was completely shredded. I have it at Les Schwab tire center in Lincoln city right now getting fixed. It’s going to cost me $950 for all of this. And now my kids and I are stranded.
Source: NHTSA WEB SITE -
2017 FORD F-150- PERRY, OH
TRANSMISSION DOWNSHIFTED AT HIGHWAY SPEED IN RUSH HOUR TRAFFIC AND LOCKED UP REAR TIRES
Source: NHTSA WEB SITE -
2017 FORD F-150- Independence, KY
The contact owns a 2017 Ford F-150. The contact stated that when the vehicle was started, there was a loud rattling sound coming from the engine compartment. Additionally, the contact stated that on several occasions while driving at various speeds, the transmission failed to operate properly. The vehicle was taken to a dealer where it was diagnosed that the cam phasers needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 63,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
2017 FORD F-150- Castle Rock, CO
Went to my honest Big O tire shop for tire rotation. Informed that lug nuts on wheels were very hard to remove. Recommended it replace them next oil change. Why wouldn't this be a Ford problem and a recall issue? Seems to me to be dangerous and a real problem with a flat tire changed on the road.
Source: NHTSA WEB SITE -
2017 FORD F-150- Waycross, GA
My transmission will down shift into 2 gear no matter how fast I'm driving and my gear position on the dash goes out but no check engine like has come on yet this has happened multiple times in the pass couple weeks. The last time I was driving at 65 MPH and the truck down shifted and locked the back tires up and motor RPM hit 8000. The truck slid about 200 yards before it slowed down and started shifting back into 6th gear. I was pushed up into the steering wheel if my seat belt would have stopped me I could have hit the windshield. I refuse to drive this truck until it is fixed and can be proven it will not happen again. Thanks for looking into this...
Source: NHTSA WEB SITE -
-
2017 FORD F-150- SHERIDAN, WY
Truck makes loud clanking noises while shifting. Has very hard shifts between gears upon acceleration and braking. Holds transmission in certain gear till the truck almost redlines before it very aggressively shifts. Makes a grinding type sound when accelerating at low rpm.
Source: NHTSA WEB SITE -
2017 FORD F-150- Ponte Vedra Beach, FL
The contact owns a 2017 Ford F-150. The contact stated while driving approximately 50 MPH, the transmission unexpectedly downshifted. In addition, the contact stated the transmission would remain stuck in 1st gear. The vehicle was taken to a local dealer where it was diagnosed and determined that the failure was related to NHTSA Campaign Number: 24V444000 (Power Train); however, the VIN was not included. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 145,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
2017 FORD F-150- New Berlin, WI
The contact owns a 2017 Ford F-150. The contact stated while driving at an undisclosed speed, the transmission unexpectedly downshifted, and the vehicle stalled. The power train warning light was illuminated. The vehicle was able to restart; however, the failure recurred while driving. An unknown dealer was contacted. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 102,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
2017 FORD F-150- greene, ME
The 5.0L Ford F-150 Engine experienced a P2005 :Manifold Runner Control Stuck Open Bank 2. This code triggers when the powertrain control module (PCM) can't control the intake manifold runner as requested . It also experienced a P2007 This code may be set due to a bad intake manifold runner solenoid or actuator with a mechanical failure within the intake manifold runner system. symptoms included poor engine performance, reduced fuel efficiency, and engine surge. It also has a P2019 DTC CODE related to the intake manifold flow control valve/position sensor, also called known as a IMRC valve/sensor (typically located at one end of the intake manifold) which helps the vehicle’s PCM control the amount of air being allowed into the engine at various RPMs. This code is set for Bank 2 errors. This is a safety issue as my vehicle slowed down and experienced significant power loss on the highway. FORD is aware of this problem with defective parts and has not issued a recall. FORD'S answer is have the entire intake manifold replaced at the owners cost.
Source: NHTSA WEB SITE -
2017 FORD F-150- Nocona, TX
I am writing to formally submit a complaint regarding persistent and significant issues with the cam phasers in my 2017 Ford F-150 EcoBoost. I purchased the vehicle in December 2019 with 40,000 miles on it. Since then, I have experienced ongoing cam phaser problems, which have led to considerable inconvenience and expense. In February 2022, with 92,000 miles on the vehicle, I took it to a dealership for reprogramming as per Ford’s Customer Satisfaction Program (CSP). Unfortunately, this did not resolve the issue. The cam phaser problems persisted, ultimately resulting in a major repair on June 17, 2024, when the truck had 134,000 miles, costing $4,100. The repair involved: •Checking engine light diagnosis and verification of cam phaser failure. •Removal and replacement of timing chains, phasers, chain tensioners, valve covers, gaskets, and other related components. •Reinstallation and testing to ensure the problem was resolved. I believe Ford should cover these costs since the cam phaser issue is widely known and documented as a design flaw in the 3.5L EcoBoost engines, particularly those produced before 2021. Ford acknowledged this issue and updated the cam phaser design in 2021, but many owners, including myself, have experienced failures despite adhering to recommended maintenance and service procedures . I urge the NHTSA to investigate this matter further and hold Ford accountable for the costs associated with these known defects. Thank you for your attention to this matter.
Source: NHTSA WEB SITE