2000 FORD F-250 Complaints

2000 FORD F250 LEAKED DIESEL FUEL. *CC WHILE RETURNING FROM A TRIP THE CONSUMER NOTICED THAT THE VEHICLE SEEMED TO BE USING EXCESSIVE AMOUNTS OF FUEL AND WAS NOT GETTING THE PROPER MILEAGE. THE CONSUMER PULLED OVER AT A REST STOP AND NOTICE FUEL LEAKING. THE ENTIRE UNDERCARRIAGE OF THE TRUCK WAS COVERED IN FUEL. THE CONSUMER DROVE TO THE NEAREST AUTO PARTS STORE AND REPLACED THE PLASTIC DRAIN VALVE WITH A 3/8 BOLT ON THE METAL DRAIN LINE. *NM

TL*- THE CONTACT STATED THAT THE FIRST TIME HE NOTICED A PROBLEM WITH HIS 2000 F250 TRUCK, WAS WHEN HE HIT HIS BRAKES AND THE PEDAL WENT TO THE FLOOR. THE CONTACT STATED THAT HE TURNED OFF VEHICLE AND CALL THE DEALERSHIP. THE DEALERSHIP ASK THAT HE BRING VEHICLE IN. ONCE THE DEALERSHIP LOOKED AT VEHICLE THEY SAID THAT HIS BRAKE LINE HAD RUSTED OUT. THE CONTACT SAID THAT HE ASKED MECHANIC WHY THIS HAPPENED AND HE WAS TOLD THAT IT WAS BECAUSE OF THE VEHICLE SITTING FOR A PERIOD OF TIME. CONTACT STATED THAT HE ONLY DRIVES THIS VEHICLE ONCE A WEEK BECAUSE IT USES DIESEL FUEL. AND DURING THE SUMMER HE DRIVES VEHICLE MORE. CONTACT STATED THAT HE DOES USE THE TRUCK TO TOW HIS 5TH WHEEL CAMPER DURING THE SUMMER. THE REPAIR WAS DONE AND CONTACT DOES HAVE REPAIR ORDER.

WHEN I STATED MY 2000 FORD F250 SD WITH THE 7.3 DIESEL ENGINE THE MOTOR RAN ROUGH AND WOULD NOT DEVELOP ENOUGH POWER TO MOVE. THE CHECK ENGINE LIGHT CAME ON. AFTER ALMOST AN HOUR OF IDLING THE MOTOR DEVELOPED ENOUGH POWER TO MOVE. I TOOK THE VEHICLE TO THE DEALER THE NEXT DAY AND WAS TOLD THAT THE PROBLEM WAS A DISCONNECTED/LOOSE WIRING HARNESS TO THE INJECTORS AND GLOW PLUGS. MINOR PROBLEM TILL I FOUND OUT IT WOULD TAKE ALL DAY TO FIX AND COST $675. I WAS TOLD THIS WAS A COMMON PROBLEM WITH MY TYPE VEHICLE. SO I SPENT THE MONEY AND THE DEALER INSTALLED A $17.00 PART TO LOCK THE CONNECTORS IN PLACE. THIS IS A PROBLEM THAT SHOULD NEVER HAVE HAPPENED. EVEN A FIRST YEAR ENGINEERING STUDENT OR A PERSON WITH ANY COMMON SENSE WOULD KNOW TO INSTALL A POSITIVE LOCK CONNECTOR FOR AN INTERNAL WIRING HARNESS. I'M JUST GLAD THE PROBLEM SHOWED UP WHEN STARTING AND NOT ON THE HIGHWAY GOING HIGHWAY SPEEDS WITH A HORSE TRAILER BEHIND. *NM

THE VEHICLE THE CONSUMER'S DODGE RAM WAS TOWING (2000 FORD 250) HAD A BLOWOUT. THIS CAUSED THE DRIVER OF THE RAM TO LOSE CONTROL OF THE VEHICLE AND RUN OFF THE SIDE OF THE ROAD. THE RAM AND TOW VEHICLE ENTERED THE NORTHSIDE DITCH AND THE TOW VEHICLE OVERTURNED. *TS *NM

2000 FORD F250, 7.3 DIESEL, FUEL LEAK FROM PLASTIC DRAIN VALVE ON THE MAIN FUEL FILTER. LEAVING A TRAIL OF FUEL ALONG THE ROAD. AND UNDER CARRIAGE OF THE TRUCK LOSING ABOUT 4-6 GALLONS OF FUEL. NOTHING HAS BEEN DONE SO FAR. OTHER THAN CONTACTING FORD. FILTER DRAIN VALVE, ON TOP OF THE ENGINE, NEEDS TO BE REPLACED. THIS HAD THE POTENTIAL OF FIRE, CAUSING SERIOUS INJURY AS WELL AS DAMAGE TO THE TRUCK, AND ENVIRONMENTAL SAFETY. *NM

CAMSHAFT POSITIONS SENSOR FAILURE NEARLY CAUSING ACCIDENT AS TRUCK QUIT RUNNING HALFWAY THROUGH INTERSECTION. FORD CPS FAILURES ARE OFTEN AND FAIL FOR NO REASON AND WITH NO WARNING. *NM

TRUCK WAS RUNNING SLUGGISH. ON NIGHT OF OCCURRENCE, TRUCK STALLED IN HIGHWAY, RESTARTED, STALLED FOR GOOD. WAITED 2 HOURS FOR TOW TRUCK ON BUSY HIGHWAY. HAD TOWED TO FORD DEALERSHIP AND THEY REPLACED THE CAM SHAFT POSITION SENSOR FOR $430.00. I DO NOT HAVE THE OLD PART. *JB

I HAVE A 2000 FORD F250 SUPER DUTY 4X4 7.3 DIESEL. WHILE DRIVING OVER A MOUNTAIN PASS ON 11-4-06 THE FRONT END STARTED SHAKING VIOLENTLY AND I ALMOST LOST CONTROL OF THE VEHICLE. I MANAGED TO STEER IT TO THE SIDE OF THE ROAD WHERE I DISCOVERED THE LEFT FRONT HUB ASSEMBLY/ WHEEL BEARING HAD FAILED AND THE TIRE AND WHEEL WERE FALLING OFF THE VEHICLE. THE TRUCK WAS TOWED TO A LARGE DEALER WHERE BOTH FRONT HUB ASSEMBLIES WERE REPLACED. THESE HUB ASSEMBLES ARE A SEALED UNIT WITH NO WAY OF SERVICING THEM. THIS REPAIR IS VERY EXPENSIVE( 450.00) PER SIDE FOR PARTS + LABOR. THE DEALER STATED THAT THIS HAS BEEN A PROBLEM WITH THESE TRUCKS AND COULDN'T UNDERSTAND WHY FORD HASN'T RECALLED THE PROBLEM,AS THEY ALONE HAVE REPLACED CLOSE TO 65 UNITS AND THIS IS JUST ONE DEALER. NEEDLESS TO SAY FORD WOULDN'T STAND BEHIND THE REPAIR AND I HAD TO PAY IT MYSELF. THIS IS A VERY DANGEROUS SITUATION IN THAT IF THIS WOULD HAVE HAPPENED AT HIGHWAY SPEEDS IT WOULD MOST CERTAINTY CAUSED TOTAL LOSS OF CONTROL OF THE VEHICLE. I HAVE 4 FRIENDS AND MY BROTHER WHO ALL HAVE HAD THIS EXACT SAME PROBLEM AND ONE,MY BROTHER, HAD DAMAGE TO HIS VEHICLE WHEN HE LOST CONTROL. THIS IS THE 2ND TIME THIS HAS HAPPENED TO ME AND AM PERPLEXED WHY FORD DOESN'T ADDRESS THIS SAFETY PROBLEM. *NM

MY CAMSHAFT POSITIONING SENSOR WENT OUT ON MY 2000 F250 IT SHUT OFF MY MOTOR WHEN I WAS GOING 70 MPH AND I LOST ALL POWER AND WAS VERY CLOSE TO CRASHING. IT WAS FIXED EASY WITH A NEW CPS BUT THIS SHOULD OF NEVER HAPPEN. *JB

1. TRUCK RUNNING CORRECTLY. 2.ENGINE STOPPED, PULLED OFF ROAD, TOW REQUIRED TO FORD, ROCKLAND MAINE . 3. CPS REPLACED, ENGINE RUNNING FINE. NHTSA ACTION #: PE06011 SYNCHRONIZER OR CMP SENSOR. *NM