2001 FORD F-250 Complaints

WHEN APPLYING BRAKES, THE PEDAL WENT SLOWLY TO FLOOR. PUMPING BRAKES HELPED IN STOPPING FAILURE WAS IN ANTI-LOCK BRAKES CONTROL PART # 5C7Z-2C286-A. *JB

TL* - THE CONTACT HAS A BLOWN HEAD GASKE, AND WHITE SMOKE WAS COMING FROM EXHAUST SYSTEM. TEMPERATURE GAUGE WAS UP DUE TO MIXTURE OF ANTIFREEZE IN OIL. THE CONTACT NOTICED SMOKE COMING OUT WHILE DRIVING AT NORMAL SPEED AND WEATHER CONDITIONS. VAN HAS BEEN SERVICED ON SEVERAL OCCASIONS AND PROBLEM STILL EXIST.

SPARK PLUG POPPED OUT OF ENGINE. ONCE I CHECKED THE ENGINE I FOUND THAT THE SAME THING HAD OCCURRED ON THE DIRECT OPPOSITE CYLINDER BEFORE. *NM

I SHUT OFF MY TRUCK AND SEVERAL COMPONENTS STAY ON, THEN I TURNED THE KEY ON AND OFF AGAIN AND THEY WENT OFF A FEW DAYS LATER THE SAME THING BUT THE WIPERS DID NOT WORK SINCE I AM AN AUTO TECHNICIAN I LOOKED INTO IT AT A FORD DEALER AND FOUND THAT FORD HAS HAD THIS MANY TIMES AND IT HAS BEEN INVESTIGATED BY THE SAFETY BOARD AND I AM NOT SURE WHERE IT WENT FROM THERE ALL I KNOW IS THAT IF I LOSS MY WIPERS ON THE HIGHWAY IN RAIN IT WOULD NOT BE SAFE. I KNOW IN CANADA THEY MADE THEM CALL THEM BACK AND FIX THE LEAKS THAT CAUSED THE WIPER FAILURE/GEM MODULE FAILURE TO FIX IT AT FORD WOULD BE 600.00 DOLLARS WHICH REQUIRES REPLACING THE GEM MODULE AND IT IS RECOMMENDED TO CHANGE THE FUSE PANEL ALSO AND TO FIX THE LEAK THERE WAS A BULLETIN TO SILICONE THE SEAMS WHICH IS A TEMPORARY REPAIR. *JB

MY 2001 F-250 SUPER DUTY DIESEL HAS STEERING PROBLEMS. ITS HARD TO BELIEVE THAT THE NUMBER ONE SELLING TRUCK IN THE NATION FOR WHO KNOWS HOW MANY YEARS, WOULD SELL A TRUCK TO THE PUBLIC THAT HAS POWER STEERING PROBLEMS. WHEN I AM TRYING TO PARK I HAVE NO POWER STEERING AT ALL. I KNOW THAT IT IS DUE TO RECEIVING ALL THE POWER TO THE BRAKING SYSTEM, BUT WITH ALL THE TECHNOLOGY OUT THERE TODAY WHY WOULD FORD HAVE A PROBLEM TRYING TO FIGURE OUT HOW TO HAVE POWER BRAKING AND POWER STEERING AT THE SAME TIME. MY 77 HIGH BOY HAD BETTER STEERING WITH 35 INCH TIRES THAN MY 2001 HAS. *NM

DT*: THE CONTACT STATED THE TRANSMISSION BECAME STUCK IN 1ST GEAR AT TIMES AND WOULD NOT UPSHIFT UNLESS THE ACCELERATOR PEDAL WAS RELEASE. THIS OCCURRED UNDER NORMAL ROAD CONDITIONS. THE NATURE OF THE FAILURE WAS PERMANENT GRADUALLY WORSENED. THE SERVICE DEALER WAS NOT ABLE TO DETERMINE THE NATURE OF THE FAILURE.

DT*: THE CONTACT STATED THE VEHICLE LOST POWER WHILE MAKING A TURN. THE ENGINE STALLED AND THE POWER STEERING STOPPED FUNCTIONING. THERE WAS NO WARNING SIGNAL PRIOR TO THE INCIDENT. THE VEHICLE WAS TAKEN TO A SERVICE DEALER, WHO DETERMINED THAT THE CAM SENSOR HAD FAILED. THE MANUFACTURER WAS NOTIFIED. THE CONSUMER STATED THAT THIS IS A VERY COMMON ISSUE WITH THIS TYPE OF VEHICLE AND FEELS AS THOUGH THIS IS A MAJOR SAFETY ISSUE. UPDATED 07/17/07 *TR

DT*: THE CONTACT STATED WHILE DRIVING 60 MPH, THE REAR DRIVER SIDE TIRE SHREDDED WITHOUT WARNING. THE CONTACT SUSTAINED MINOR INJURIES. THE VEHICLE WAS TAKEN TO A SERVICE DEALER, WHO WAS UNABLE TO PROVIDE A RESOLUTION. THERE WAS A NHTSA RECALL # 00T005000 WHICH PERTAINS TO THE TIRE TREAD. THE VEHICLE WAS NOT INCLUDED IN THE RECALL DUE TO THE VIN. THE TIRE MANUFACTURER WAS FIRESTONE. TIRE LINE: STEEL BELTED TIRE. SIZE: P265/75R16.*AK

I TOO HAVE A 2001 F-250 WITH THE TRITON V-10 THAT HAD A PLUG BLOW FROM THE CYLINDER. IT DESTROYED THE CYLINDER THREADS AS WELL AS THE SOLENOID. FORD IS OBVIOUSLY AWARE OF THIS PROBLEM AS THEY HAVE AVAILABLE A REPAIR KIT. *NM

I WAS DRIVING ON THE HIGHWAY WHEN SUDDENLY LOST POWER TO MY TRUCK. FORTUNATELY I WAS NOT ON A LONG TRIP WITH MY WIFE AND KIDS HAULING A LOAD. I TRIED TO CONTACT A DEALER AND WAS TOLD THEY WERE UNABLE TO SEE ME AFTER SEVERAL WEEKS AND SOME CALLS I WAS ABLE TO LOCATE ONE TO LOOK AT MY TRUCK. AFTER I GAVE MY APPROVAL TO REPAIR THE ENGINE THE RESULT WAS $13.23 IN PARTS AND $779.12 IN LABOR. APPARENTLY A WIRE HARNESS THAT RUNS UNDER THE VALVE COVERS SIMPLY CAME UN PLUGGED. THE DEALER TOLD ME THIS ONLY HAPPENS TO MY TYPE OF VEHICLE AND A STAND OFF BRACKET NEEDED TO BE PUT IN PLACE. I ASKED WHY THIS WASN'T A RECALL ITEM AND THE LADY AT THE COUNTER SAID I SHOULD CALL THE MANUFACTURER. *NM