2000 FORD F-250 Complaints

WAS PULLING MY BOAT OUT OF THE WATER AND WHEN STOPPING HEARD A LOUD BANG. STOPPED TRUCK AND SAW FLUID LEAKING ON TO THE GROUND FROM JUST FORWARD OF THE DRIVERS SIDE REAR TIRE. FOUND FLUID TO BE BRAKE FLUID. BRAKE STEEL LINE THAT RUNS DOWN THE LEFT FRAME RAIL HAD BURST NEAR FUEL TANK. THIS AREA HARD TO SEE UNLESS USING A MIRROR AND LIGHT. THE BRAKE LINE WAS VERY CORRODED AND HAD RUSTED THRU IN THE AREA THAT IS HARDEST TO SEE. REPLACED THE STEEL BRAKE LINE TO REPAIR. I AM THE ORIGINAL OWNER OF THIS TRUCK. I HAVE PICTURES AND HAVE THE OLD BRAKE LINE. *TR

TL* THE CONTACT OWNS A 2000 FORD F-250 SD. THE CONTACT STATED THAT WHILE DRIVING APPROXIMATELY 45 MPH, THE BRAKES UNINTENTIONALLY LOCKED WITHOUT WARNING. THE VEHICLE WAS MANEUVERED TO THE SIDE OF THE ROAD, AND REMAINED PARKED OVERNIGHT. THE FOLLOWING DAY, THE CONTACT STARTED THE VEHICLE AND RESUMED DRIVING WITH THE BRAKES FUNCTIONING NORMALLY FOR 15 MILES BEFORE THE FAILURE RECURRED. ONE WEEK PRIOR TO THE FAILURE, ALL OF THE ROTORS AND BOTH REAR CALIPERS WERE REPLACED. IN ADDITION TO THE REPAIR, THE FRONT AND REAR BRAKES WERE REPLACED. THE VEHICLE HAD NOT BEEN DIAGNOSED OR REPAIRED FOR THE MOST RECENT FAILURE. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE AND THE CONTACT WAS INFORMED THAT THERE WERE NO RECALLS RELATED TO THE BRAKES. THE APPROXIMATE FAILURE MILEAGE WAS 178,000.

WIRING IN THE STEERING COLUMN HAS BEEN COMING APART AND PIECES FALLING OUT OF THE COLUMN. THE CRUISE CONTROL, AIRBAG AND HORN ARE ALL NOT WORKING AS A RESULT OF THIS FAILURE. IT IS A FLAT (RIBBON WIRE) WIRE THAT APPEARS TO RUN FROM THE STEERING WHEEL THROUGH THE CENTER OF THE COLUMN. *TR

NOISY FRONT RIGHT WHEEL GRINDING NOISE. UNSAFE TO DRIVE, THE BEARING HAD APPROX 3 INCHES OF PLAY AND GRINDING ON THE ROTOR. REPLACED FRONT HUB ASSEMBLY AND BEARING AND BRAKES. THE VEHICLE HAD THE IDENTICAL FAILURE JULY 2010 ON THE LEFT FRONT WHEEL. MECHANICAL FAILURE THAT COULD RESULT IN DEATH.

OUR UNATTENDED FORD F-250 PICKUP CAUGHT FIRE IN OUR CONSTRUCTION YARD. THE SUBSEQUENT FIRE COMPLETELY DESTROYED IT AND AN ADJACENT VEHICLE. THE VEHICLE HAD BEEN PARKED AND NOT MOVED FOR DAYS. I WAS THE LAST PERSON TO DRIVE IT AND I AM NOT AWARE OF ANY DEFECTS THE LAST TIME IT WAS DRIVEN. VIDEO SURVEILLANCE DID NOT CAPTURE THE FIRE OF THE FIRST VEHICLE, HOWEVER IT DOES PROVIDE A TIME LINE FOR THE EVENT AND SUBSEQUENT FIRE OF THE ADJACENT VEHICLE. *TR

MY YEAR 2000 FORD F-250 TRUCK BURST INTO FLAMES IN MY DRIVEWAY TODAY AN HOUR AND A HALF AFTER I PARKED IT. IT'S A TOTAL LOSS. *TR

TL* THE CONTACT OWNS A 2000 FORD F-250 SD. THE CONTACT WAS DRIVING 40 MPH WHEN THE SPARK PLUGS DISCONNECTED FROM THE ENGINE. THE VEHICLE WAS INSPECTED BY THE DEALER WHO DRILLED INTO THE ENGINE AND REPLACED THE SPARK PLUGS BUT THE FAILURE RECURRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE AND THERE WERE NO FURTHER REPAIRS. THE FAILURE MILEAGE WAS 103,000 AND THE CURRENT MILEAGE WAS 103,050. THE VIN WAS UNAVAILABLE.

TL* THE CONTACT OWNS A 2000 FORD F-250 SD. THE CONTACT STATED THAT HE HEARD A CLICKING NOISE AND THE LIGHTS ON THE INSTRUMENT PANEL FLICKERED ON AND OFF. ONCE HE TURNED THE HEATER CONTROL OFF, THE FLICKERING STOPPED BUT RECURRED WITHIN A FEW MINUTES. THE CONTACT PARKED THE VEHICLE AND WHEN HE RETURNED, THE VEHICLE WAS ATTEMPTING TO START INDEPENDENTLY. HE REMOVED THE POSITIVES AND NEGATIVES FROM THE SOLENOID TO CORRECT THE FAILURE. HE THEN REATTACHED AND THE FAILURE RECURRED. IN ADDITION, SMOKE WAS EMITTING FROM THE VEHICLE. THE VEHICLE WAS NOT INSPECTED OR REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE CURRENT MILEAGE WAS APPROXIMATELY 218,000 AND THE FAILURE MILEAGE WAS APPROXIMATELY 217,000.

THERE WERE NO PARTICULAR EVENTS LEADING UP TO THE FAILURE. WHEN STARTING THE VEHICLE ENGINE, THE ENGINE WILL NOT KEEP RUNNING ON ITS OWN. TO KEEP THE ENGINE RUNNING LIGHT PRESSURE MUST BE APPLIED TO THE ACCELERATOR TO MAINTAIN AN 800 TO 1000 RPM. THE VEHICLE CAN BE DRIVEN, HOWEVER, THE LEFT FOOT MUST BE USED FOR BRAKING SINCE THE RIGHT FOOT MUST BE USED TO KEEP CONTINUOUS PRESSURE ON THE ACCELERATOR TO PREVENT THE ENGINE FROM STALLING. THE ACCELERATOR ISSUE WILL SOMETIMES CORRECT ITSELF AFTER THE ENGINE HAS BEEN RUNNING FOR A PERIOD OF TIME AFTER STARTUP, HOWEVER, IN MOST CASES THIS PRESENTS A DANGEROUS SITUATION. WHEN THE ENGINE IDLE CORRECTS ITSELF, THE RPMS WILL TAKE A +1000 RPM JUMP FROM THE CURRENT RPM POSITION. FOR EXAMPLE, IF YOU ARE STOPPED AT A STOP LIGHT ONLY A FEW FEET FROM THE CAR IN FRONT OF YOU WITH LIGHT PRESSURE ON THE BRAKE, THE JUMP FROM 1000 RPM TO 2000 RPM MAY SEND THE VEHICLE LURCHING FORWARD REAR-ENDING THE VEHICLE IN FRONT OF YOU IF YOU DO NOT SLAM ON THE BRAKES QUICKLY! ANOTHER SITUATION THAT HAS ALSO CAUSED A "CLOSE CALL" IS WHEN DRIVING THE VEHICLE 5 MPH AT 1000 RPM IN A PARKING LOT. THE REASON THIS SITUATION IS EVEN MORE DANGEROUS IS DUE TO THE FACT THAT THE BRAKE IS TYPICALLY NOT BEING APPLIED AT ALL, SO WHEN THE +1000 RPM JUMP TO 2000 RPMS OCCURS IT CAN SEND YOUR VEHICLE LURCHING FORWARD INTO ANOTHER VEHICLE OR PEDESTRIAN THAT IS CROSSING IN FRONT OF THE VEHICLE. I ATTEMPTED TO FIX THE FAILURE BY REMOVING THE AIR BREATHER ASSEMBLY AND CLEANING THE INTAKE THROAT WITH CARBARATOR CLEANER, HOWEVER, THIS DID NOT RESOLVE THE FAILURE. *TR

I HAD A SPARK PLUG BLOW OUT OF THE CYLINDER HEAD, AS MANY OTHER PEOPLE HAVE. THIS IS A MANUFACTURING DEFECT, AND THEY KNOW IT, SINCE THEY CHANGED THE DESIGN. THERE SHOULD BE A RECALL FOR THIS, SINCE IT IS A SAFETY ISSUE, AND IF I CANNOT FIX IT, IT WILL COST ME $2400 FOR A NEW CYLINDER HEAD. *TR