1999 FORD F-250 SD Complaints

OWN A 1999 F-250 SUPERDUTY, CREWCAB,V-10. TOOK IT TO DEALERSHIP FOR 60,000 MILE CHECK-UP. I WAS TOLD THAT IT NEEDED A NEW (LEFT SIDE EXHAUST MANIFOLD). THEY STATED THAT A BOLT BROKE OFF AND IT HAD TO BE REPLACED. TOTAL COST WOULD BE $1500.00, THEY STATED THAT THE MANIFOLD MUST BE WARPED? WHAT WOULD CAUSE A MANIFOLD TOO WARP? *JB

DT*: THE CONTACT STATED WHILE STOPPED AT A STOP SIGN, THE VEHICLE STALLED SUDDENLY WITHOUT WARNING AND THE CHECK ENGINE LIGHT ILLUMINATED. THE VEHICLE WAS VERY DIFFICULT TO RESTART. THE VEHICLE WAS TOWED TO THE CONTACT'S RESIDENCE INITIALLY AND THEN TO A DEALERSHIP WHO DETERMINED THE CAM POSITION SENSOR WAS DEFECTIVE. PRIOR TO THE INCIDENT, THERE WAS ONE PROBLEM WITH THE VEHICLE STARTING. THE CONTACT HAD SEEN SEVERAL COMPLAINTS ON THE INTERNET CONCERNING THIS ISSUE ON THIS YEAR, MAKE AND MODEL OF VEHICLE.

TIRE TREAD SEPARATING AND IS CAUSING AN ADVERSE IMPACT ON THE STEERING OF THE VEHICLE. *NM

BULGE IN TIRE DUE TO TREAD SEPARATION. FIRESTONE STEELTEX RADIAL A/T BSW - LT265/75R16 LOAD RANGE E. THIS IS AN OEM TIRE INSTALLED ON A 1999 FORD F-250 SUPER DUTY PICKUP TRUCK. THE TIRE WILL HAVE TO BE REPLACED, BUT HAS NOT YET BEEN DONE. *JB

(1) CRUISE CONTROL INOPERATIVE ON 1999 F250 SUPER DUTY SINCE DATE OF PURCHASE ON 5/12/06. (2) NOTIFIED THAT BRAKE LIGHTS INOPERATIVE. (3) FOUND 20 AMP FUSE BLOWN IN FUSE SPACE #13 AND REPLACED IT IN FRONT OF AUTO PARTS STORE. STEPPED ON BRAKE PEDAL TO CHECK BRAKE LIGHTS. A HISSING SOUND FOLLOWED BY ENORMOUS AMOUNT OF SMOKE CAME FROM UNDER HOOD. CHECKED UNDER HOOD AND FOUND THE CRUISE CONTROL DEACTIVATION SWITCH WET WITH BRAKE FLUID AND BURNT SWITCH. FOUND OUT ABOUT RECALL INFO ONLINE AFTER THE FACT. *NM

THE CAM POSITION SENSOR ON FORD'S POWER STROKE DIESEL TRUCKS ARE KNOWN TO GO BAD. EVERYONE I KNOW THAT HAS ONE ... HAS HAD TO REPLACE IT. SOMETIMES MORE THAN ONCE. MINE HAPPENED TO GO OUT WHILE DRIVING DOWN THE ROAD AT 70 MILES PER HOUR. THIS IS NOT GOOD. IT CAN CAUSE SERIOUS ACCIDENTS. I'M JUST CONCERNED WITH THE SAFETY OF PEOPLE HERE. NOT ONLY THAT, BUT REPLACING THEM CAN GET EXPENSIVE. I BOUGHT A NEW SENSOR FROM INTERNATIONAL AND PAID ~$100 USD. I THINK SOMEONE NEEDS TO STEP UP TO THE PLATE AND FIX THE PROBLEM. *JB

VEHICLE SEEMED TO BE RUNNING FINE. PARKED IN MY DRIVEWAY AND 70 MINUTES LATER MY WIFE CAME HOME AND FOUND THE TRUCK ON FIRE. HEAVY FIRE WAS ENSUING FROM THE DRIVER SIDE WHEEL WELL AS WELL AS OUT THE FRONT DRIVER SIDE GRILL. *JB

AT HIGHWAY SPEED, 1999 FORD F250 4WD 7.3 DIESEL STALLED ON TWO OCCASIONS. I AM TOLD THAT THIS IS MOST LIKELY CAUSED BY A FAULTY CAMSHAFT POSITION SENSOR AND IS A VERY COMMON FAILURE WITH THIS ENGINE. *JB

DT: THE CONTACT STATED BOLTS THAT HOLD THE EXHAUST MANIFOLD FRACTURED. THE FRACTURED BOLTS WERE DISCOVER BY THE SERVICE DEALER WHILE PERFORMING OTHER MAINTENANCE WORK. THE DEALER ALERTED THE CONTACT THAT THIS IS A REOCCURRING PROBLEM WITH THE YEAR, MAKE AND MODEL OF THE VEHICLE. IN THE PAST ON THERE VEHICLES, STAINLESS STEEL BOLTS HAVE BEEN USED TO REMEDY THIS PROBLEM BUT THE PROBLEM REOCCURED. THE DEALER PLANS TO REINSTALL THE SAME TYPE OF BOLTS ORIGINALLY USED ON THE CONTACT'S VEHICLE. THE CONTACT PREDICTED THE PROBLEM WILL REOCCUR.

AN EJECTION OF SPARK PLUG HAS OCCURRED ON THIS VEHICLE ON THREE DIFFERENT OCCASIONS. I UNDERSTAND THERE HAVE BEEN OTHER COMPLAINTS REGARDING THIS PROBLEM. THE COST TO REPAIR THE ENGINE IS ASTRONOMICAL. PLEASE INVESTIGATE. *NM