1999 FORD F-250 SD Complaints

WHEN BRAKES WERE DEPRESSED THEY DIDN'T HOLD. THE BRAKE PADS, WHERE IT CLUES TO THE METAL, SEPARATED AND DAMAGED THE CALIPER AND SKID DISC. DEALERSHIP REPLACED PARTS, BUT PROBLEM RECURRED.*AK

THE EMERGENCY BRAKE CABLE WAS ROUTED INCORRECTLY, WHICH CAUSED IT TO RUB AGAINST THE LEFT REAR TIRE, AND BECOMING COMPLETELY EXPOSED. DEALER DIAGNOSED THE RETAINER BRACKET WAS NOT INSTALLED AND CORRECTED. DEALER SERVICE DEPT. THEN ROUTED CABLE UNDER THE LEFT REAR LEAF SPRING WHICH WAS RUBBING THE CABLE AGAIN, AND CAUSED EXPOSURE.*AK *TS. THE FUEL GAUGE SENDER WAS REPLACED. *JB

WHILE BACKING A JET SKI TRAILER DOWN A BOAT RAMP THE BRAKE PEDAL CAME COMPLETELY DISCONNECTED FROM THE OTHER COMPONENTS AND LAID AGAINST THE FIREWALL. THIS MADE THE BRAKE SYSTEM UNUSABLE. THE TRUCK WAS FINALLY STOPPED WITH THE PARKING BAKE PLUS THE TRAILER JACK KNIFING TO THE LEFT AND INTO THE LEFT REAR QUARTER PANEL OF THE PICKUP BED. THE YELLOW RETAINING PIN THAT HOLDS THE BRAKE PEDAL POST WITHIN THE ? STABALIZING MOUNT AND THE ELECTRICAL SENSOR MODULE WAS FOUND ON THE FLOORBOARDS. ONCE RECONNECTED THE BRAKE SYSTEM PERFORMED NORMALLY.*AK

BRAKE ROTORS WARPED SEVERAL TIMES, TURNED, AND REPLACED ONCE. THIS LAST TIME BRAKE PADS WERE WORN OFF AND DOWN TO METAL. EXPERIENCE THESE ISSUES EACH TIME I TAKE A LONG TRIP OF 1000 MILES ON THE INTERSTATE. DRIVING AT HIGH SPEED FOR 3-4 HOURS BEFORE STOPPING AND LITTLE OR NO BRAKING DURING THIS PERIOD. THIS LAST TIME I HAD TO PAY FOR THE TURNING OF THE ROTORS AND BRAKE KIT. NEW KIT HAS SPRINGS TO HELP A PROBLEM PER TECH? THIS IS A DEFECTIVE SYSTEM!*AK

I HAVE A 1999 FORD F250 SUPERDUTY 6 SPEED MANUAL. I HAVE 61000 MILES ON IT. TODAY THE CLUTCH PEDAL STUCK TO THE FLOOR WHEN I WAS AT A STOP SIGN. THE CLUTCH SLAVE/MASTER CYLINDER WENT OUT. ...AGAIN. LUCKILY I KNEW HOW TO DRIVE A VEHICLE WITH A BAD CLUTCH. I HAD TO SHIFT A COUPLE OF TIMES WITHOUT THE CLUTCH PEDAL JUST TO GET IT HOME. AT LEAST I WAS JUST DOWN THE STREET FROM MY HOUSE. *AK WHEN THE CLUTCH SLAVE/MASTER CYLINDER GOES OUT THE CLUTCH PEDDLE LOSES PRESSURE AND LETS THE CLUTCH ENGAGE AND THE TRUCK STARTS ROLLING. THIS EXACT THING HAS GONE OUT ON MY TRUCK TWICE IN THE LAST 7 MONTHS. I JUST WANTED TO REPORT THIS SINCE IT COULD BE VERY DANGEROUS IF ONE OF THESE WENT OUT WHEN SOMEONE WAS STANDING IN FRONT OR BEHIND THE VEHICE AND THE VEHICLE RAN THEM OVER OR EVEN IF IT WENT OUT AT AN INTERSECTION AND THE TRUCK ROLLS INTO THE INTERSECTION BEFORE SOMEONE CAN STOP IT. SINCE ITS A DIESEL (LOTS OF TORQUE), YOU CAN'T STOP IT VERY EASILY IF IT STARTS ROLLING IN LOW, 1ST GEAR OR REVERSE. I AM A MEMBER OF A FORD DIESEL FORUM (WWW.THEDIESELSTOP.COM AND THERE ARE MANY MANY CASES OF THE CLUTCH SLAVE/MASTER CYLINDER GOING BAD. YOU CAN GO TO THE FORUMS AND LOOK IN THE 7.3L POWER STROKE ENGINE AND DRIVETRAIN SECTION. (JUST DO A SEARCH FOR THE WORD "SLAVE")

THE WAS A PROBLEM WITH THE BRAKE ROTORS. WHEN THE VEHICLE WAS DRIVEN, THE BRAKES BECAME WARM AND THE FRONT END OF THE TRUCK VIBRATED WHEN APPLIED. THE CONSUMER WAS TOLD BY THE MECHANIC, THE BRAKES WERE WARPED AND IT WAS NORMAL FOR MOST OF THESE KINDS OF TRUCKS. *NLM THE VIBRATION WAS CAUSED BY THE FRONT SPINDLE AND ROTORS. *TS *JB

CONSUMER STATES THAT SPARK PLUGS BLEWOUT OF THE CYLINDER, STRIPPING THE THREADS OUT OF THE CYLINDER HEADS, RESULTING IN ENGINE FAILURE. THIS HAS OCCURRED TWICE SINCE VEHICLE PURCHASED. 1ST OCCURRENCE AT 3900 MILES, 2ND OCCURRENCE AT 56000 MILES. *AK

SEVERE BRAKE PEDAL PULSATION SINCE TRUCK WAS NEW. HAVE HAD FOUR MAJOR REPAIRS TO THE SYSTEM. PADS, ROTORS, ETC. STILL EXPERIENCE THE PROBLEMS. HEAT AFFECTED POOR QUALITY OF METAL IN THE CALIPERS.*AK

CONSUMER CALLED COMPLAINING ABOUT THE SEAT BELTS BEING TOO LOOSE. MANUFACTURER WAS CONTACTED,M AND HAD FIXED THEM, BUT THEY STILL GO BAD. *AK

I WAS DRIVING MY 1999 FORD F250 DIESEL TRUCK AT 70 MPH (SPEED LIMIT) WHEN I TOUCHED THE BRAKE TO RELEASE THE CRUISE TO STOP AT THE TRAFFIC LIGHT UPON ENTERING PLAINS, TX. THE CRUISE DID NOT RELEASE AND I BRAKED HARDER......THE ENGINE KEPT AT OVER 2,000 RPM AND DID NOT SLOW DOWN.....I BRAKED HARDER TO STOP AT THE LIGHT AND THE ENGINE NEVER SLOWED DOWN......I PUSHED THE OFF BUTTON ON THE CRUISE CONTROL AND PUMPED THE BRAKE AND IT NEVER SLOWED......I HAD TO BRAKE PRETTY HARD TO COME TO A STOP AT THE HIGHWAY INTERSECTION.....THE ENGINE WAS STILL RACING AT 2,000 RPM......I JERKED ACROSS THE INTERSECTION AND STOPPED THE TRUCK ON THE SIDE OF THE HIGHWAY BY TURNING OFF THE ENGINE.....WHEN I RESTARTED THE TRUCK, IT WOULD NOT GO FORWARD. I HAD THE CAR HAULED TO THE NEAREST FORD DEALERSHIP, BROWNFIELD, TX. THEY SAID IT SOUNDED LIKE AN ELECTRICAL PROBLEM......THEN THEY TOLD ME IT WAS THE TRANSMISSION......THE TRUCK ONLY HAD 28,000 MILES ON IT......THEY REPLACED THE TRANSMISSION FOR $2,800. AFTER TELLING MY FRIEND, A MECHANIC, THE PROBLEM HE SENT ME THIS MESSAGE: GO TO: WWW.NHTSA.DOT.GOV/HOTLINE/ AND FILE A REPORT ON THE INCIDENT WITH THE TRUCK. AFTER THINKING ABOUT WHAT YOU SAID HAPPENED, THERE MAY BE A PROBLEM WITH THE THROTTLE COMPONENTS. IT COULD HAPPEN AGAIN. IF IT DOES , SHUT OFF THE IGNITION. TRYING TO HOLD THAT ENGINE WITH THE BRAKES (NOT SAYING IT DID) COULD BLOW THE TORQUE CONVERTER ON THE TRANSMISSION. THE REASON FOR FILING THE REPORT IS THEY WILL INVESTIGATE FOR SAFETY AND THEY WILL ALSO LET YOU KNOW IF A SIMILAR REPORT HAS BEEN FILED. TOM. *NLM