2016 FORD FOCUS Complaints

The contact owns a 2016 Ford Focus. The contact stated that while driving approximately 15 MPH, the transmission suddenly malfunctioned and the vehicle would not accelerate forward. During the failure the "Transmission" and "Check Engine" warning lights were illuminated. The vehicle was towed to the local dealer who diagnosed that transmission module and transmission clutch were faulty and needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure. The failure mileage was 103,000.

The coolant/antifreeze tank melts upon the returning coolant/antifreeze where the return line meets the tank due to the high temperature of the coolant/antifreeze and causes the coolant/antifreeze to spill onto the engine. This led to a high engine temperature increase warning and immediately made the vehicle to stall to prevent overheating of the engine. I already replaced the old tank with a new one. Also, the rear passenger seat belt began to fray and it makes it almost impossible to buckle up.

UNKNOWN. I believe this vehicle's engine is also impacted by the recall campaign number 18V735000, even though the engine is a 2.0L L4. The same issues that are mentioned in the recall campaign occurred with this vehicle around the 60k milage and 120k milage mark. These issues seems to happen every 60k miles. I did report this same issue with this system with this vehicle when this happened when the milage hit around 60k. The engine check light did show up each time this happened and the vehicle would stall immediately, even while driving at interstate speeds of around 70mph.

The contact owns a 2016 Ford Focus. The contact stated the vehicle failed to accelerate while depressing the accelerator pedal. The check engine warning light was illuminated. The vehicle was previously repaired under an unknown recall for the dual clutch in the transmission. The vehicle was taken to the dealer where a diagnostic test was performed. The mechanic believed that the failure was related to the Transmission Control Module; however, the mechanic was unable to verify the cause of the failure. The manufacturer was notified of the failure. The vehicle was not repaired. The approximate failure mileage was 128,056.

The contact owns a 2016 Ford Focus. The contact stated while driving at an undisclosed speed uphill, the vehicle made an abnormal sound and stalled. The oil pressure and check engine warning lights were illuminated. The failure nearly caused a collision. The vehicle was coasted to the side of the road and then was towed to the residence. The contact's husband, an independent mechanic, diagnosed that the engine oil pump needed to be replaced. The vehicle was not repaired. The contact later received notification of NHTSA Campaign Number: 23V905000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The manufacturer was not made aware of the failure. The failure mileage was approximately 108,000. VIN tool confirms parts not available.

Customer Satisfaction Program 14M02. DPS6 Automatic Transmission. Ford customer service recommended I contact you as my vehicle barely falls outside of the rebiuld date requirement of this program but is experiencing the same problems. They said you could add this VIN number to the program to get repaired under this program.

My car is having transmission issues that have been recalled many times before. The car does not move forward when I apply the gas, it violently shakes on acceleration, the engine doesn't always turn over, and will rev but not move forward at a green light. This is incredibly dangerous, especially when trying to enter the flow of traffic. It's been a known issue for years, I don't know why they canceled the recall.

PURGE CANISTER VALVE SYSTEM FAILURE. CAR SPUTTERS AND WONT START WHEN GAS IS PUT INTO THE CAR. CAR JERKS. CHECK ENGINE LIGHT STAYS ON.

The contact’s son owns a 2016 Ford Focus. The contact stated that while refueling the vehicle at the gas station, the contact had to wait for approximately 2-30 minutes before the vehicle would start-up. The contact stated that while the vehicle was parked, the RPM revved and fluctuated from high to low. The contact also stated that while driving from a stop light, the vehicle stalled. The check engine warning light was illuminated. The vehicle was taken to the dealer where it was diagnosed with a failed canister purge valve. The vehicle was not repaired due the cost. The manufacturer was notified of the failure and stated a previous recall was cleared due to the vehicle passing the canister purge valve test and the power train control module was updated. The failure mileage was approximately 160,000.

The contact owns a 2016 Ford Focus. The contact received notification NHTSA Campaign Number: 23V905000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The contact stated while his wife was driving 50-55 MPH, the vehicle started shaking and lost motive power. The contact’s wife pulled to the side of the road. The contact’s wife was unsure if any warning lights were illuminated. The vehicle was towed to a local mechanic where the vehicle was diagnosed, and it was determined that the engine had seized due to the oil pump drive belt failure. The vehicle was repaired, and the engine was replaced. The manufacturer was not notified of the failure. The approximate failure mileage was 84,320.