2014 FORD FUSION Complaints

The contact owns a 2014 Ford Fusion. The contact stated that while driving at various speeds the vehicle would not properly accelerate, the engine experienced misfiring and the check engine light remained illuminated. The vehicle was taken to the local dealer who diagnosed that coolant was present inside the engine cylinders and the engine needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure but no assistance was offered. The failure mileage was 80,000.

When driving the car will stall out and die in the driving state. This occurs without warning from any sensor light error warnings. After acceleration to 35 it will sputter as if the fuel is not flowing, yet then it will correct but stall and completely die during operation while driving. Have had both the upper and lower full pumps installed within the last calendar yet still currently having the problem or issue. Experiencing the exact same Eco boost concerns as other Ford models have been recalled for as of recent

We are the owners of a 2014 Ford Fusion model vehicle. We took this vehicle to a local Ford service dealer to have the tires rotated. Dealer service manager told us they could not do the tire rotate because the chrome plating on the wheel lug nuts had swollen and their wrench would not fit the lug nuts. The offered non OEM replacement lugs nuts for our cost of $134.95 plus tax. I believe this is a safety issue as we could be stranded along any roadway should we have a flat tire needing us to use our spare, and unable to remove the flat tire. Our vehicle has a total of about 60,813 miles shown on the odometer. Apparently this swollen lug nut issue is a known problem with this vehicle? Can you help us resolve this?

The contact owns a 2014 Ford Fusion. The contact stated while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended. The contact stated that the vehicle was hesitating. Additionally, the contact stated that the vehicle was not driving properly. The contact stated that later that day, while the vehicle was parked, the contact saw fluid on the ground underneath the front driver’s side of the vehicle. The vehicle was taken to the dealer where it was diagnosed with transmission fluid leak and half shaft seal failure. The contact was informed that either the half-shaft seal or the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure but provided no assistance. The contact was informed of an unknown recall repair; however, the VIN was not associated with the recall. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 113,098.

The seat belts are fraying at the stitching and the female end sometimes doesn’t want to let you put seat belts in or after there in they pop out for no reason

2014 Ford Fusion SE safety concerns for electric rack and pinion assembly failure

When accelerating from a stopped position, the throttle is staying stuck wide open. Without my foot on the accelerator, the engine still accelerates wide open. Stepping on the brake, doesn't do anything or make it stop. It has now happened 3 times in the last 2 weeks. I was not taking off at a fast speed. I was accelerating at a normal rate.

I've had my Ford Fusion SE ecoboost 1.5, 2014 in for service on 2 separate occasions a day apart for the same reoccurring problems. The first service there was the actions done related to recalls which are consistent with 20S15 A-C and recall 23E03 B. The reasons for my Ford Fusion 1.5 to have been brought to the Premier Ford, Waveland, Ms was as follows: The temperature overheat lamp light was jared, there was 3 leaks from the overheat, there was a Shutter and sounds that came from the engine, (LIMP*)and there was no fuel power through acceleration. There had been moisture located on exhaust before brakedown without having been driven for approximately 10hrs before brakedown. 2ed service was as follows: temperature overheat lamp light jared, no power through fuel to accelerate, and issues starting. LIMP* I had not on this brakedown paid attention to if my Fusion needed water, the engines performance in regards to shakes or sounds nor did I look to notice nor did I look for leaks. I called directly to Premier Ford, Waveland and had my Ford towed in. The service was as follows: 1) 3U2Z*14S411*HYB WPT988 WIRE ASY 2) DS7Z*8501*E PW556 PUMPASP-WATER 3) BE8Z*8507*A GASKET-WATER PUMP 4)VC*13*G 3801132 ANTI-FREEZE 5) 6 BM5Z*6K2543*S437 SCREW 6) BM5Z*6K254*A TENSIONER - TIMING BELT With the parts 261.44 Labor 1748.99 misc charges 50.00 for a total of after taxes 2204.66 I picked up my Ford Fusion on October 4, 2024 and on October 9, 2024 I went beck to the Premier Ford and spoke with the service department because I had to stop and let my Fusion cool every 20 to 30 minutes, I stated that there was some loss of water and it was overheating, the power train light warning notify me of an issue, and that my Fusion would not go over 80miles per hr. The service department associate seemed frustrated with me and argued the fact that it had ran hot and said that the reason for the speed issue was that the lamp was Identifying the keylock complete on pdf

The contact owns a 2014 Ford Fusion. The contact received notification of NHTSA Campaign Number: 14V736000 (Electrical System); however, the contact was informed by the dealer that during the reprograming of the instrument cluster, the instrument panel system had failed. The contact was informed that to repair the instrument cluster the dealer needed to perform a diagnostic test. The vehicle was not repaired. The manufacturer was made aware of the issue. The failure mileage was approximately 89,000. Parts distribution disconnect.

The contact owns a 2014 Ford Fusion Hybrid. The contact stated while driving 20 MPH, there was an abnormal sound coming from the front of the vehicle. The vehicle was driven to the dealer to be diagnosed. The contact was informed that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and a case was opened. The failure mileage was approximately 76,000.