2020 FORD FUSION Complaints

Although there is an existing recall in place by Ford Motor Co, a solution is not expected for another year. In the mean time, I am worried about a vehicle fire or vehicle going dead everyday. In addition, by not using the battery charger, my mileage has dropped from 54 mpg to 32 mpg. This past summer, I had three instances where my check engine light went on and the car would not start.

The flex plate is bad and ford won’t fix it. It needs recalled before it kills someone. Flex plate is the plate that puts power from engine to transmission

While driven collision sensor sudenly activated and locked my steeringweel,now vehicle is inoperative due to this issue, dealer is not repairing it while under warranty or not even making a estimate diagnosis.

On hot days the Forward Collision will show as unavailable, but there is no notification saying when it will be available again. This is dangerous in that a safety feature on the vehicle is unavailable when it is hot outside and has been sitting in the sun. Outer door panel skins are becoming unattached from the door frame, which could cause an issue if the skin fails elsewhere that it would be totally unattached to the door frame and fall off when driving. The rear package tray trim (carpeted trim piece behind the rear seats covering the speakers) disintegrates when it is touched due to it being exposed to the sun. Discovered when attempting to clean inside of my rear window. This has caused black particulate to be scattered throughout the vehicles interior. They are small enough that you could be breathing them in as the debris has been found all over the dashboard, seats, infotainment console, and trim all around the car. This is a health hazard due to breathing in fabric/carpet particulate that can irritate the lungs. Link to forum of other people having the same issue: https://www.fordfusionforum.com/index.php?app=forums&module=forums&controller=topic&id=20981#comments

The contact owns a 2020 Ford Fusion. The contact received notification of NHTSA Campaign Number: 23V440000 (Electrical System) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2020 Ford Fusion. The contact received notification of NHTSA Campaign Number: 23V440000 (Electrical System) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2020 Ford Fusion. The contact stated while driving at an undisclosed speed, the contact heard an abnormal knocking sound coming from the engine compartment. The vehicle was taken to the dealer and diagnosed with a failed flex plate and torque converter. The contact was informed that the flex plate and the torque converter needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure but provided no assistance. The failure mileage was approximately 63,000.

Failure of the Flywheel. It’s broken in pieces according to the dealership at greenway Ford. Did some searching on line and other people have report the same issues. The problem is they installed crappy plates that crack between 60k-90k miles. As others have reported the Luckily for them It was at an intersection and could pull over to the side of the road but imagine if this happens to you while on the freeway!

Car has the same 6f35 transmission issues as previous years and nothing is being done about it my car has 63k on it with a dead transmission because of the flexplate issue from previous years

The contact owns a 2020 Ford Fusion. The contact stated while driving approximately 55 MPH, the contact became aware that the vehicle was losing motive power. The contact stated that the RPM was fluctuating. The contact stated that the check engine warning light was illuminated. The contact stated that the vehicle stalled but was able to be restarted. The contact stated that the failure had occurred three other times. The contact had taken the vehicle to a local dealer, where it was diagnosed and determined that the tube assembly fuel vapor separator (9D289) needed to be replaced. The vehicle had not been repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 102,495.