2020 FORD FUSION Complaints

RANDOMLY 'SERVICE ADVANCE TRAC', 'PRE-COLLISION ASSIST NOT AVAILABLE', LANE ASSIST NOT AVAILABLE', POWER ASSIST STEERING NOT AVAILABLE', HILL ASSIST NOT AVAILABLE', WARNING LIGHTS APPEAR. WHEN THEY DO I COMPLETELY LOSE POWER STEERING. WHICH IS EXTREMELY DANGEROUS WHILE DRIVING. MOST THE TIME I CAN TURN OFF AND RESTART THE CAR AND IT GOES AWAY. HOWEVER, NOW IT HAS BECOME MORE FREQUENT AND HAS STARTED LOSING COMPLETE POWER OF THE CAR TURNING OFF WHILE DRIVING. I ALMOST DIED ON THE INTERSTATE. FORD DEALERSHIPS ONLY RECOMMENDATION WAS A NEW CIRCUIT BOARD THAT WAS LIKE $5K, MORE THAN THE CAR IS WORTH. THEY SAID IT WAS SOMETHING COMMON WITH THE FORD FUSIONS, THATS WHY THEY WERE QUIT BEING MADE. I RESEARCHED AND IT IS A COMMON ISSUE, BUT NO RECALLS HAVE BEEN MADE???!!???

Vehicle Make/Model/Year: Ford Fusion, 20XX (replace with your year) Component Affected: Suspension – lower control arm bushing or mount Summary of the problem: I am reporting a recurring and well-known issue with the lower control arm bushings on Ford Fusion models from 2013 and newer. In my case, the bushing wore prematurely, causing a clunking or cranking noise when turning, especially at low speeds. The bushing or bolt appears to shift even when torqued properly. This problem has been acknowledged by many other owners as well. Safety risk: This affects the vehicle’s handling and stability. It can cause loose steering, misalignment, premature tire wear, and could result in suspension failure while driving. This poses a real safety concern, especially during cornering or evasive maneuvers. Repair history: This issue is so common that owners often have to replace the bushings or the full control arm multiple times. Even after replacement, the problem can come back, suggesting a design flaw. Community evidence: There are many online complaints and forum threads about the same issue in Ford Fusions from 2013–2020. This appears to be a widespread defect that has not been formally acknowledged by the manufacturer. Request for action: I’m asking NHTSA to investigate this recurring suspension issue and determine if a safety recall is warranted. This is a design defect that affects vehicle safety and should be addressed by Ford.

Tire Pressure Monitor System Warning Action Now Issue Since 09-22-2024 The tire pressure monitoring system has detected one or more tires are significantly under-inflated. Suggested Actions: Check the tire pressure to ensure the tires are properly inflated. WARNING: The tire pressure monitoring system is NOT a substitute for manually checking tire pressure. The tire pressure should be checked periodically (at least monthly) using a tire gauge. See Inflating Your Tires in the Wheels and Tires chapter of your Owner's Guide. Failure to properly maintain your tire pressure could increase the risk of tire failure, loss of control, vehicle rollover and personal injury.

since day number one this vehicle has had an issue of maintaining a charge even when you drive it regularly , if you don't start it the next day it needs a jump , agew days after purchase a new battery was installed and the problem persisted , this vehicle has the same issues as the other 2020 Ford Fusion models that have been recalled?? But unfortunately under the VIN there has been no recall when this vehicle suffers from the same issues the ones that have been recalled suffer from Just add it like the others please . The incident has happened every day since 2020 If you miss a day starting it the next day it needs a jump even in warm weather , and it's been driven .,Just doesn't hold a charge I assume , needs a jump There's a record on the Ford app of the numerous jumps for rhe vehicle

The accelerator pedal broke off while merging into traffic resulting in the immediate loss of speed control.

The flexplate in my 2020 Ford Fusion SE (1.5L EcoBoost engine) failed at just over 53,000 miles. The car began making loud knocking and rattling noises while driving, and it vibrated heavily at idle and during acceleration. This posed a serious safety concern, as we feared the car could stall or break down while on the road with our toddler in the backseat. We took it to an independent, certified repair shop where they diagnosed a broken transmission flexplate, which required immediate replacement. The repair cost nearly $3,000, and the shop confirmed it was not caused by driver error or normal wear-and-tear. The failure was premature and mechanical in nature. The mechanic informed us that this specific engine and flexplate design have been recalled before in other Ford models using the same 1.5L EcoBoost engine and parts. They suggested we contact Ford, as this appeared to be a known defect that should be covered under goodwill or extended warranty. We followed their advice and reached out to Ford directly, but Ford refused to offer any assistance — even though they are aware of these ongoing flexplate failures across similar vehicles. After researching, I discovered Ford has had multiple flexplate and powertrain-related recalls in other 1.5L and 1.6L EcoBoost engines in previous model years. I also found many online complaints from other Ford owners experiencing the same flexplate failures, often at similar mileage. Yet, this issue has not been acknowledged or recalled for the 2020 Ford Fusion SE. This is clearly a design or manufacturing flaw that should be investigated by the NHTSA. Flexplate failure puts lives at risk and results in major repair bills for consumers. Please investigate this ongoing issue before someone is seriously hurt.

At approximately 99,900 miles, my 2020 Ford Fusion began experiencing serious transmission issues, including rough shifting, hesitation, jerking, and difficulty accelerating, especially at low speeds or while merging onto highways. These symptoms created an unsafe driving situation, particularly in traffic and intersections. I took the vehicle to multiple repair shops to have the issue diagnosed. This process caused my mileage to go slightly over the 100,000-mile recall coverage limit for transmission repair assistance, but I have full documentation showing that the transmission problem clearly began while the vehicle was still under the limit. I later discovered that Ford had issued a recall or Customer Satisfaction Program (CSP) related to known transmission issues on this model. The CSP is 22N12, however, I never received any notice from Ford by mail, phone, or email about this recall or warranty extension. I was unaware it existed until after my car began to fail. Despite being under the recall threshold when the issue began, and having proof, Ford has so far refused to fully cover the cost of the repair, only offering partial assistance due to the slight overage in mileage. This is a serious safety defect. My vehicle hesitates or fails to shift properly at critical times, putting myself and others at risk of collision. I was not informed of the recall, and now I'm being financially penalized for Ford’s delay and lack of notification. I cannot afford this out-of-pocket expense, and I believe it is unfair and unreasonable to place this burden on consumers, especially when safety is involved. I respectfully request that NHTSA review this matter and urge Ford to take full financial responsibility for the recall repair. This defect is not due to misuse or wear-and-tear, but is acknowledged by Ford as a manufacturer issue I have an open case with Ford Corporate in which they have failed to get back to me about the issue. Case number ([XXX]) INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (

The contact owns a 2020 Ford Fusion. The contact stated that while making a turn in either left or right direction, the Traction Control warning light had displayed, and the vehicle had reduced speed independently. During failure, the contact lost control of the vehicle and crashed into a mailbox. During the crash, no injuries were reported. No police report was filed and the vehicle was driven home. The cause of the failure was not determined. The manufacturer was notified of the failure, but no assistance was offered. The failure mileage was 81,000.

The contact owns a 2020 Ford Fusion. The contact stated that the vehicle was started, there was a large amount of white smoke coming from the exhaust pipe, with the engine sputtering. The vehicle as taken to an independent mechanic and was diagnosed with engine block failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and a complaint was filed. The failure mileage was approximately 71,000.

The contact owns a 2020 Ford Fusion. The contact stated that while driving at various speeds or while the vehicle was idling, there was an abnormal clunking sound coming from the vehicle. There were no warning lights illuminated. The vehicle was taken to the local dealer where it was diagnosed and determined that the flex plate had fractured. The vehicle was repaired; however, the failure recurred. The manufacturer was not contacted. The failure mileage was approximately 25,000.