2024 FORD RANGER Complaints

While driving, randomly and intermittently the vehicles drive mode will change on its own, usually requiring the driver to slow down to allow for a 4X4 shift, as called out by messages on the dash and an audible warning. This has happened multiple times and ford cannot replicate this issue. I was going to just replace the drive mode selection knob but as it turns out it's on national backorder.

The truck shifted its drive mode from normal driving into Baja mode by itself, and also shifted the transmission from 2H to 4H, potentially damaging the transmission and causing a safety issue on the highway.

one brake rotor has warping issues from faulty made parts,truck only has 11,000 miles and should not have an issue with brake rotors.Espically just one

Vehicle experienced unintended transmission gear change without driver input from the gear selector. While driving, the transmission shifted unexpectedly into 4H even though the selector was not touched. This created a safety hazard due to sudden change in vehicle behavior, including: loss of acceleration, lurching and unexpected movement. Issue occurred at approximately 30 mph. Concern is potential electronic transmission control or shift-by-wire malfunction causing unintended gear engagement.

When using the rear camera while towing a trailer, the image is partially blocked by a persistent message stating “full view not available”. This creates a safety issue as it obscures the driver’s view of the trailer and/or the trailer load. It is critical to be able to monitor the trailer and the load during towing to ensure a hazardous condition is not developing. I believe the rear view camera is working as designed, that is I do not believe there is a defect or failure in the hardware. However the design of the message is the problem. If the driver needs to know that “full view not available” then the message should be moved to a different part of the screen to not obscure the view of the trailer.

When accelerating, occasionally there is a hesitation. This becomes dangerous when accelerating from a side street onto a 55mph road when there’s an occasional break in traffic that I need to jump into. There’s been times where I got concerned when it hesitated and there was oncoming traffic. The other day I was going under 10mph around a curve and it hesitated so much, I looked at my gas gauge, thinking I was running out of gas (but I had a half tank). I’ve seen complaints online about this problem. I’ve had it to two different dealers and they found nothing wrong. I’ve had this problem since I purchased it new and I now have 12K miles. Thank you! [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The incomplete recall 26V238 is a concern. They say in the letter from Ford that it could be a fire issue. It seems the harness in the A pillar gets pinched and could short out causing the overhead lighting or mirror lighting to either cause a smoke issue or fire. BUT THE ANSWER IS NOT GOING TO BE AVAILABLE UNTIL LATE JULY MAYBE!! Why send a letter and state you have no answer yet or will have for a couple of months!!! Am I supposed to be happy that I will know why the fire breaks out? Some 1400 potential failures out of 140,000 is the prediction per a conversation with your [XXX] on the chat line. This is to me a lame response to an issue with a potential for a real safety issue and should have more response than "WE ARE WORKING ON THE ANSWER AND MAYBE END OF JULY" INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The vehicle has had hard down shift at slow speeds. Sometimes so hard that i thought I got rearended when stopping. Sometimes you can feel it but not horrible, other times it's bad! I've been trying 6 months to get Coggin Ford to look at it and they keep putting me off.

The brake pedal is extremely soft and routinely travels to the floor during normal driving conditons. It also catches at various levels. It is impossible to tap the brakes to slow the vehicle down when rounding a corner which has led to several scary incidents and near misses. The truck is currently at Crossroads Ford in Indian Trail NC for 3 weeks. It has been there once before and 3 times at Town and Country Ford in Charlotte. Both dealers said this is the way the brakes are supposed to work. I was also told by a service manager that this is due to the electronic braking system and they are reluctant to spend time on troubleshooting because Ford cut their renumeration. A service Field Engineer stated that the brakes were in spec and traveled 2 3/4" toward the floor. This is a subjective observation as every person uses different foot pressure. The gas pedal is at 3" off the floor and the brakes are 5". The brake pedal passes the gas pedal and many times, my foot hits both pedals. My inspection with a ruler shows the brake pedal going 1 1/2" past the gas pedal. There were no warnings the first time this happened. I have taken the vehicle to an independent mechanic who bled air out of both rear brake lines which helped. This repair lasted 3 months and now the issue is back. I've been told by independent mechanics that the problem is in the ABS module (which pulls the pedal to the floor when activated).

My 2024 Ford Ranger XLT 2W has been suddenly losing power or stumbling upon initial acceleration. This has been occurring intermittently. My truck now has approximately 20,000 miles. The problem has become increasingly frequent. It seems to occur most often when accelerating from a complete stop. The loss of power can last for several seconds, then normal power is regained. Several times, the truck has lost power while making a left turn. It simply will not accelerate, and I find that I am stuck, unable to complete my turn and clear the oncoming traffic. I have taken my truck to a local dealer who attempted to diagnose the problem and they didn’t offer a solution since they were unable to reproduce the problem during their road test. It has happened many times since then and I am scheduled to return the vehicle to the same dealership to attempt to diagnose and fix the problem again soon. The problem seems to occur, regardless of which drive mode the truck is in and also occurs with Electronic Stability Control both enabled and disabled. There are no warning lights or check engine codes shown.