2020 FORD RANGER Complaints

Wiring in components failed resulting in non functioning cross traffic alerts and blind spot detection. Problem found by independent mechanic, ford warranty does not cover.

The contact owns a 2020 Ford Ranger. The contact stated that while the vehicle was in reverse(R), the vehicle jerked before the transmission responded as needed. The contact stated that the vehicle returned to normal functionality afterwards. No warning lights were illuminated. The vehicle was taken to the dealer where it was diagnosed that the gear shifter assembly needed to be replaced. The vehicle was not repaired. The contact stated that on a separate occasion, while driving 50 MPH, there was an abnormal humming sound coming from the vehicle before the transmission unexpectedly downshifted. The contact stated that unknown warning lights were intermittently illuminated. The vehicle was taken to a dealer and was diagnosed with an internal leak in the transmission which caused the failure. The contact was informed that the transmission needed to be replaced. The vehicle was not repaired after the latest failure. The manufacturer was contacted and opened a case. The contact related the failure to Ford Campaign Number: 242046. The failure mileage was approximately 77,000.

Rear brake lights did not work, but high mount brake light functioned normally. I found a safety recall for the 2019 Ford Ranger for the same condition (19S43). This safety recall identifies connector C442 as the root cause for the incident. Based on this information, I located the connected. I disconnected the connector, did visual inspection. Visual inspection did not find any bent pins, so I reconnected connector. After inspection and reconnection of connector C442 the brake light now work. A little background on me. I’m a retire Service Engineer from Nissan and I have extensive background in vehicle service issues, recalls and campaigns. Based on my experience, I believe that the incident I confirmed on my vehicle may indicate that the Ford Ranger may continue to have brake light inoperative condition beyond the current Safety Recall window of vehicle. I have already contacted Ford to advise them of this condition. I offered to make my vehicle available to Ford for inspection, Ford declined.

My rearview camera sometimes will not work. Ford has many recalls for this but not for my 2020 Ranger.

I purchased a 2020 Ford Ranger truck which had, either a faulty "bulb," or other type of device which caused the driver side tail light to not illuminate. I was not made aware of this, as I do not commonly check to see if the taillights were when I turn on the lights to drive at night. However, I observed the faulty taillight probably a year or so after owning the vehicle. The vehicle is not frequently driven, as I brought the 2020 Ford Ranger truck new, and it presently as of April 2025 has about 7300 miles on it. When I became aware of the faulty taillight, I went to the local AutoZone store to purchase a replacement bulb, and was informed by a fairly knowledgeable individual that my vehicle did not have a standard "bulb" which could be replaced. I was told the unit which housed the component which caused the lighting to occur was an integrated compounded which had to be totally replaced, at a significant cost. I have not made any attempts to remove the component, and was informed there would be a significant cost to do so. On March 29, 2025 I was pulled over by a local sheriff's office indicating there was a problem with not only the taillight on the driver side not operating, but also problems with operation of my brake lights and other lights in the rear of the truck. I was informed that I should get the problem fixed as soon as possible. I did explain that I had previously made an attempt to get the driver side taillight fixed, but the component, was not available to do so. I then began to research the problem, and found an article was online which was attributed to Consumer Reports entitled "Ford recalls Ranger pickup trucks for taillight problem, automaker says loose electrical connections could lead to a crash" the basis of the November 25, 2019 article stated "Ford is recalling 78,264 of its 2019 Ranger pickup trucks because electrical connector may be loose or not properly installed. As a result the taillights may be inoperative or work intermittently.

The taillight on the driver's side has never worked properly. Took it for repair to get a replacement bulb. Personnel at local auto parts store were aware of problems on this model vehicle. They stated no replacement bulbs were available because it required an electronic "bulb." Was informed that the part was VERY expensive, so was unable to get replacement part. Was pulled over by local police and told no lights in rear of vehicle, including brake lights were working. Consumer reports reported same problem with 2019 Ford Ranger and had article "Ford Recalls Ranger Pickup Trucks for Taillight Problem." November 25, 2019. Ford recalled 78,264, year 2019 Rangers. My truck is a 2020 Ranger and the problem with the taillights0030 described for 2019 is IDENTICAL TO THE ONE DESCRIBED FOR 2019.

The contact owned a 2020 Ford Ranger. The contact stated that his wife had parked the vehicle in the residence driveway and was bringing purchases into the residence when she returned to the vehicle she observed that gray smoke was being emitted from under the hood. The contact came out to the driveway, observed the smoke, and saw that flames were coming from the driver's and passenger side of the hood. The contact stated that the fire department was called but when they arrived the vehicle was engulfed from the front to the rear. The contact stated that the fire department extinguished the flames using water and chemicals. The contact stated that the fire department had written an incident report. The contact stated that his insurance provider had the vehicle towed to an impound lot and declared the vehicle a total loss. The manufacturer was informed of the failure and referred the contact back to his insurance provider. The failure mileage was approximately 24,500.

While driving on the highway the tensioner pulley snapped off from the timing cover. Losing the pulley caused my serpentine belt to become tangled in the radiator fan. My engine over heated and I lost power steering. This left me stranded on the side of the highway for hours. I took the truck to ford, the origional quote was 3900, but they worked with me and got it down to 1765.

Date/Time: [XXX] Approximately 3:00PM local Weather: About 10F, light wind. No precipitation. Event Description: Vehicle had sat for > 12 hours. Started vehicle and operated wipers to clear snow. Vehicle was in 2WD; Shifted to “D” and began driving forward down driveway slowly; normal throttle response. Shifted from 2WD to 4WD. 4WD engaged, and there was normal throttle response. After driving for about 15 seconds, near end of driveway, removed foot from accelerator to slow to see if there was traffic. I saw that there was none and tried to accelerate. No throttle response; the vehicle came to a stop in the snow. Note: when I state “no throttle response”, I mean no engine revving; it was not simply that the drivetrain wasn’t sending engine power to the wheels, the engine wasn’t increasing throttle as I commanded. Momentarily surprised, I pressed harder to about 30% throttle, still no response. I removed my foot from the accelerator and applied the brake. As I did so, looked at the center console display. It was showing that it had lost connection with my phone (I had left it in the house) and it was trying to reconnect. At that moment I felt a slight “bump” of acceleration. The time between first noticing no throttle response and feeling the “bump” was about 3 seconds. I decided to go back for my phone (and I also didn’t want to get on the road with a wonky throttle) so I backed up to the house; normal throttle response. I retrieved my phone and everything operated normally after that. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2020 Ford Ranger. The contact stated that while driving at various speeds, the "Pre-Collision Assist Not Available Sensor Blocked" message was displayed on the instrument panel. The contact stated that whenever the message was displayed with the Cruise Control activated, the Cruise Control would disengage independently. The dealer was notified of the issue but offered no assistance. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 20,000.