2024 FORD RANGER Complaints

while driving between 5-10 MPH on a dry, smooth paved road, the transmission began cycling through 4WD modes and began shifting from normal mode to 4WD Sand mode, i was able to pull over and park, but the transmission continued shifting and fully transitioned to 4WD mode. This is the second time it has occurred, the first time the transmission fully switched 4WD and i was barely able to pull off the road to reset it. after first issue, dealership noted the following "3131 confirmed concern. pulled codes with FDRS and found P05D3 in ABS module. Referred to workshop manual and run pinpoint test AH for concern. AH1 yes. AH2 had me reconfigure ABS module with As-Built data rerun self test. No codes returned and system operating correctly at this time." There multiple online forums with owners having the same problem. https://www.ranger6g.com/forum/threads/24-rr-shifted-while-driving.18956/ Truck will be going to dealership for assessment again.

Why hasn't Ford found replacement parts for this airbag defect. I don't feel safe driving a car that may cause more injury to my person if I'm in an accident. This should fixed immediately. Or I would like to return my vehicle for full refund or get a new one with out safety issues.

I have had the truck for 2 weeks. Three times I've almost rearended a car in front because of a braking system that doesn't stop the truck quickly enough. The pedal will travel 6" at times before it engages. This is very dangerous especially when braking when travelling around curves or round a bouts. I've taken the vehicle to two dealers and an independent brake shop. Dealers say it's normal. Independent brake shop warned against driving the truck. Town and Country stated that the pedal going to the floor is normal. No warning prior to this incident.

I was slowing down, foot off of throttle, to make a left turn. After completing turn and wanting to speed up, I had no throttle response for 2 or 3 seconds. Then all of a sudden back to normal. There was no accident. This has happened before, at least 3 times. Same/similar circumstances and result. I have not taken it to the dealer yet after reading other owners doing so and was not resolved.

The Drive Mode Control has been malfunctioning and selecting different drive modes while the vehicle is in motion without any physical input from myself, the driver. While driving in the normal two-wheel drive high (2H) at various rates of speed the Drive Mode Control will start clicking and selecting different drive modes, such as going to four-wheel drive low (4L) or four-wheel drive high (4H) and a pop-up message in the instrument cluster display showing the change displaying Mud/Ruts, Sand, Slippery modes being selected. This has been continuously occurring randomly at both low and high rates of speed. There are never any objects or materials in contact with the Drive mode Control when this happens, it does it on it's own with an audible clicking noise. This is effectively putting myself, my family and other drivers safety at risk since the truck is making changes to the power train without any input from myself and I have to take my attention off the road to bring the truck back into normal two-wheel drive high (2H) mode. I have contacted both Ford Motor Company directly and my local Ford Dealer Service Center to try to have the vehicle inspected but have not been able to due their delay in being able to diagnose the vehicle. This has been going on for 4+ months and the date provided below is the last occurrence of the issue.

Vehicle has multiple drive modes. Vehicle will attempt to change drive modes while moving without any input from the driver, i.e. using the drive mode control to change drive modes. Results in vehicle attempting to shift into four-wheel-drive or other drive modes while vehicle is in motion, even at highway speeds.

The truck randomly loses power, sometimes after rounding a corner, getting into turn lane, or over a speedbump the accelerator is dead for 1-2 seconds and the truck does not move forward. It has left me in a precarious position in the middle of the road with on coming traffic.

When truck was new at 400 miles Abs traction controll rear collision and all braking erro codes were displayed on dash. Brought to dealer had a bad wheel speed sensor in rear. At that time I asked about large amount of rear brakes dust on vehicle like if the brakes were dragging. Technician said just poor oem pads. Now at 14k miles rear pads at 6mm thickness back wheels are always covered in brake dust. I was at dealer asked if there is anything they could do regarding initial build quality. Dealer said no there is no fault just poorly made pads. As a consumer ths is less then except able of a vehicle to almost need new rear brakes at 14k miles. Delaer should be replacing these pads on there behalf not the customer.

When driving truck especially in rolling traffic truck has hard time downshifting and clunky and lunches as transmition tries to figure what gear to be in. It is an intermittently happening but now evolved to completely dropping out of gear goes into neutral were you can rev engine without truck moving foward. This has only happened twice both time as I was slowing down to make a turn and the trying to Accelerate after turn truck would go limp. Dealer could not replicate issues and could not find any issues advised to return is issue consistent

ive had 2 seperate issues with my 2024 for ranger one is a steering assist fault the other is a electric fault on the speedometer jumping up and down while its in park and causing an issue