2016 GMC CANYON Complaints

The contact owns a 2016 GMC Canyon. The contact stated that while driving at various speeds on several occasions, the traction control warning light illuminated and the messages "Service Power Steering" and “Service Stabili-trak" were displayed. Additionally, the contact stated that the steering wheel became stiff and was very difficult to turn. On several occasions, the vehicle was pulled over to the side of the road and restarted. The vehicle was taken to a dealer however, the failure was not duplicated. The manufacturer was notified of the failure. The failure mileage was 139,000.

stability tracker alerts, then loss of power steering, would happen randomly, sometimes few times in a row, sometime after shutting down vehicle would reset it - other times not. safety issue when: 1) driving on freeway - made steering difficult if/when needing to make sudden turn or lane change 2) 90 degree turns would be difficult 3) sudden loss of steering ability when there is other traffic oncoming. Taken to auto shop - they ran a few checks, but the issue was sporadic, usually does not happen right away, so it was not reproducible on demand. First repair was for inspection and fluids, did not find issue with the Stability Tracker. When the problem resumed again, took the vehicle back to the shop and they researched the issue more and recommended replacing the steering column. The technician said the issue was on a Recall on previous year/model but not the 2016. The issue started about mid-2024. So far as of 3/2025 the issue has not happened since the column replacement on 2/12/2025. Warning would be the Stability Tracker

The contact owns a 2016 GMC Canyon. The contact stated that while driving on the highway at 65 MPH, the vehicle experienced a loss of power steering functionality, and the steering wheel became stiff and difficult to turn. The traction control and Service Vehicle Soon lights were illuminated. The message "Power Steering Fault - Drive with Care” was displayed. The contact pulled over to the shoulder lane to restart the vehicle and was able to continue driving. The contact stated that the failure had occurred on several occasions. The vehicle was taken to a local dealer and was inspected; however, the vehicle was not diagnosed. The contact was informed that the VIN was not under recall, and there was no failure cause for the failure found. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 94,000.

The contact owns a 2016 GMC Canyon. The contact stated while driving 65 MPH, the vehicle lost power steering functionality, and the steering wheel became significantly difficult to steer. The power steering, the transfer case, and the anti-sway warning lights were illuminated. The contact was able to veer to the side of the road. The contact turned off and restarted the vehicle, and the vehicle operated as needed. Additionally, the contact stated while driving approximately 50 MPH around a curve, the failure recurred. The contact depressed the brake pedal, and the vehicle decelerated; however, the vehicle went into a ditch, which scratched paint off the front passenger's side plastic bumper. There was no injury sustained. The contact turned off and restarted the vehicle, and the vehicle operated as needed. The contact was able to resume driving. The vehicle was taken to an independent mechanic, where it was diagnosed with steering column sensor failure. The vehicle was not repaired. The contact related the failure to NHTSA Action Number: RQ19001 (Steering). The dealer and the manufacturer were notified of the failure and informed the contact that the VIN was not included in a related recall. The failure mileage was approximately 190,000.

Power Steering system failure warning message followed by a Stabilitrac system failure warning which caused the drivers front side brake to apply. I could not duplicate the brake application issue with the dealer but the other failures which included loss of power steering at highway speeds and lack of stabilitrac system was repeatable. A full replacement of power steering rack was performed with a front end alignment after dealing with the problem for weeks. Was told this manufacturing failure was covered for free in models newer and older than my truck (same model) but my truck was not covered. This is unsafe and not acceptable.

I am the owner of a 2016 GMC Canyon truck, which i purchased used in approx 2020 with about 43,000 miles on it...today's date is now 1/5/25 and the truck has approx 99,0000 mile on it. Over the last 2 years the electronic stability control has failed approx 20 times. A warning light appears on the dash stating the failure of the power steering and the stabilitrac. When this happens steering the truck and be extremely difficult and I am forced to pull off the road. Usually when the truck is turned off for a short while and then turned back on the problem will fix itself, but only for a few minutes or hours and the problem reoccurs. Last week I took the truck to a GM dealer and had the steering angle sensor recalibrated..which fixed the problem for 1 month. Now it is failing again! My wife is afraid and refuses to drive the truck because if this happens again while she is driving she isn't strong enough to turn the wheel..particularly from a complete stopped position. This is a very serious and dangerous problem that GM needs to be responsible to resolve.

The contact owns a 2016 GMC Canyon. The contact stated while driving at an undisclosed speed, the steering wheel seized, and the steering wheel was jerking with several unknown warning lights illuminated. The contact stated that the steering wheel became difficult to turn. The vehicle was restarted; however, the failure reoccurred. The vehicle was taken to the dealer but was not diagnosed or repaired. The manufacturer was made aware of the failure. The approximate failure mileage was 302,000.

The contact owns a 2016 GMC Canyon. The contact stated while driving 65 MPH, the ABS, and service stabili-trak warning lights were illuminated. The steering wheel began to vibrate, and the brake pedal became firm. The contact was able to continue driving. The vehicle was not taken to a dealer. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 220,674.

I bought my 2016 GMC Canyon back in 2018 with 40k miles on it. After couple of months, I noticed that when traveling at approx 70MPH front wheels are shaking violently. I did wheel alignment and other wheel check but still there. Lately, power steering stabilitrak keep showing up on my panel. Since it can’t be resetted, Im literally driving like arm wrestling in the middle of the road specially during parking. After many years of wondering of what the wheel vibration is causing, electronic Rack and Pinion issue was the result of diagnostic conducted by Schumacher Chevrolet here in West Palm Beach, FL. They quoted me 3K for the repair.

The contact owns a 2016 GMC Canyon. The contact stated that while his wife was driving approximately 70 MPH, the power steering suddenly failed, and the steering wheel became difficult to turn in either direction. During the failure, the message "Power Steering Failure" was displayed. The cause of the failure was not yet determined. The manufacturer and local dealer were notified of the failure, but no assistance was provided. The failure mileage was 51,867.