2016 GMC CANYON Complaints

Sudden loss of power steering. Happened to me a lot a times. Sometimes when I driving on a freeway already took it to the GMC. Paid money and the problem is not solved.

Aug 31, 2023 Power steering failure. Aug 31, 2023 I started the vehicle, warning bell chimed, dash warning to "service power steering" appeared. Then dash warning, of vehicle stability control appeared. Steering wheel was extremely difficult to turn. I shut the vehicle off and restarted, which momentarily cleared the problem. I backed out of the driveway and the problem described above returned along with the inability to turn the wheel. I shut the ignition off and restarted the truck, which cleared the problem. I attempted a short drive, and the problem (described above) returned within a 1/4 mile at a speed of 30 mph. I managed (with difficulty) to safely drive the vehicle to the shoulder as I was driving in a straight line at the time of the incident. No mechanic or service personnel have inspected or diagnosed this problem as yet. I have scheduled an apptointment with my mechanic. In my opinion the vehicle is unsafe to operate at this time both to the occupants and the general public. No recalls are currently issued on the vehicle, although the vehicle manufacturer has had prior issues with the 2015 model which mirror the issues on the 2016 model which was recognized by GMC as a safety issue in regards the prior year, the manufacturer (gmc) has not recognized the 2016 issue as a safety problem and subsequent safety recall has not been issued.

The stabilitrak power steering system fails randomly at high speeds causing loss of control and risk of crashing. This is a known problem to GMC and a recall was issued for 2015 canyon trucks requiring the dealer to replace the steering gear torque sensor cover assembly free of charge due to defective electrical connections within the assembly. They have excluded 2016 and it is a serious problem. This problem is widely reported on GMC and Chevy forums and Reddit for 2016 models. It’s essentially all over the internet for anyone willing to simply look. The error “loss of power steering, proceed with caution” appears as does the lane departure light and check engine light. The errors “Stabilitrack has failed” “Torque sensor failure” Fault Code C0545 also appear. After shutting the car off and restarting , all error codes and lights disappear and do not appear on a code reader. The issue then happens sporadically again at very dangerous times. It is the exact same issue as the 2015 recall # 21V213000 issued on Mar 25, 2021 but GMC refuses to help.The problem is a defective torque censor connection. Please help. I don’t want to die on the freeway.

While driving at 70 MPH on the interstate approaching a bend in the path of travel the "service traction control" warning was displayed on the instrument panel display and just after that the electronic power steering stopped working causing a near collision with a vehicle in the adjacent lane. The local GMC dealership noted a recall for the 2015 Canyon model for the steering gear torque sensor cover assembly to be replaced due to corroded electrical connections. The number (15595) recall was not associated with my VIN but should be added as part of the vehicles in the recall as it is experiencing the same issues.

The contact owns a 2016 GMC Canyon. The contact stated while driving 65 MPH, the stability control and power steering warning lights illuminated. The vehicle then lost stability control functionality and the steering wheel became firm. The contact stopped on the side of road and turned off the vehicle. The vehicle was restarted and operated normally. The vehicle was not diagnosed or repaired. The manufacturer was contacted and stated that the vehicle needed to diagnosed. The failure mileage was 116,000. The VIN was not available.

Vehicle Stability Control systems light comes on sporadically and stalls the power steering. In other words, the power steering turns off at any time and dangerously on a highway, when the Vehicle Stability Control lights comes on the dashboard. The first diagnosis (May27, 2023) of the above issue was performed at Green Brooks, a Certified NJ GMC Service Dealership yielded no results from their inspection. A second diagnosis was needed due to the vehicle's malfunctioning danger to me and other drivers on the road. The Certified GMC Service Dealership Ewing Buick/GMC TX diagnosis (June 12, 2023) showed a "STEERING GEAR INTERNAL TORQUE SENSOR" costing two thousand one hundred and eight dollars and fifty cents ($2,108.50) to complete. The codes were C0545 00 stored in DSCM followed by S14849247 requiring Steering Gear Replacement. The total cost including labor cost was two thousand seven hundred and ninety dollars and eighty-eight cents ($2,719.88).

July 30, 2021 airbag warning - dealer replaced left front impact sensor mileage 33905 March 9, 2022 rough idling and stalling - dealer replaced evap purge solenoid valve mileage 39067 April 20, 2023 airbag warning - dealer replaced right front impact sensor and air bag module mileage 44496

The problem: the power steering disables at high speeds suddenly due to a potential poor electrical connection within the steering gear assembly. The hazards: a loss of power steering makes it more difficult for me to maintain control of my vehicle and in turn increases my risk of a crash. This problem requires steering inputs with increased effort. It clears with a power cycle to the truck but then reoccurs randomly.

While driving in excess of 40mph, my truck experience two warning lights "Service: Stabilitrak" and "Service: Power Steering Drive With Care", and my power steering immediately went out and my steering was very difficult and had to maneuver off the road and through traffic to the side of the road, and was very fearful for my safety and others around me on the road when this happened. I could not turn the vehicle without a tremendous amount of effort. After pulling to the side of the road, I immediately shutoff the vehicle and restarted and the steering and messages were gone. I began driving down the road and it happened again within 5 minutes. I shutdown and it reset again. I then proceeded to the GMC Dealer in West Chester Pa (Faulkner) to determine if they are familiar with this problem and they said they've never heard of this and couldn't find anything wrong with the truck otherthan a couple Codes unrelated to any Steering problems.

The Power starting keeps going out while driving it. Once vehicle is turned off and back on it resets and works again. There is active recall for this exact issue but only in 2015 models and mine is a 2016 so told it isn’t a part of recall. It happened a few times several months ago but GMC service center couldn’t get problem to recreate and I didn’t have good documentation for the few times it had happened. GMC then offered free onstar for several months to try to help track problem. It hadn’t happened in last several months until Friday. It has now happened 7 times in last 4 days. On star sent me two reports indicating a code of U0240 with ABS system failure code. I took videos and pictures of the dashboard with what was showing. There is service message saying “power stealing drive with care” and “stabilitrak” service message too. GMC not getting me in for another week. I have a new 16 year old driver who drives this vehicle and it’s so unsafe! I don’t understand how I keep being told my vehicle is not included in the recall but it’s the same issue. I have to keep taking pictures and videos and pushing onstar button when it happens.