2019 GMC SIERRA 1500 Complaints

Experience water leaking 3rd brake light and rear window. Leaking in both areas. Also concerned about mold that could be caused by this.

The contact owns a 2019 GMC Sierra 1500. The contact stated that the rearview camera displayed a black screen while the vehicle was in reverse(R). The contact stated that the failure obstructed driving visibility, preventing the driver from safely operating the vehicle. The vehicle was taken to the dealer; however, the contact was informed by the dealer that the part needed for the recall repair was not available. The vehicle was not repaired. The contact stated that the failure persisted. The manufacturer was not notified of the failure. The failure mileage was unknown.

Engine malfunction, had dealer look at truck and they said I needed a new engine, check engine light came on and a knocking noise appeared suddenly. Reading about 2021+ sierra with 6.2 engine that has a recall with the same problem as mine. Wondering why that recall wasn’t extended to my truck as well.

The contact owns a 2019 GMC Sierra 1500. The contact stated that while driving approximately 60 MPH, the vehicle started shuddering. The check engine and stabilizer warning lights were occasionally illuminated. The contact pulled over into a nearby gas station, and the vehicle was later towed to a local dealer. The vehicle remained at the local dealer, where it was diagnosed and determined that the engine needed to be replaced. The vehicle was not repaired due to the cost. The local dealer informed the contact that the failure was related to NHTSA Campaign: 25V274000 (Engine and Engine Cooling); however, the VIN was not included. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 49,000.

Engine failure on 12/1/2025 16,253 miles and 591.9 hours on vehicle. Vehicle has the 6.2l engine. Towed to dealership

Engine oil cooler lines leaking from crimp joints. "Oil Pressure Low Turn Vehicle Off" display showed on dashboard. Oil is present all over the bottom of my truck as well as a trail along the road and the parking lot where I parked it. I have not brought it to the dealership yet. There has been a Customer Service Program notice about this issue, I got my truck after the issue was sent out so I did not get the letter or supposedly this truck is not part of it even thought it is the exact issue. Customer Service Program number N212326940.

The contact owns a 2019 GMC Sierra 1500. The contact stated that while driving at various speeds, the vehicle hesitated and failed to properly accelerate while the accelerator pedal was depressed. No warning light was illuminated. In addition, the contact was aware of excessive oil consumption and the vehicle was previously taken to a local dealer. An appointment with the same local dealer was scheduled to inspect the vehicle. The vehicle was not yet repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 87,000.

The contact owns a 2019 GMC Sierra 1500. The contact stated that while driving 62 MPH, the vehicle lost motive power. There was no warning light illuminated. The vehicle was towed to the dealer, where it was diagnosed and determined that the fuel pump module sensor had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 82,000. The VIN was not available.

Complete engine failure. I was driving approximately 55 miles an hour, then all of a sudden the cruise control automatically shut off and a series of alarms are triggered. When pressing the accelerator pedal, the engine vibrated excessively in Cleary indicated catastrophic engine failure. I was lucky enough to make it to the nearby dealer who confirmed a complete engine failure. I ended up buying a new vehicle that day to avoid being stranded.

Around June 2025 under normal driving my truck displayed engine oil low which I promptly checked the oil to find that it was in range. The light later went off but I still brought it to the dealership to which they could find no issues. From there over the next month or so the truck developed a low end popping sound on start up and at my next oil change at the dealership in August of 25 I asked them to listen to see if they heard it and could recommend a course of action. They reported not hearing anything. On October 19th I had my family in the truck with me and during normal acceleration the engine had a loud pop sound and lost power. Every warning light came on and I pulled over promptly when safe. I had it towed to the dealership and their initial diagnosis was a failure on cylinder 4 with a suspected failure of either the cam shaft or lifter. Given the poor design of the lifter I didn’t want to go back with the OEM lifter so I had it towed to an aftermarket shop. It is there now and they are in the process of tearing down the engine. After watching a video on YouTube I fear my truck is part of the connecting rod bearing failure under PE25-001. My understanding is there is an official investigation into the trucks outside the initial recall. I wanted to submit this for your review as the truck only had 74,000 miles. Freeman GMC in Grapevine, Tx has performed all the maintenance and should have documentation.