2024 GMC SIERRA 1500 Complaints

transmission shift hard and slipping. When step on gas to go faster transmission shifts really hard like going drop on ground. Sometimes wont shift at all only goes up to 69 till left off gas and then transmission will shift. Start happening with about 10000 miles on truck and GMC said this is normal. Now need a torque converter and shift module in it.

Was traveling home and started losing power going up a hill on XXX. The truck was surging, the check engine light came on and an audible warning of no (low?) oil pressure. The truck shut off on a busy interstate highway and barely got onto the shoulder. The tow truck driver had to lay on the ground with part of his body in the lane of travel to place "skids" under the rear tires because there is no way to place this vehicle in neutral for a tow without a special GM tool. When I contacted Harry Robinson GMC service center in [XXX], they told me that it was no longer a safety recall because the truck had passed diagnostics and new, high viscosity oil was put in the truck XXX. The GMC app says code P0016 which is the dreaded 6.2L camshaft to crankshaft alignment that accompanies engine component failure. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Ever since I bought this truck new, I noticed a lot of metal shavings and debris in the oil filter every single time I changed the oil. I took it to the dealership multiple times to have this looked into before the engine recall came out. The dealership took pictures of the metal and sent them to a General Motors engineer, but the engineer just told them it was "normal." Later on, the truck went in for the official recall inspection, passed the PICO test, and nothing was fixed. Then on August 4, 2026, I was driving on a crowded expressway right through a construction zone with absolutely no shoulder to pull over on. Out of nowhere, the truck started hesitating badly, lost power, and the engine started making a really loud knocking noise. It barely ran, and it was incredibly dangerous because there was nowhere to go and traffic was heavy. Luckily, I was able to limp the truck along just far enough to clear the construction zone and pull over safely. the truck was towed to the dealer were they confirmed the engine was blown, and needs replaced.

Ever since I bought this truck new, I noticed a lot of metal shavings and debris in the oil filter every single time I changed the oil. I took it to the dealership multiple times to have this looked into before the engine recall came out. The dealership took pictures of the metal and sent them to a General Motors engineer, but the engineer just told them it was "normal." Later on, the truck went in for the official recall inspection, passed the PICO test, and nothing was fixed. Then on August 4, 2026, I was driving on a crowded expressway right through a construction zone with absolutely no shoulder to pull over on. Out of nowhere, the truck started hesitating badly, lost power, and the engine started making a really loud knocking noise. It was barely running, and it was incredibly dangerous because there was nowhere to go and traffic was heavy. Luckily, I was able to limp the truck along just far enough to clear the construction zone and pull over safely.

The contact owns a 2024 GMC Sierra 1500. The contact stated that while driving at an undisclosed speed, the engine seized, and the transmission independently shifted into park(P). The failure had occurred while driving on a busy highway at highway speeds. The contact's minor children were occupants inside the vehicle during the failure. The vehicle stalled in the middle of the highway. No warning lights were illuminated. The contact stated that while attempting to restart the vehicle, the vehicle failed to start. The vehicle was towed to the dealer where it was diagnosed with catastrophic engine failure. The contact was informed that the engine needed to be replaced. The vehicle was repaired; however, the failure reoccurred eight months later. The vehicle was taken to the dealer where it was diagnosed with catastrophic engine failure a second time. The contact was informed that the engine needed to be replaced. The vehicle was in the process of being repaired. The manufacturer was made aware of the failure and a case was filed. The failure mileage was approximately 39,000.

While driving on XXX I received a message on the dash: service transmission, will not be able to shift soon. I went to the nearest GMC service center, located in [XXX]. Their diagnostics indicated that the Gear Shift Control Module needed to be replaced with new PN 86421783. That part was not available until XXX, but old PN 86274946 was available at a few dealersships, and it acould possibly be ordered and arrive sooner than XXX. I was told that driving the truck would be okay, but the part should be replaced as soon as possible. I live over an hour's drive from [XXX], and with the assurance that driving the GMC was okay, I chose to have the part shipped to and replaced at the dealership in [XXX], the nearest one to [XXX]. I drove back to [XXX], stopping at the Waldoboro dealership to make an appointment for their inspection of my truck, their troubleshooting the problem, and ordering the necessary parts to repair the transmission. When the part number went into their ordering system, the dealership was advised that no parts were available and no availability date was known. I contacted GMC Customer Assistance to express my concern and request assistance in locating the parts, but she was also unable to locate the parts or speed their availability. Again, on the assurance that the truck was okay to drive, on XXX I drove to my storage units near [XXX], and when I tried to leave and shifted into reverse the truck would not move. AAA towed me to the dealership in Waldoboro, and the replacement parts search began. Finally, on 7/28/26 I was advised that the part was at the dealership, and on XXX I picked up my repaired GMC truck. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Unknown. Went in to get inspection for the recall on the motor and it failed the test so motor was replaced. Now the I've hade the motor for 9 moths started hearing knocking in the motor and losing power.

The engine (6.2L V8) in my 2024 GMC Sierra 1500 AT4 failed at approximately 40,750 miles. I began hearing a ticking noise coming from the engine, and the dealership subsequently diagnosed the cause as damaged bearings that in turn damaged the crankshaft, requiring a full engine replacement. Notably, this vehicle was not included in the related recall covering this engine defect, despite exhibiting the same failure. The original failed engine may be available for inspection upon request but I would need to confirm with the dealership whether it was retained or already returned to GM under warranty. This defect creates a serious safety risk because a damaged crankshaft and bearings can cause the engine to lose power or shut off without warning while driving. An unexpected loss of engine power at highway speed or in traffic could result in loss of vehicle control, reduced ability to accelerate out of a hazard, and increased risk of a collision to myself and to other drivers on the road. The failure gave no advance warning, so there was no opportunity to pull over safely before the issue became apparent. The fact that this failure occurred outside the scope of the existing recall suggests other vehicles with the same defect may be similarly at risk without notice. The dealership diagnosed damaged bearings and a damaged crankshaft as the cause of the ticking noise and performed a full engine replacement under warranty, confirming the failure. The dealership diagnosed the failure and performed the repair; I do not have direct confirmation of whether GM's engineering or warranty division conducted a separate inspection of the failed components beyond the dealer-level diagnosis. No warning lights or messages appeared on the dashboard at any point. The only symptom prior to failure was a ticking sound from the engine which I noticed shortly before the engine required replacement. I was not provided any electronic warning that would have alerted me.

I was driving on the highway when the vehicle started to make clinking noises. The vehicle started to lose power as I accelerated it would feel like something was pulling me in the opposite direction and the knocking noise would get louder. Ultimately, I had the vehicle towed to a dealership. This vehicle passed the L87 recall not too long ago, and the vehicle is barely used.

While driving at highway speed in normal traffic, the upper front grill deflector detached from the vehicle and struck the windshield, cracking the windshield. This appears consistent with the defect that is the subject of Safety Recall N24290120.