2018 GMC TERRAIN Complaints

On Wed., Dec. 6 around 3:15 pm during heavy traffic on FWY [XXX], cars slowed down to a brief complete stop. When I went to start slowly as traffic began to move, engine completely shut down. I could not open windows or my door to get out of vehicle. Immediately called 911 and was transferred to DPS. It took approximately 65 minutes before I had help and was finally towed from the dangerous freeway lane where I was stuck and with vehicle completely stalled and locked down, I couldn't even get car in N to be able to have help moving to a non dangerous place outside of the FWY lanes. This is the fifth time this car locks down. I've learned to open a panel by the foot brake area, pull a lever in that area and be able to move the car to a safe location until I got towed into the dealer. It is the second time that this has happened in a potentially dangerous street and now Freeway. Danger to myself and many others that had to maneuver around me. The first time (around 2020) the car totally shut down, it was reported that a computer harness had to be replaced. This last time I was faced with such a dangerous situation on a FWY it was determined that the ECM (Engine Control Module) had caused the shutdown and locked the vehicle to where I could not even get out for close to an hour. The ECM was replaced by GM and the car is running again, but my shock and trauma still haunt me as to the self and others danger that was present. . GMC Dealer finally determined after several attempts that ECM was the problem. Unsure if available to inspect it. Delivered car back 12/8. . Heavy freeway traffic at peak hour put me and many others in serious danger. . My dealer report reads it was difficult to diagnose and finally find ECM was the problem. .Vehicle has not been inspected by Manufacturer, police, or insurance. .A few minutes before this lock-down an engine icon appeared while on the FWY. Previous shutdown incidents had no warnings or messages before locking up. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFO

The 2018 GMC Terrain has the AutoStop feature but does not incorporate a switch to defeat AutoStop. In heavy stop and go traffic or when fast acceleration from stop is required, the response of the engine in having to restart creates not only a nuisance condition but a severe accident hazard. It not only hesitates from stopped, it lurches forward after hesitating, which could cause a collision with a vehicle in front. I have had several other vehicles equipped with AutoStop, and all of them have a defeat or cancel AutoStop switch to allow the operator the opportunity to turn AutoStop Off. My 2018 Terrain Denali is now on its third battery. Having a dead battery in traffic also constitutes a safety hazard as does the inherent danger of using jumper cables. I have asked my dealer for a way to defeat the faulty feature, but they either cannot or will not do it. There must be a software code to easily allow this that the dealer can perform or a slight hardware modification to allow the operator to defeat AutoStop when it creates a safety hazard.

Driving 2,5 hrs from Binghamton, NY towards Long Island on Saturday. We took a short break and after that I got onto the highway and not even hit the 50 miles/hour speed I received “engine power reduce” alert on the dashboard and car stalled. I was able to pull the car off the road. I was provided a tow truck by the state police and moved to closest GMC service, GRAND PRIZE GMC Nanuet, NY. This car has only 30,309 miles and it’s 2018. The car has been fixed by replacing 5 parts, oxygen sensor, pcv tube, air inlet tube etc. We ended up paying $1,460 just before the Holidays. Rightfully, we are very upset with this unexpected event driving a basically brand new car, in 30000 miles. This car has been mostly driven by my wife who is in 60s in local streets not exposed to harsh enviroments. There is a recall I noticed online for 2019 models and almost from the same area of throttle body, but nothing for 2018. Now, my wife and I hesitating to drive the car. Are we going to get stuck on the road again?

There is an has been an issue with my electrical system says I purchased this car in 2017. Myself believe that the issues have not been documented until 2020. When my racy begins to run out, my engine light has been coming on and I’ve been getting the same code P1101 I took my vehicle to GMC and they told me that the engine light came on because the tape came loose. I brought this vehicle and there’s no way there should be no tape on it. The service tech also told me that if the problem continue to bring it back and I will have to pay $120 or whatever the label rate was for them to research I contacted GMC to file a complaint and I received the whole bunch of calls from a guy named Kevin. I believe he told me that he had been contacting [XXX] and no one returned his call and that he was sorry he couldn’t help me. This is my report number one of them from GMC. [XXX]. Everywhere I take my car they tell me that they have a lot of customers with the same issue and they tried to replace what the code is matching which is the mass airflow sensor but that does not help there is some type of problem with the engine or the electrical system with this vehicle. I am not the only consumer that has had this problem. I don’t know what to do. I have two kids I cannot afford to keep pay and label rate for them not to find the problem. I am also attaching the typical email that GMC sent out when they are working with the dealerships because I have been in contact with them and the person that was calling and then they sent me this email. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

While driving down the road at approximately 55 mph, came up to an intersection, 4 Lane I was in the right lane to go straight, there was a right turn lane next to me. I applied the brakes, pedal was really stiff and very slow to respond, I was able to edge over into the turn lane cutting people off and just barely missing the vehicles in front of me. It took 5 car lengths to stop my vehicle. When I finally was able to get the vehicle fully stopped I was almost in the paths of the crossing traffic.. when the light turned green I was able to slowly cross the intersection looking for a safe place to pull over. Immediately crossing the intersection the Service Brake Assist notification appeared, about another half mile the vehicle informed me of loss of power and that it was reducing engine power (limp mode). I was able to find a gas station parking lot to put it. When I opened the hood I noticed quite a bit of engine oil located under where the brake assist pump was located. I had lost about 1.5 quarts of oil. I refilled that. The next day I returned with a tow dolly. The vehicle was started just long enough to load and unload it at home. We pulled the vacuum pump where upon inspection it was noticed that the part has exploded and so far we are still missing some pieces that may be inside the engine. This is a known and documented problem of this part and should have a safety recall issued. . I still owe over twenty eight thousand on this vehicle and it has only 109,000 miles on it. I hope we can find all the pieces and that the engine wasn't fately harmed. GMC needs to make this right, a lot of people could have been harmed.

The contact owns a 2018 GMC Terrain. The contact stated that while driving at 35 MPH, the brake pedal was firm and became inoperable. No warning light was illuminated. The vehicle was towed to a dealer to be diagnosed. The contact was informed that the failure was due to a faulty vacuum pump. The vehicle had not been repaired. The manufacturer was made aware of the failure and advised the contact to call NHTSA Hotline for assistance. The failure mileage was approximately 66,084.

The contact owns a 2018 GMC Terrain. The contact stated that while driving at approximately 35 MPH going over a hill, the brake pedal was depressed but was firm and failed to depress as needed. The engine power reduced message was displayed and flashed on and then off. The brake assist warning light was illuminated. The service transmission message was displayed. The contact continued to depress the brake pedal until the vehicle responded as needed. The driver was able to pull into a parking lot, and the vehicle rolled to a stop. While driving, the engine misfired. Additionally, the vehicle failed to fully shutoff. The vehicle was towed to the local dealer, where it was diagnosed that the brakes had locked up and that the vacuum pump needed to be replaced. The contact was also informed that the cam shaft had fractured inside the engine. Additionally, the fuel injector, fuel line, and fuel pump needed to be replaced. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 19V645000 (Service Brakes, Hydraulic) and 23V013000 (Fuel System, Gasoline). The manufacturer was contacted, and the contact was informed that the VIN was under recall. The failure mileage was approximately 30,000.

The contact owns a 2018 GMC Terrain. The contact stated while driving 35 MPH, the brake pedal was depressed and went to the floorboard without warning. The contact started driving to the dealer after the failure, and the brake warning light illuminated. The vehicle was inspected and diagnosed with a defective vacuum pump and cam shaft. The manufacturer was notified of the failure and the contact was referred to the NHTSA Hotline. The vehicle had been repaired. The failure mileage was approximately 89,300.

Car is losing go power when accelerating on to interstate. It’s like the transmission loses power, the d illuminates, and then it kicks in to drive. It puts us at risk for an accident and I had a semi almost hit me because of this. This has been reproduced at the mechanic shop as well. No warnings before this happens

My vehicle put itself in park in the middle of an intersection while waiting to make a left turn in the middle of rush hour traffic. The car could not even be placed in neutral to be pushed out of the way of oncoming traffic. Narrowly avoided a collision.