2019 GMC YUKON Complaints

The contact owns a 2019 GMC Yukon. The contact stated that while driving at slow speeds in a parking lot, the transmission unexpectedly downshifted and the vehicle jerked abnormally. The contact stated that when the gear shift lever was shifted to drive(D), the vehicle failed to function as designed. The contact was unable to drive the vehicle, and the vehicle was towed to the residence. No warning light was illuminated. The vehicle was towed to the dealer, where it was diagnosed that metal shavings were found in the oil and the transmission needed to be replaced. The warranty had expired, and the vehicle was not repaired. The contact stated that the failure persisted. The vehicle was then taken to a transmission specialty shop, where it was confirmed that metal shavings were found in the oil and that the transmission was defective and needed to be replaced. The contact took the vehicle back to the private dealer where the vehicle was purchased. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was 125,870.

2019 GMC Youkon with 94,659 miles. I am the second owner of this vehicle. I purchased it used in February 2025. Check engine light came on in route to work on March 5, 2026. Immediately took vehicle to Auto Zone to scan for codes. Multiple codes were returned. I drove it directly to a repair shop for further diagnostics. Return Results were massive lifter failure and cam shaft damage. Why would the check engine light not come on sooner to prevent TOTAL FAILURE. Vehicle was towed to a GMC certified mechanic where it was confirmed that all Lifters and cam shaft were damaged beyond repair and must all be replaced. Estimated Cost of repairs so far: $8,596.80 Labor: Remove & Replace Left And Right Valve Lifter (Both Sides) Coolant Service Oil Change Labor Parts: Engine Camshaft 1 , Genuine GM Engine Valve Lifter Oil Manifold Gasket 1 , Genuine GM Fuel Pump Gasket 1 Engine Timing Cover Gasket Set 1 Engine Valve Lifter Guide 1 Engine Valve Lifter Guide 1 Coolant/Antifreeze Orange Dex-Cool 1 Gal 3 Engine Push Rod 8 Engine Oil Filter 1 0W-20 Full Syn 8 Engine Cylinder Head Bolt Set 1 Engine Valve Lifter Guide 1 Engine Valve Lifter Guide 1 Stock Engine Valve Lifter 4 Stock Engine Valve Lifter 4 Engine Cylinder Head Gasket Kit 1 Engine Cylinder Head Bolt 10 APPROVED Subtotal $8,422.71 + est. Tax $174.09 $8,596.80 Estimated time for repair: going on three weeks

I was driving on RT80 in NJ and my 2019 GMC Yukon lost power. I took it to my local Chevy dealer. The scan code was p0300 engine misfire. They removed right side valve cover and found no bent pushrods. Inspected camshaft and found damage from failed lifter. I had to get a new engine and pay out of pocket $14,435.44

P0304 and P0306 misfiring and compression on both cylinders is 0. Both lifters have broke and collapsed. It started with a noise, once checked by the mechanic, we were told the lifter was going bad, before we could get it repaired it completely broke and that is when the check engine light came on and went off repeated times. At this time it is pouring out black smoke when driving and must have a complete engine replacement. The replacement work has been quoted for $10479.57.

The contact owns a 2019 GMC Yukon XL. The contact stated that while driving approximately 50 - 55 MPH, and slowing down to approximately 40 MPH, the check engine warning light illuminated, and the engine started knocking. The contact noticed that the engine was one quart of oil low after an oil change and driving less than 2,058 miles. The vehicle was not taken to the dealer, but was not repaired. As a certified mechanic, after searching NHTSA.GOV, the contact became aware of NHTSA ID Numbers: EA25007 (Engine, Engine and Engine Cooling) and RQ26001 (Engine); related the failure to the campaigns. The manufacturer was not informed of the failure. The failure mileage was approximately 62,008.

Automatic emergency braking system deployed unexpectedly on acceleration from a traffic light stop. Vehicle was about 10-15 MPH and system operated with no brake pedal input. A vehicle behind had to do a panic stop to avoid collision. Deployment disengaged when accelerator pedal was released. My wife, principal driver, was in the car. She advised this had occurred two times before. No recalls are presently listed for the vehicle.

The contact owns a 2019 GMC Yukon. The contact stated that while driving approximately 5 MPH, a second vehicle traveling approximately 65 MPH crashed into the front drivers side of the vehicle. During the crash, the vehicle sustained severe front-end damage, but no airbags in the vehicle deployed. The contact sustained injuries that included fractured ribs and a fractured left hip, and a sternum contusion. The contact was air-lifted to the hospital. Two occupants in the second vehicle were transported to the hospital with unknown injuries. A police report was taken at the scene, and the vehicle was towed away. The contact indicated that the vehicle was destroyed during the crash. The cause of the failure was not determined. The manufacturer and local dealer were not contacted. The failure mileage was 170,000.

Check engine light came on. Went off a little later and then came back on. Took it to the dealership where they ran codes. They changed the fuel injector and spark plugs based on the codes listed. They heard a noise coming from under the engine and felt like it was the same failure that it happened in the 2021 to 2024 Yukon models those engines had been recalled. Was quoted $15,000 for a new engine was also charged $1000 for the fuel injector and spark plugs.

I suddenly noticed a noise coming from the engine that sounded like a noisy lifter and stopped using the car after hearing it. The next day I called Circle Chevrolet to check and verify if they could check the car and do any work required under the CPO Warranty. They advised that they could since they were part of the GM Family and could do any work required under the CPO Warranty. I then arranged to have the car towed to Circle Chevrolet to prevent any further damage, that was on Oct 20, 2025. The CPO Warranty was due to expire on Oct 27, 2025 due to time, not mileage. The dealership advised that the vehicle would need to be examined by one of only 3 qualified mechanics in their shop who could do this evaluation and determination if the issue(s) were covered under the CPO Warranty and it would be about 3 days before they could have one of their 3 qualified technicians check the car. The Service Adviser called me back on October 22nd, 2025, and advised that Cylinder 5 had noisy lifters and that they would be changing out the engine with a newly rebuilt engine, all under the CPO Warranty. The Service Adviser said it would take 3-5 days to get the replacement engine in and then about 2-3 days to replace the engine. However, less then 24 hours after getting my car back, the check engine light came on, which was not on when I had the car towed to the dealer. They said the catalytic converter needed to be replaced and said it would be ~$6000. They refused to cover the replacement even though the catalytic converter was damaged due to a combination of the engine problem/defect and the testing and installation work performed by the dealer. I reached out to the dealer and GMC and they refused to address the issue and would not provide an itemized estimate to replace the catalytic converter and refused to return my phone calls I made to both the Service Adviser and Service Manager. The GMC representative I spoke to refused to address the issue as well.

The transmission is shaky, Lower gears the truck seems to fight it way into the next gear, I feel this is happening around 3 to 5 gears. One garage told me the power converter was failing. I changed the transmission fluid and filter and it got better, but sill, this is an expensive truck. This is power train, this should be covered to 100,000 miles.