2026 GMC YUKON Complaints

On July 30th 2026, I was Driving on the highway at about 75 miles per hour and the engine shut down. We were fortunate that we could pull over to the side of the highway. We had the truck towed to Oxendale gmc. Today 8/4/26 I was informed that in fact the engine needs to be replace. No warnings no symptoms, the truck just shut down while driving.

The contact owns a 2026 GMC Yukon. The contact stated that while driving 55 MPH and depressing the accelerator pedal, the vehicle failed to respond as intended. The contact pulled over to the side of the road, turned off and restarted the vehicle; however, the failure persisted. A dealer was contacted. The vehicle was towed to the dealer to be diagnosed, and the contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and informed the contact that there was a wait for the replacement engine. The approximate failure mileage was 3,788.

The vehicle was parked and turned off for approximately 45 minutes on a residential street along the curb in front of a house when the rear window suddenly shattered. I was inside a nearby house at the time. A landscaper working in the area reported hearing a single loud pop and then my vehicle’s alarm sounding. He stated he was not close to the vehicle and did not see any object strike it. When I inspected the Yukon, the entire rear window had exploded outward and inward, leaving no glass remaining in place. Glass was scattered both inside the cargo area and outside behind the vehicle. The upper liftgate section had also popped open, which is consistent with the sudden pressure release that occurs during spontaneous tempered-glass failure. There are no impact marks, dents, or paint damage that would indicate a rock strike or external force. Given the circumstances, the debris pattern, and the absence of an impact point, this appears to be a spontaneous failure of the tempered liftgate glass, likely due to internal stress or a manufacturing defect. I am requesting that the dealership inspect the liftgate assembly, confirm the cause, and consider warranty coverage for the glass replacement and any related components.

The large central infotainment touchscreen (which controls climate control/AC, navigation/maps, audio, backup camera, and all primary vehicle functions) has repeatedly failed by going completely dark/blank without warning on my 2026 GMC Yukon Denali XL purchased new on [XXX]. The screen has gone dark on three separate occasions. First failure occurred prior to [XXX]; vehicle was taken to Champion GMC (7885 W Grand River Rd, Brighton, MI 48114) for repair and returned to me. The screen failed again shortly after. Second repair attempt was made on 06/22/2026; vehicle was returned and the screen failed again immediately. The vehicle is currently at Champion GMC for a third repair attempt as of 06/29/2026. Safety risk: Loss of the screen eliminates access to the backup/rearview camera, speedometer display, climate controls (heat and AC), navigation, and warning indicators — all while operating the vehicle. There is no warning, message, or dashboard indicator prior to each failure. The screen goes dark suddenly and without notice. The problem has been confirmed and repair attempted three times by Champion GMC. The vehicle has not been inspected by police or insurance representatives. The component is available for inspection upon request, as the vehicle is currently at the dealership INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The center screen (infotainment), which shows controls for cabin climate (A/C, heat) and many more functions of the vehicle fails to turn on at random times. It is available for inspection. The external air temperature is in the upper 90s; temperature inside the car’s cabin is easily 115 or higher. This makes safe operation of the car not possible. Additionally passengers cannot occupy the vehicle safely at these extreme temperatures. The problem has been reproduced by dealers. UNKNOWN whether the components have been inspected by the manufacturer. No warning lamps or lights.

Engine failed at 12, 430 miles. Dealer said it required a new engine. This happened on 06/06/2026 and I am still without my very expensive vehicle. There were no wanring lamps or other engine failure notificatioins before this occurred.

**Incident / vehicle info:** - **Year / Make / Model:** 2026 / GMC / Yukon (Elevation) - **Date incident began:** ~mid-March 2026 - **Odometer / mileage:** under 1,000 - **Component:** Back Over Prevention: Rearview Camera (and/or Electrical System / Visibility) - **Crash? Fire? Injuries? Deaths?** No / No / No / No - **Vehicle still owned:** Yes - **Dealer or manufacturer contacted?** Yes — servicing dealer Rick Hendrick City Chevrolet (Charlotte); GM Customer Care cases 101763052 and 102071761 - **Description (paste this — ~1,700 characters, under the ~2,000 limit):** My 2026 GMC Yukon Elevation experiences intermittent total failure of the center infotainment/display screen, beginning around mid-March 2026. The failure is heat-related and intermittent: the screen functions on cool days, and on hot days it fails the vast majority of the time, unpredictably, after the vehicle heat-soaks in the sun. When it fails, the entire screen goes dark and I lose the backup camera and surround-view cameras, all HVAC/climate controls, audio, navigation, and most secondary controls. Steering, brakes, and engine are unaffected. This creates two safety hazards. First, loss of the rearview camera image eliminates rear visibility when backing — the exact risk FMVSS 111 is intended to prevent — raising the chance of a backover crash. Second, loss of all climate control in extreme heat endangers occupants in North Carolina summer temperatures, and a blank, unresponsive screen is a driver distraction. Here's everything in copy-paste form for the NHTSA complaint. **VIN:** 1GKS2BKD1TR227930 **Incident / vehicle info:** - **Year / Make / Model:** 2026 / GMC / Yukon (Elevation) - **Date incident began:** ~mid-March 2026 - **Odometer / mileage:** under 1,000 - **Component:** Back Over Prevention: Rearview Camera (and/or Electrical System / Visibility) - **Crash? Fire? Injuries? Deaths?** No / No / No / No - **Vehicle still owned:** Yes - **Dealer or manufacturer contacted?** Yes —

I lost all sound on my 2026 GMC Yukon XL with only 150 miles on it. Apparently this is a common issue that needs a recall.

While operating the vehicle, I began to hear a metallic grinding noise originating from the center of the engine compartment. The sound was clearly audible within the cabin. Approximately one mile before the vehicle ultimately failed, the engine began to malfunction. As I slowed to a stoplight, the vehicle started to shake before shutting off abruptly and entering a coasting state. All electrical systems powered down and the vehicle would not restart. Shortly thereafter, heavy smoke began to emit both inside and outside the cabin, visibly coming from the hood and through the air vents. There was also a distinct burning odor. I attempted to restart the vehicle multiple times without success. The dashboard displayed the message: “conditions not suitable to shift.” Due to the vehicle becoming disabled on a curve and posing a safety hazard, I contacted the Sheriff’s Office for assistance to prevent a potential collision. Upon their arrival, it was noted that the engine compartment and hood area were exceptionally hot, particularly where the smoke was originating. The dealership has since confirmed they have also been unable to restart the vehicle. The vehicle has been inspected by the GMC dealer and is currently pending further evaluation by a GM-certified mechanic to determine the root cause. Prior to this incident, there were no warning lights, system messages, or other noticeable symptoms indicating an issue.

So the ultimate failure is from a catastrophically failed crankshaft journal thrust bearing. Which could be caused from one of two things: 1) The crankshaft thrust bearings they are putting in these motors are made with inferior materials, probably cheap Chinese crap or 2) The crankshaft end play tolerance was never set properly, giving the crankshaft the ability to move forward and backward in the engine more than it was designed to. Which will over time beat up on the thrust bearing until it fails. In either case it would result in the same progressive issue showing itself. It will start as a squeak here and there. Which, as the soft thrust bearing material is unable to hold the proper oil film thickness for lubrication, will spiral into more and more heat being sent into the adjacent components, plus the buildup of metal particles being sent through the entire engine oiling system. Which will then start killing connecting rod and crankshaft bearings one by one. If the engine survived to this point, it’s now a ticking time bomb. It is either going to just seize up and not run anymore or the exciting route would be a connecting rod breaks and makes a window sized hole in the side of the engine block.