2013 HONDA ACCORD Complaints

1. Faulty vehicle stability assistance (VSA) and antilock braking system (ABS) Module. Common issue and reported by thousands of Accord Owners, Other models of same Honda generation have been recalled for same exact issue. Vehicle is available for inspection on request. 2. Faulty VSA module poses increased risk of “loss-of-traction” events that could result to injury or death on roads. Faulty ABS module poses a severe detriment to the braking system of a the vehicle, in some cases rendering the brake pedal unresponsive or locking the brakes, in turn increasing the risk of losing control of the vehicle that could result in injury or death. 3. Yes, multiple mechanics have diagnosed the vehicle and came to the same conclusion that it is a faulty VSA/ABS module. 4. No, manufacturer, police or insurance reps have not investigated. 5. Yes this issue is known to trigger every warning light on the dashboard to turn on at once. That is what happened on my vehicle.

Power steering issues: Stiff steering wheel that locks then becomes loose and causes loss of steering control. Deviation from the intended path of travel without warning or driver input. Constant veering to one side without driver input.

When overtaking a car on a one lane highway, the engine suddenly started to sputter and the steering felt unstable, and a few seconds later, four engine lights turned on (Malfunction Indicator Lamp, Vehicle Stability Assist System Indicator, Electric Power Steering System Indicator, Low Tire Pressure/TPMS Indicator). I was able to drive the car to an auto shop, where their mechanics did a diagnosis and found codes P0087, 83-11, 61-11, 85-01. While cycling through the codes all lights turned off, so they advised that I could continue to drive the car as is. A few weeks later, the same problem happened when I was driving on the highway. This time, I could not push the car past 2500 RPM, rendering the car unable to exceed 55mph on the highway. I was able to drive the car to a Honda dealership. They diagnosed P0087 and P0088 codes, and followed the TSB recommendation to replace the high pressure fuel pump. After paying the hefty replacement fee and getting the new part, the car works as expected. Q1: High pressure fuel pump failed, Honda dealership did repair so they would have the old part if not already disposed. Q2: In first instance, car became unstable at high speeds. In second instance, had to drive two hours back to dealership near me on a highway going 20mph under speed limit. Also had to pull over on a narrow shoulder. Q3: Technicians reproduced problem when holding vehicle at 3000rpm. Found code P0087 and S/B 14-039 for that code, which recommended replacing the high pressure fuel pump. Q4: Component inspected by Honda dealership. Q5: Specific warning lamps and codes listed above.

ABS module failure. Lights up emergency brake, tire pressure warning, Electrical power steering, and Vehicle Stability Assist indicator. Did some research and the failure is caused by faulty soldering inside the ABS module.

I was stopped at a stop light. The light turned green and I started to go. My car had a major issue and was stuck in traffic. I had to push the vehicle out of traffic with the assistance of the Police Department. My vehicle was not operable. After an investigation into the issue, the Driver front axle broke in in half. No lights or prior indicators existed before the incident. Repairs have been made and this issue has caused damage to the other axle. Both have been replaced by authorized repair shops. I continue to have a “wobbling” issue while accelerating. I did go to a Honda dealership for the balance issue. They did say it is common for the axle to break and there was a recall for my Make/ Model and Year that I did not qualify for. Paperwork is attached. I have children and if my children were in my vehicle with me and I was on the highway this incident could have led to serious physical injury or death. There is a current recall which my vehicle doesn’t apply for. I believe my vehicle should apply. A news article from Honda shown to me by a Honda Dealership rep is attached as well as invoices.

The ABS system went out. All the lights in the dashboard is on. The module was on back order for months and it’s cost $2500. Why should I have to pay for a faulty electrical system that my actions had no bearing on?

The contact owns a 2013 Honda Accord. The contact stated while driving approximately 50 MPH and slowing to exit the highway, the steering wheel was turned to the right and seized. The contact pulled over and stopped the vehicle. The vehicle was turned off and restarted several times however, the power steering feature was inoperable. The vehicle was towed to a dealer who diagnosed the vehicle and determined that the EPS torque sensor had failed and needed to be replaced. The contact researched online and related the failure to Technical Service Bulletin: 15-056 EPS Torque Sensor (Steering). The contact had spoken to the dealer and to the manufacturer but was informed that the vehicle was no longer covered under warranty. The vehicle was not repaired. The failure mileage was 115,008.

The ABS module failure has caused all my dash boards lights to remain on making the lan assist and calibration impossible to complete. This needs to be investigated for all Honda accords from 2012 - 2018. I have had several mechanics say this should be recalled due to its occurrence. The other issue is the timing belt slips without any wrecks due to being poorly built.

Car started to show FWC lights, LDW lights, steering warning, Traction control. Inspected by two mechanics and say the codes come back to ABS module defect.

Component VSA ANTI LOCK ABS PUMP MODULATOR 57110-T2F-A1 malfunction. Circuit board wiring inside of modulator has loose/dismantled wires causing complete failure of ABS system for vehicle. This is a widely know problem amongst 9th generation Honda Accords and Honda has yet to issue a recall here in the United States.