2013 HONDA ACCORD Complaints

ABS module failure on 2013 Honda Accord. FCW system failure, ABS failure, LDW failure along with brake light constantly on, also tire pressure sensor light on. Brakes have a softer feel when compressed. Diagnosed at independent repair shop as failure of the ABS module which is a circuit board issue with improperly soldered wire connections, something Honda should cover as the module dealer cost is about $3000 plus labor. Brake sensitivity and possible failure is a major concern and the vehicle is at only 116K miles.

The contact owns a 2013 Honda Accord. The contact stated that while attempting to complete a left turn, the vehicle inadvertently lost motive power. The contact was able to coast into a nearby parking lot, where the failure persisted. No warning lights were illuminated. The vehicle was towed to an independent mechanic and was diagnosed with failures with the driveshaft and steering gearbox. The driveshaft was repaired at that time. The contact stated that while leaving the independent mechanic at an undisclosed speed, the vehicle suddenly veered to the left, prompting the contact to immediately return the vehicle to the independent mechanic. The contact was advised to take the vehicle to the dealer for assistance. The vehicle was taken to the dealer, who diagnosed a failure with the steering gearbox. The vehicle was not repaired. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 160,000.

Dash board lights indicated ABS system module malfunction, per Illinois Honda dealership diagnosis. ABS module failure also causes failure of forward collision warning system and lane departure warning system.

VSA Modulator failed at 106 thousand miles, replaced at dealer and it failed again after 15 thousand miles. Honda did not take any responsibility as the milage had exceeded the 12k miles warranty. They charged an additional $4,000 to repair.

In the past 2–3 months, multiple door lock actuators/latches on my 2013 Honda Accord have failed. Both rear doors will not reliably lock or unlock, and the front driver door actuator is intermittent. This means that three of the four doors cannot be secured or opened normally. This is a serious safety and security issue. The car cannot be locked to prevent theft or unauthorized entry. Children or passengers in the rear may not be able to exit safely in an emergency. I am also concerned that the failure could compromise crash safety if doors cannot be unlocked quickly after a collision. Performance Kings Honda (Cincinnati, OH) inspected the vehicle, confirmed the failures, and diagnosed both rear door latch/actuator assemblies as faulty. They provided an estimate of $1,000+ for repairs. I have an open case with American Honda. Honda acknowledges there is no recall, but this appears to be a systemic defect rather than normal wear, since multiple actuators have failed simultaneously. There were no warning lights or messages. The issue developed gradually, starting with difficulty locking/unlocking one door, followed by failure of the others. The vehicle remains available for inspection at the Honda dealership.

I was driving and all of a sudden my steering wheel started steering on its own quickly to the right and it was very difficult to keep control of the steering wheel couldn’t keep control and car was going against traffic and merging into other vehicles. When I finally came to a stop the steering wheel still moved on its own. The vehicle is available for inspection upon request. The safety of myself and my children is at risk while driving the car, it could cause major damage to other vehicles and structures and harm to us. The problem was inspected by Honda dealer and advised there is an extended warranty on EPS and confirmed that the EPS malfunction and needs to be replaced, but was advised that American Honda will not honor the warranty because there are no system codes coming up, there where no warnings, lights on dash, noises or anything indicating EPS failure. Car has always been taken for maintenance and repairs at a certified Honda dealer, American Honda will not take responsibility for the dangerous and deadly malfunction.

The contact owns a 2013 Honda Accord. The contact received an NHTSA recall email alert for NHTSA Campaign Number: 25V422000 (POWER TRAIN). After contacting the dealer, who confirmed the VIN inclusion in the recall, an appointment was scheduled. The vehicle was taken to the dealer for the recall repair; however, upon inspection, the dealer determined that the driveshaft did not require replacement. The contact disagreed with the assessment, stating that the driveshaft was visibly corroded. The contact had taken pictures both before and after the appointment. Despite waiting at the dealer for over two hours, no work was performed on the vehicle. The contact notified the manufacturer about the decision of the dealer not to replace the driveshaft. The manufacturer opened a case and stated that a regional technician would be contacted. The contact sent photos to the manufacturer's case associate, who then communicated with both the dealer and the regional technician and confirmed the dealer's initial assessment that the driveshaft did not need to be replaced. The failure mileage was 53,456.

See attached document for complaint. I took my 2013 Honda Accord in to my Honda Dealership due to leakage. I was informed the leak was in the intermediate drive shaft that was not under recall. Part Number: H,44500-T2A-A00 (Shaft Assy) Part Total : $871.38 I researched Honda recalls and found an article dated December15, 2020 that Honda was conducting 2 drive shaft recalls for 2013-2015 Honda Accords in 22 states where salt is used to clear roads during the winter. This included Michigan. The article (enclosed) stated the drive shafts can break due to corrosion and the right and left drive shafts were to be replaced. I did not receive any recall notice for this drive shaft problem until I took my car in for a leak inspection and I was then verbally informed of a drive shaft recall.

I have been having problems with many dashboard lights coming on at once. I got it checked out and I got ABS code 123 - 11 and code 81 - 20. This has been going on since the beginning of August 2025. This could lead to dangerous malfunctions, And is one of the most expensive things to repair. It is my understanding that many many vehicles between 2013 and 2017 in the Honda range I've been experiencing this to the point of where we need a recall.

To: National Highway Traffic Safety Administration (NHTSA) I am writing to formally submit a safety complaint regarding a serious issue I have encountered with the Anti-lock Braking System (ABS) manifold on my 2013 Honda Accord EX-L. This issue raises significant safety concerns and may warrant investigation for a potential recall. Recently, I experienced a failure in the ABS system that resulted in warning lights illuminating on the dashboard. Upon diagnostic inspection, it was confirmed that the ABS manifold (also referred to as the ABS modulator or hydraulic unit) had malfunctioned. This failure compromised the vehicle’s ability to maintain braking stability during emergency or slippery-road conditions. I understand that ABS systems are critical for preventing wheel lockup and maintaining vehicle control during braking. The failure of such a key component can severely increase the risk of a crash, especially under adverse driving conditions. Additional Concerns: This appears to be a known issue based on numerous similar complaints reported online by other 2013 - 2017 Honda owners. The cost of repair is substantial, with replacement estimates exceeding $1,500–$2,000. Despite the safety implications, Honda has not issued a recall or technical service bulletin to address this widespread problem. I respectfully request that NHTSA investigate whether this issue represents a systemic safety defect in the 2013 Honda Accord EX-L. The failure of a core safety system such as ABS warrants a thorough review to determine whether regulatory action or a manufacturer recall is appropriate. Thank you for your attention to this matter.