2012 HYUNDAI VELOSTER Complaints

Over the last year, I’ve had to purchase three air conditioner switches after driving for several years with it being out the first one we replaced caused a small electrical fire as did all of the others. This has been an ongoing issue not just with my car, but my sister‘s in-laws who is a 2014 model I looked online. It has been reported over the years basically since the cars come out of this same issue can you please Issue a safety recall before somebody’s house or vehicle or both catches fire completely. This is not safe at all. I have already put in a request for the safety recall on several other occasions this is unacceptable unsafe and a very large problem across the United States since this vehicle has come out please do something.

The Hvac Temperature Control Unit has faulty wiring and plastic dials to where the wiring over heats and melts the Hvac control unit . Multiple complaints on this and nothing has been done . My wiring has melted completely and is a FIRE HAZARD

The car was in Hyundai dealership for 35 days to have a recalls fixed - still showing as no remedy for ABS systems and they said they fixed it ? they had me pick up the car? And but the recall still shows no remedy ? I’m not sure it’s fixed ? and 2 weeks later the transmission goes out while I’m driving again and lose control over the vehicle and stuck on side of road had And Hyundai dealership proceeded to only be concerned on who’s paying for the diagnosis who has been the one fixing the vehicle and I have an extended warranty with Car Max. Car max sold me a car that had rusted brakes and brake lines and several recalls and now the transmission went out . I have expressed to Hyundai and Carmax - The car is not safe .

While driving and trying to travel in a straight line the steering wheel would bind snd stick while trying make slight corrections. This would cause the vehicle to constantly swerve from side to side. The Hyundai dealer (Classic Hyundai) misdiagnosed the problem and claimed the car needed new strut bearings. An independent consultant found it was caused by an open ball bearing on the steering shaft just under the steering wheel. The bearing did not have proper dust seals and therefore allowed dirt to enter rolling race area cause the binding. This is a Hyundai design fault and should have be subject to a recall.

In Dec of last year my cars dash lights started flashing no matter which gear I tried the gear would flash on the dash,when I called my extended warranty "car shield ",they recommended that I take it to a repair shop in nearby city and have a diagnostic test performed. I did so,in which after testing they said it was something on side of transmission and they weren't equipped to perform the repairs and needed to be taken to dealership instead. I picked up the vehicle and same issue was present of course, so I had it towed to a dealership and then was contacted by them that they could not do a diagnostic test until the battery was replaced because it was not starting, so I brought a battery and put it on in the place of my old one.I made sure that the vehicle was going to start before leaving and it did with no problem, so I turned it off and was contacted by the dealership saying that it was extensive damage, and car shield had to send out their own personal investigator and they refused to fix any issues and would not pay for diagnostic services or the $10,000 to cover the repairs due to unknown circumstances causing the fuse box next to battery to melt as well as damage to my wiring harness and the wiring harness for the alternator somehow. Now I have a vehicle that I paid for less than a year ago and a no good extended warranty paid for as well and a vehicle with less than 100000 miles that's useless.

The contact owns a 2012 Hyundai Veloster. The contact stated that while driving at approximately 15 MPH, the gear shift indicator located on the instrument panel started flashing. The contact stated that the vehicle failed to shift into gear and failed to remain in drive(D) as intended. The vehicle was steered to the side of the road and parked. The vehicle was towed to a dealer, where it was diagnosed that the fuse panel, the transmission, and the alternator wiring harnesses had melted and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 99,000.

The contact owns a 2012 Hyundai Veloster. The contact received notification of NHTSA Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

Since the make of this car and it’s further year generations people can complained about the a/c control switch burning out and actually it melts the inside of the part. Upon replacing it will short out again and again. So my people have called Hyundai over this issue and they 22 years after my car was made still have not issued a recall. Please someone do something about this!!!PLEASE!!! They don’t sell a replacement part and Hyundai is making 200+ just for the part they “need” to replace (whole unit) for a $5 part of the unit. As someone who lives in AZ it can be fatal to not have A/C. Additionally the stearing controls have also shorted out. This while card electronics are a hazard and a money pit!

The contact owns a 2012 Hyundai Veloster. The contact stated that while driving at approximately 30 MPH, the vehicle lost motive power. No warning light was illuminated. The vehicle was able to be restarted. The vehicle was taken to AutoZone, where it was diagnosed with transmission failure, glow relay short circuit, and ABS failure. The vehicle was then taken to an independent mechanic, where it was diagnosed that the engine needed to be replaced. The dealer was made aware of the failure. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was 128,220.

Brakes catastrophic failure due to brake line corrosion. Complete lose of fluid and pressure. The undercoating was not done right or possibly at all so road salts ate through the lines. All lines replaced at a cost of roughly $2000.00. This is already a recall in Canada so like do something about it.