2013 HYUNDAI VELOSTER Complaints

View complaints related to 2013 HYUNDAI VELOSTER. The complaints found here are submitted by actual consumers with first hand experience. There are more than 400 complaints submitted for the 2013 HYUNDAI VELOSTER. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.

  • 2013 HYUNDAI VELOSTER
    - Humacao, PR

    Car started smoking on cabin while driving. Risk of hazard dueto bad A/C control switch. Wiring harness and plug melted too. Several Hyundai Veloster are suffering same issue. Started to think blower wiring is to small for load too. Pleaae see attached pictures. Time and miles provided is an approximate. Do not remember when exactly happened but was reported previously. In the pictures you are going to be able to see the faulty part P/N for your review.

    Source: NHTSA WEB SITE
  • 2013 HYUNDAI VELOSTER
    - Enfield, CT

    The contact owns a 2013 Hyundai Veloster. The contact stated while driving 45 MPH, the vehicle lost motive power and the check engine warning light illuminated. The contact depressed the brake pedal and the vehicle started to shake. The contact stated that after shifting into gear the vehicle became difficult to drive. The vehicle was taken to an independent mechanic, where the vehicle was diagnosed with a passenger’s air bag fault. The dealer was made aware of the failure. The manufacturer was made aware of the failure and a case was opened. The failure mileage was approximately 172,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2013 HYUNDAI VELOSTER
    - Mesa, AZ

    The air conditioner knob doesn't work when I put it at 4. Took it apart and the wires are burn including the pigtail that holds the wires into the knob.

    Source: NHTSA WEB SITE
  • 2013 HYUNDAI VELOSTER
    - Albuquerque , NM

    On October 17, 2024, owner was leaving Denver, CO on the highway and had to stop for traffic and vehicle wouldn't move. Was in drive but vehicle would not drive and pulled to side of road. Had insurance tow to nearest Hyundai dealership. Check engine light was on and dealership checked vehicle and needed to have the crankshaft position sensor replaced. Fixed the problem thank God and I was on my road shortly there after. My Veloster is 2013 with 47,000 miles at time of incident.

    Source: NHTSA WEB SITE
  • 2013 HYUNDAI VELOSTER
    - Henderson, NV

    The contact owns a 2013 Hyundai Veloster. The contact stated that while his wife was driving at an undisclosed speed, she heard an abnormal clicking sound emanating from the front of the vehicle, after which she became aware that there was excessive left and right play in the steering wheel. No warning lights were illuminated. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The manufacturer was notified of the failure but did not assist. The failure mileage was 67,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2013 HYUNDAI VELOSTER
    - Canal Winchester, OH

    The contact's god-daughter owns a 2013 Hyundai Veloster. The contact stated that the ABS warning light and other unknown warning lights were illuminated. The vehicle was taken to the dealer, where the recall repair of NHTSA Campaign Number: 23V651000(Service Brakes, Hydraulic) was performed; however, the failure persisted. The contact stated that while inspecting the vehicle at the residence, the contact noticed that the ABS fuse was blown. The contact replaced the ABS fuse; however, the ABS motor made an abnormal whining and humming sound. The ABS motor then blew up and caught on fire. The contact stated that he was able to extinguish the 12 inch high flames with a bottle of water. The vehicle was towed to the dealer, where it was determined that the ABS unit and the wiring harness needed to be replaced. The vehicle was not repaired. The contact stated that the recall remedy failed to fix the failure. The manufacturer was notified of the failure and a case was opened; however, the manufacturer later sent a letter to the contact advising that the claim was denied. The failure mileage was approximately 87,700.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2013 HYUNDAI VELOSTER
    - St. Petersburg, FL

    A connecting rod bearing failed in the engine leading to catastrophic engine failure with the connecting rod breaking through the wall of the engine block causing a hole and undriveable vehicle. According to my research, this issue has been recalled in adjacent model years (2015-2016) but not in my model year (2013) that has the same engine. This issue has already been confirmed in these engines, but Hyundai states my car is not included in the recall. This was a safety risk because the engine failure breached the engine wall which could have ignited engine oil and caused a fire. The engine may have also failed at a critical driving moment when acceleration was needed and stranded the car in an unsafe position. Yes, the problem was reproduced at the dealer's service center because the failure occurred while they were test driving my vehicle. Since the service center tech was the one driving the car when the incident occured, I do not know if there was a fire or not and the speed they were traveling, etc. The vehicle has been inspected by the dealer service center and confirmed that this is the issue that caused the problem. The dealer even suspected this was going to happen as they had foreknowledge of the issue occurring on other vehicles that had already been recalled for this issue. The only prior warning of this issue is that I had some misfires on the engine a few days before which is what prompted me to bring it in for service. The misfires temporarily illuminated the "check engine" light but then the light went back out again. I had no idea this minor issue would result in such a severe, catastrophic failure.

    Source: NHTSA WEB SITE
  • 2013 HYUNDAI VELOSTER
    - Apex, NC

    On going issue since 2016 with the failure of the rubber coupling in the motor driven power steering (MDPS) assembly. Loose steering, knocking noise, worsening overtime. Known issue with the Hyundai Elantra and recall issued for the same part and issue on the Elantra. But not for the Veloster, service department acknowledged identical part usage in Veloster and MDPS assembly is failing in the Veloster with same safety issues. But since no recall have been issued full cost of replacement passed to consumer. $5 dollar rubber coupler, +$500 labor.

    Source: NHTSA WEB SITE
  • 2013 HYUNDAI VELOSTER
    - Gainesville, FL

    One night I was driving on the highway and my check engine light came on. At first I thought it was weird because I had just gotten the car from a dealership three weeks prior. I pulled into a gas station and checked my oil which was low so I added some oil that I had bought. As I was driving home the car suddenly developed a tick and started to lose power. The turbo stopped working. I was pretty concerned about this so the next morning I decided to top off the oil and I decided to take the car into a shop. The first shop heard the engine knock and told me that my crankshaft might be going bad but I wanted a second opinion so I took it to a trusted shop who heard the engine knock and told me the engine would need to be replaced. I called the warranty company and they inspected it at the shop and said the engine would need to be torn down for diagnosis. I had to agree to pay for the shop to tear down the engine if it would not be covered. The shop found metal shavings in the oil pan. Once the engine was apart, they said that the rod bearing was bad. The car and engine are available for inspection.

    Source: NHTSA WEB SITE
  • 2013 HYUNDAI VELOSTER
    - EL CAJON, CA

    Car hit 100k miles engine is knocking and mechanic says engine is blown. Researched the issue and found many other people having same issue. Hyundai issued a recall for this year's veloster but is saying my car does not fall under the category even though it is one of the issued problems with vehicle

    Source: NHTSA WEB SITE