2000 JEEP GRAND CHEROKEE Complaints

I OWN A 2000 JEEP GRAND CHEROKEE, OVER THE PAST 6 MONTHS IT WILL JUST SHUTDOWN GOING DOWN THE HIGHWAY. IT DOES NOT MATTER WHAT SPEED OR EVEN IF YOU ARE SITTING AT A RED LIGHT. JEEP DEALERSHIP REPLACED THE CRANK SENSOR AND SAID THAT WAS MY PROBLEM. IT SHUTDOWN AGAIN ON THE WAY HOME FROM THE DEALERSHIP. I RETURNED WITH THE JEEP AND ALL THEY COULD TELL ME WAS THEY DON'T KNOW WHAT THE PROBLEM IS. MY JEEP WILL ACT LIKE IT HAS LOST ALL ELECTRICAL TO IT, ALL THE GAUGES WILL FALL TO THE LEFT. AFTER YOU TURN IF OFF SOMETIMES IT WILL RESTART AND OTHER TIMES YOU HAVE TO SIT THERE FROM ANYWHERE TO 5-15 MINUTES. *TR

TL* THE CONTACT OWNS A 2000 JEEP GRAND CHEROKEE. WHILE DRIVING APPROXIMATELY 40 MPH, THERE WAS A SLIGHT EXPLOSION SOUND. THE CONTACT MOVED THE VEHICLE FROM THE ROADWAY AND FOUND THAT THE FAN BLADE, RADIATOR AND OTHER UNDER HOOD COMPONENTS WERE BROKEN. THE VEHICLE WAS TOWED TO THE DEALER IN WHICH THE VEHICLE WAS PURCHASED. THE DEALER REPLACED THE FAN BLADE, RADIATOR, HOSES AND CONNECTORS. THE CONTACT WAS ABLE TO LOCATE NHTSA CAMPAIGN ID NUMBER: 06V199000 (ENGINE AND ENGINE COOLING: COOLING SYSTEM: FAN) AND WHEN CONTACTING THE MANUFACTURER, HE WAS TOLD HIS VIN WAS NOT INCLUDED IN THE RECALL. THE FAILURE MILEAGE WAS 140,000 AND THE CURRENT MILEAGE 141,000.

2000 JEEP GRAND CHEROKEE REAR BRAKE LIGHTS OUT BECAUSE OF DEFECTIVE DESIGN. BRAKE LIGHTS STOP WORKING WHEN HEADLIGHTS TURNED ON. BRAKE LIGHTS WORK FINE WHEN HEADLIGHTS OFF. PROBLEM DESIGN IS IN THE TAIL LIGHT ASSEMBLY. WHEN YOU REMOVE THE LIGHT SOCKET FOR THE TAIL/BRAKE LIGHT IN THE LIGHT ASSEMBLY, YOU WILL SEE 3 SILVER CONTACT POINTS INSIDE THE BLACK PLASTIC RING. TWO ARE GROUPED TOGETHER AND THERE IS ONE THAT IS OPPOSITE OF THE TWO. THE ONE BY ITSELF IS THE GROUND; THE OTHER TWO ARE THE CONTACTS FOR THE TAIL LIGHT AND BRAKE LIGHT. THE PROBLEM LIES WITH THE GROUND CONNECTOR. YOU SHOULD NOTICE THAT THE GROUND CONTACT IS DEPRESSED INTO THE PLASTIC AND THE PLASTIC ITSELF IS SLIGHTLY WARPED DOWN. MOST CARS HAVE LIGHT SOCKETS WITH THEIR WIRING ATTACHED. THE SOCKET TWISTS INTO THE LAMP ASSEMBLY. ON THE GRAND CHEROKEE, THE SOCKET DOES NOT HAVE THE WIRING ATTACHED. INSTEAD, THE WIRING GOES INTO THE LAMP ASSEMBLY AND THE SOCKET HAS THREE ELECTRICAL CONTACTS THAT, WHEN TWISTED INTO THE ASSEMBLY, WILL MAKE THE CONTACT. WHAT SEEMS TO BE THE MOST FREQUENT MALFUNCTION IS THAT THE ELECTRICAL CONTACTS (WHICH MAKE CONTACT WITH THEIR RESPECTIVE ELECTRICAL PATHS WHEN THEY ARE INSERTED INTO THE ASSEMBLY) ARE PRESSED TIGHT TO ENSURE GOOD CONTACT WITH THE ASSEMBLY...AND ON MANY TAILLIGHTS, THE PLASTIC RING CONTAINING THE RESPECTIVE PATHS OFTEN BEGINS TO SEPARATE FROM THE FATIGUE OF THE CONTACTS PRESSING SO HARD. OF THE THREE CONTACTS (REAR TAIL LIGHT, REAR BRAKE LIGHT AND GROUND), THE GROUND IS WHAT MOST COMMONLY LOSES ITS CONTACT DUE TO FATIGUE CRACKING. THIS IS A SERIOUS SAFETY ISSUE BECAUSE OFTEN DRIVERS ARE UNAWARE THAT THERE IS A PROBLEM. IT ONLY HAPPENS WHEN THE HEADLAMPS ARE ON, SO IF CHECKED IN DAYLIGHT, THE PROBLEM OFTEN GOES UNDETECTED. ONLY WHEN ANOTHER DRIVER OR THE POLICE POINT IT OUT DOES IT LOOKED AT. THIS IS A WIDESPREAD PROBLEM THAT OCCURS FOR NEARLY EVERY 2000 JEEP GRAND CHEROKEE. IT IS NOT AN ISSUE OF WILL IT HAPPEN, RATHER WHEN IS IT GOING TO HAPPEN! *TR

FRONT DRIVER-SIDE WINDOW DRIVE ACTUATOR BROKE FOR THE SECOND TIME. WINDOW WON'T STAY UP AND WILL NOT MOVE UP OR DOWN. HAD TO HAVE THE WHOLE WINDOW MOTOR REPLACED AT A COST OF $500.00. THE WINDOW DRIVE ACTUATOR IS PLASTIC AND APPARENTLY BREAKS FREQUENTLY. THIS APPEARS TO BE DESIGNED TO FAIL. THIS IS A DEFECT AND SHOULD BE RECALLED. *TR

2000 JEEP GRAND CHEROKEE LAREDO. FRONT DRIVER-SIDE SEAT FRAME BROKE AT THE LOWER LEFT FRONT BASE LEG. HAD TO BE WELDED. *TR

THE WELD ON MY SET IN MY 2000 GRAND CHEROKEE BROKE LOOSE WHILE DRIVING. ALL WELDS ARE CURRENTLY BROKEN EXCEPT FOR ONE. SEAT HAS NOT BEEN REPLACED BECAUSE REPLACEMENT PARTS ARE HARD TO FIND. *TR

2000 JEEP GRAND CHEROKEE LAREDO. FRONT DRIVER'S SEAT STARTED TO WOBBLE/ROCK AND THEN BROKE. A WELDER FRIEND TRIED TO BRAZE IT BACK TOGETHER, HELD FOR 2 DAYS BROKE AGAIN. OFF TO JUNKYARD TO FIND WHOLE NEW SEAT. LOOKING ONLINE THIS IS A WIDE-SPREAD PROBLEM. AN OBVIOUS DEFECT AND SHOULD BE RECALLED. DEALERSHIP WANTS $800-1000 TO FIX. *TR

2000 JEEP GRAND CHEROKEE DRIVER SEAT JUST NORMAL DRIVING THE SEAT BROKE CAUSES EXTREME BACK PAIN. BREAKS CONSTANTLY IN 4 DIFFERENT AREAS FIRST BREAK WAS A BRACKET. HAVE WELDED THE PARTS MULTIPLE TIMES. *TR

2000 JEEP GRAND CHEROKEE - HEATER CORE LEAKAGE LED US TO TAKE UP CARPET - BOTH DRIVER'S SIDE AND PASSENGER SIDE HOLES IN THE FRAME WHICH HOLD THE SEATS DOWN TO THE BODY, WERE RUSTED THROUGH. CAUSE - WATER TRAP (DESIGN FLAW) IN DESIGN OF THE UNIBODY, AND NO UNDERCOATING TO HELP PREVENT SUCH OCCURRENCE. FRAME METAL IS APPROX. 1/8TH INCH THICK. AREAS AFFECTED WERE CUT OUT AND NEW METAL WELDED IN (BY PRIVATE PARTY - NOT DEALER. I DO HAVE THE PIECES WHICH WERE CUT OUT.) SHOULD THERE HAVE BEEN A COLLISION, THE SEATS WOULD HAVE BROKEN LOOSE FROM THE FRAME AND SERIOUS INJURIES WOULD HAVE OCCURRED. OTHER COMMENTS MADE ON THIS SAME VEHICLE, TO INCLUDE OURS, RELATE HOW THE ACTUAL SEAT FRAME BREAKS. METAL FOUND WHEN THIS OCCURRED IS WEAKENED - NOT RE-ENFORCED TO PREVENT BREAKAGE. *TR

2000 JEEP GRAND CHEROKEE LARADO, 105,000 MILES. JEEP DOOR LOCKING ACTUATORS HAVE BEEN REPLACED 3 TIMES ON ONE DOOR, AND IT JUST WENT AGAIN. IN ADDITION TO ANOTHER DOOR ACTUATOR HAVING TO BE REPLACED AS WELL. ACCORDING TO THE INTERNET FORUMS FOR JEEPS, THIS IS A KNOWN ISSUE AND THERE ARE LITERALLY THOUSANDS OF COMPLAINTS FOR THIS SAME ISSUE ON THE SAME MAKE AND MODEL OF JEEP. *TR