2022 JEEP GRAND CHEROKEE 4XE Complaints

left front clunking, knocking after driving for about 30-45 mins and temperature above 70 degrees (F). this happens when driving from small or large bumps on the road. after a three hour interstate the noise was almost constant. i have three recordings while driving of the sound.

The contact owns a 2022 Jeep Grand Cherokee. The contact received notification of the NHTSA Campaign Number: 23V413000 (Suspension) however, the part to do the recall repair was not yet available. The dealer was contacted and confirmed that parts were not available for the recall repair. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

Unknown, The Jeep designed as to not be able to be put in drive with a door ajar. Twice now pulling out of parking lots, while driving the vehicle has disabled itself, put it inself in park stating a door was left open. I'm alright with a vehicle not allowing an operator to leave park while a door is open but it shouldn't be able to disable the vehicle while turning on to a busy street once moving.

The contact owns a 2022 Jeep Grand Cherokee. The contact received notification of NHTSA Campaign Number: 23V413000 (Suspension) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that when the vehicle was taken to the dealer, the contact was informed that the driver’s side rear coil spring was defective. The dealer was made aware of the failure but confirmed that parts were not yet available. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 16,103. Parts distribution disconnect.

After starting 2022 Jeep Grand Cherokee 4Xe, multiple warnings displayed on dash including: service power steering, service electronic stability control, blind spot alert unavailable service required, and rear braking assist unavailable. The ignition was fully turned on and after shifting into reverse, there was no power steering which required extra effort to turn the steering wheel. The power steering was out for approximately 20 minutes. After restarting the car 20 minutes later, the power steering and blind spot alert was back. A check engine light persisted. After taking to Auto Zone to read check engine light, there was no readable code. The warnings have since went away. The vehicle had 2,497 miles on it at the time of this occurrence which was on June 9, 2023 at 10:18 am.

Purchased 1 Feb 23. 3 weeks later, I pulled out of driveway and drove 3 blocks before coming to stop sign, After stopping, I proceeded to pull across 4 lane hwy. Only to have vehicle shut off in middle of 2 lanes. I was left sitting broadside in middle of 2 lanes. I finally realized the drivers door was ajar, I closed door completely and was able to restart vehicle. It is Now June 2023 and it happened again after driving about 3 blocks. This time It shut off while I was driving 50 mph in middle of 2 lane hwy. Again drivers door was ajar. This is a serious safety hazzard. Vehicle is not supposed to move if door is not closed completely. There were no bells or lights warning you that door was not closed completely. Jeep Dearlership does not seem to think this is a major safety issue and did nothing to fix.

Turn signals are blinking at slow/abnormal rate after car was put into repair. Appears to have been after a software update. Multiple vehicle owners reporting same issue.

The issue only occurs when holding down a +/- button to move the speed control to a high/lower set-point greater than a one mph increment. When, after being held, the button is released at the desired new speed level, it continues to increase/decrease speed until the speed control is turned off, cancelled, or the brake is actuated. (The manual for this vehicle reinforces my understanding that releasing the held button, should stop the speed change and save a new speed level.) I have tested this, and it occurs every time and never stops accelerating until I turn off the speed control function. ( i have released this control at 35 mph and it continues to accelerate to greater than 90 mph and the new speed command is not recognized.) I can handle this now, but the first time it happened I froze temporarily and believe this issue to be very dangerous if it occurs with an unaware person at a critical time.

I was turning at a intersection, there was no car in-front only on the side , as I was turning , my jeep suddenly made an emergency beeping sound and break as if I was goin to crash into a car or something. Clearly I was just turning . The break was so hard I even thought I had gotten hit in the back or I had hit something in the front ! The car behind me had to stop and act fast as well otherwise I would have really been hit by him/her. I called my dealer since I had just bought my car 2weeks ago. I have a appt to get it look at , they told me it might be my sensor being dirty or something but I feel like this is a concern jeep should take care of. Or it will really cause an accident I don’t feel safe driving my jeep at all now! Especially doing turns or just thinking it might breaking when I am driving much faster next time. I’m taking my jeep to my dealer service dept. picture below are evidence of appts , and having to get a rental because of my report.

Dealer identified my concern with the noise the car is making as apart of the recall in the steering and no parts available to fix per dealer