2016 JEEP PATRIOT Complaints

The contact owns a 2016 Jeep Patriot. The contact stated that while driving at an undisclosed speed, the vehicle violently jerked while the transmission was changing gear. Additionally, while starting the vehicle, the RPM revved to 1,500 RPM before the vehicle shut off. The vehicle was taken to an independent mechanic, and the camshaft and crankshaft sensors were replaced; however, the failure persisted. The dealer was not notified of the failure. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 96,121.

The contact owns a 2016 Jeep Patriot. The contact stated that while driving at an undisclosed speed, the engine seized. No warning lights were illuminated. The vehicle was coasted to the shoulder of the road. While attempting to restart the vehicle, the vehicle failed to start. The vehicle was taken to the dealer, where it was diagnosed with a failed crankshaft position sensor. The contact was informed that the crankshaft position sensor needed to be replaced. The vehicle was not repaired. The failure had occurred several times. The contact stated that the vehicle was unsafe to drive. The manufacturer was made aware of the failure, and a case was filed. The contact referenced an unknown recall with a similar failure description; however, the VIN was not under recall. The contact was informed that the repair was not covered under the recall. The failure mileage was approximately 126,000.

The contact owns a 2016 Jeep Patriot. The contact stated that while driving at an undisclosed speed, the vehicle stalled. There were several unknown warning lights illuminated. The vehicle was able to be restarted, and the contact drove to the residence; however, the failure persisted. The vehicle was taken to the dealer, who determined that the crankshaft sensor needed to be replaced. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 16V907000 (Engine and Engine Cooling); however, the VIN was not included in the recall. The manufacturer was made aware of the failure. The failure mileage was approximately 126,000.

Vehicle acts like it wants to shut off. No warnings or check engine lights it just starts to shake and not let me accelerate. Auto shop looked at it and engine and transmission are ok. They look ed at it 6 times in 4 months and it just keeps happening. Now car is leaking oil and they can’t figure out where from, they replaced oil pan me anything relating to it so not sure what’s wrong. Also, clicking sound from air vent seems to be a electrical issue. Key is starting to bend from ignition shape also. We replaced the key multiple times. New brakes and new rotors but car screeches and sounds like brakes are old but they’re brand new. Car sounds like struggling when accelerators.

Vehicle stalls when idle at stop signs or stop lights. When restarted while driving engine stops running. Idling is sporadic.

Vehicle began not accelerating and then shut-off. Check engine light was not on, but it sputters. I put it in the shop and was told it's the engine and needs replacing.

The driver headrest deployed without being in an accident. Took my vehicle to Phillips Chrysler Jeep Dodge Ram dealership on November 24, 2025 and the associate informed of the recalls/warranty I have. The invoice comment from the dealership "Performed inspection driver side front headrest has failed cannot replace due to part being discontinued." This results in driving a vehicle that is unsafe. I spoke with Chrysler hotline regarding the issue 12/2, 12/3, 12/8, 12/17 and was given a case # 94878288 which was closed without the problem being fixed/repaired. Just trying to get this issue resolved while the part is a recall and covered through the warranty.

I continually have the same issue with this vehicle. It started only a couple of months after initial purchase and has happened various times since. Today was one of those days it occurred, the ABS system will turn on along with the traction control light in the middle of the freeway causing the vehicle to immediately slow down, I could not accelerate and was almost hit by the car behind me because of it. The last time this happened I was in a remote location and was stranded for about an hour with no signal to call anyone. When this happens the car does not turn immediately back on and you can hear it continuously cranking. This vehicle has been in and out of the repair shops and the Chrysler hall could not figure out what was wrong with it. It stopped doing it but now it started again. I notice that when this happens the car starts tugging while driving and will spin out when attempting to brake. It happens randomly and that is very scary and dangerous.

The contact owns a 2016 Jeep Patriot. The contact stated that while driving at an undisclosed speed, the vehicle failed to accelerate as intended while depressing the accelerator pedal, and the vehicle stalled. The check engine warning light and traction control warning light were illuminated. In addition, the contact had to use force to steer the wheel. The contact was unable to coast to the side of the road during several failures. The contact stated that several attempts were needed to restart the vehicle. The contact stated that after resuming driving, the failure recurred. The vehicle was taken to the dealer, where it was diagnosed, and determined that the crankshaft and camshaft sensors had failed. The vehicle was not repaired due to the cost. The contact stated that the failure persisted. The manufacturer was not made aware of the failure. The contact related the failure to NHTSA Campaign Number: 16V907000 (ENGINE AND ENGINE COOLING); however, the VIN was not included. The failure mileage was approximately 90,000.

While driving home from a wedding with a passenger in my car, the engine for my Jeep Patriot stalled several times. The car would come to a stop and was difficult to control when the stalling occurred, putting both myself and my passenger at risk of a traffic accident. The car was towed to an independent service center which documented in their reports the engine stalling repeatedly. This independent service center was not able to alleviate the issue despite replacing the crankshaft and camshaft sensors. I then took the car to my local Jeep dealership, which performed further repairs on the crankshaft sensor and wiring harnesses, thereby resolving the problem. The vehicle and components were not inspected by any other parties to my knowledge. There were no warning lights or prior indication that the engine was about to stall, adding to the danger associated with this incident.