2010 JEEP WRANGLER Complaints

ABS failing. Loss of Traction Control & Possible Brake Failure. Vehicle Manufacturer failing to provide parts.

ABS, Traction Control, & Brake warning lights have come on due to issues with the ABS Sensors. Repairs unavailable due to unavailability of parts.

As you were fueling the vehicle it will spit fuel back at you and poor fuel all over the ground and me, many people have this problem there is a recall from 2007 to 2008 but not 2009 through 2010 even though they have the same exact very dangerous issue

I will be driving down the road and a red lighting bolt will flash on my gauges then the jeep will either lose power or shut off. I was almost hit by a semi truck due to this. Once I cycle the key goes away till the next time it happens. Also the brake assist will randomly kick on typically applying braking power to the left rear passenger tire. This is not fixed by cycling the key. Jeep has recalled newer Wranglers for these exact issues but when I contacted Jeep they said it would cost me out of pocket

Upon fueling the vehicle and the fueling process stops, the Jeep spits back about 1/2 gallon of fuel, all over the vehicle, the ground and the fuel station.

Plastic rollover valve on gas tank dry out cracked which is modeled to tank can not be replaced which means you have to replace the gastank for what looks like a 5 dollar part. Will not past smog because of this issue.

The contact owns a 2010 Jeep Wrangler. The contact stated while parking the vehicle, the tie rod drag link detached, causing the steering wheel to continually spin. No warning lights were illuminated. The vehicle was repaired by a family member at the contact’s residence. The manufacturer was not notified of the failure. The approximate failure mileage was 200,000.

The design of the fuel tank installed in the 2010 Jeep Wrangler is faulty, The plastic utilized in the manufacture of the gasoline and evaporation fittings is of an inferior material and it can not withstand heat and low humidity. The plastic tends to dry out, crack and crumble, creating fuel and vapor leaks, which could result in a fire or explosion. I have had to replace the gas tank on my 2010 Wrangler in July 2017, at odometer reading 94944 and again in January 2023 with an odometer reading of 161599.

The ABS control module is reporting a DTC code C2200 indicating an ABS module internal failure. The instrument panel warning lights for esp, bas, abs and the traction control are all continuously lit. This problem is continuous but has not been confirmed or inspected by a dealer. independent service center, police or insurance representatives. It is, however, a well known issue reported on Jeep owner forums as an ABS Dashboard Christmas Tree. I have not yet had an ABS related accident but it is extremely concerning that there is an internal ABS module failure that could cause an accident. I have attempted to replace the ABS Module, part 68067458AA, but I am told this part is not available due to a hold for engineering review. I was told the engineering review should be completed by March 20 but until then I am unable to obtain a new replacement part.

Jeep Wrangler JK is required to replace clockspring due to dust that could compromise airbag circut causing potential non-deployment of the driver airbag. Currently, the jeep is available for inspection. Non deployment of the airbag can cause bodily harm or life threating injuries that put at risk driver and others. Jeep owner bring multiple times the vehicle to the dealership but they didn't have part available and never is been fixed. The vehicle has been inspected from multiple technicians at differents dealership. Airbag warning is showing in the dashboard of the vehicle since 2016.