2003 MAZDA PROTEGE Complaints

EXCESSIVE WEAR IN THE AREA INSIDE AND OUTSIDE IN TIRES ... MANY SEVERAL WORKSHOPS CAN NOT CORRECT THE ALIGNMENT FAULT ... THE STEERING WHEEL GO TO THE RIGHT AND I HAVE TO FORCE TO THE LEFT ... ALL THE FRONT AND REAR SUSPENSION PART ARE NEW , INCLUDING THE SHOCK ABSORBER IS NEW AND CONTROL ARM AND LINK ROD AND BUSHING ...THE CENTRIC BOLT NOT CORRECT THE FAILURE ...I SEE OVER ETHERNET MANY PEOPLE HAS THE SAME FAIL IN THIS CAR ..I BUY THIS CAR NEW AND NEVER CRASHED OR OR MISTREATED ..I REPORT THIS IN THIS YEAR BECAUSE PEOPLE HAVE TOLD ME IT'S A MANUFACTURING FAULT..AND I HAVE HAD TOO MUCH EXPENSES AND I CAN NOT SOLVE ... RIGHT NOW I NEED TO BUY OTHER TIRES...PLEASE I NEED A SOLUTION ...I SEND A ETHERNET PHOTO AND THE CAR AND COLOR IS SAME ...TO REMEMBER THE MILLEAGE VALOR AND YEAR PRESENTED IN THE NEXT QUESTION IN THIS FORM IS APPROXIMATED ...THANK YOU I WAIT YOU RESPONSE

2003 MAZDA PROTEGE 5 WAS TRAVELING APPROXIMATELY 45MPH AND STRUCK A MOVING VEHICLE IN THE REAR QUARTER PANEL. NO AIR BAG WAS DEPLOYED IN THE MAZDA PROTEGE 5. THE OTHER VEHICLE'S AIRBAGS DEPLOYED.

SEVERE RUSTING OF LEFT AND RIGHT REAR QUARTER PANELS LEADING INTO REAR OF ROCKER PANELS DUE TO POOR RUST PROTECTION FROM FACTORY.

THE DRIVER SIDE SEAT BELT LATCH IS NO LONGER WORKING. THERE APPEARS TO BE BROKEN PARTS IN THE FEMALE PART.

I WAS PULLING UP TO MY RESIDENCE WHEN THE SEAT BELT POPPED OUT OF THE RECEIVER BY ITSELF.. I TRIED TO RE-LATCH THE SEAT BELT AND IT WOULD NOT LATCH. I ATTEMPTED A FEW MORE TIMES AND THE SEAT BELT RECEIVER COMPLETELY FELL APART.. *TR

PASSENGER SIDE STRUT TOWER HAS RUSTED TO THE POINT THAT FAILURE OF THE SUSPENSION IS IMMINENT. THE RUST INHIBITOR THAT WAS APPLIED FROM MAZDA MOTOR CORP. DURING MANUFACTURING, ON THE PASSENGER FRONT WHEEL WELL HAS FAILED AND IS ALLOWING WATER, ROAD SALT ETC TO ENTER THE ENGINE BAY AND CAUSE SEVERE RUSTING ON THE TOP AND SIDE PORTION OF THE STRUT TOWER WHERE THE SIDE MOTOR MOUNT AND STRUT TOWER BRACE ATTACH TO THE STRUT TOWER. THE FAILURE OF THE RUST INHIBITOR HAS NOW CAUSED THE FAILURE OF THE STEEL STRUT TOWER WHICH IN-TURN COULD CAUSE THE ENGINE AND/OR FRONT PASSENGER SIDE SUSPENSION TO BECOME DISLODGED AND CAUSE A SEVERE ACCIDENT. PICTURES CAN BE PROVIDED UPON REQUEST. *TR

I BOUGHT THE CAR FROM A SMALLER CHEAP DEALERSHIP, I HAD NO IDEA THAT THE FRONT END WOULD BE AS BAD AS IT GOT. MY LOWER CONTROL ARM / BALL JOINT WAS SO CORRODED EVERY TIME I MADE A LEFT TURN IT WOULD MAKE A LOUD NOISE IN THE LEFT FRONT WHEEL THEN WOULD CONTINUE TO HAPPEN OVER AND OVER EACH TIME. THIS WOULD HAPPEN OFTEN WHEN IT WAS DRY AND WARM AND SAT FOR AWHILE. LIVING IN BUFFALO, WELL YOU CAN NOT HELP BUT HIT POTHOLES IN SOME PLACES MORE THAN OTHERS. THIS WOULD MAKE THE PROBLEM WORSE AND THROW MY STEERING OFF WHILE TRAVEL AT A HIGH RATE OF SPEED. IF I WAS DOING THE CURVES ON ROUTE 33 OR ROUTE 290 I WOULD HAVE TO SLOW DONE TO MAINTAIN STEERING ABILITY. I HAVE RECENTLY BEEN TOLD IT WAS SO BAD I COULD LOSE MY WHEEL AND CRASH. SO I WENT TO A LOCAL REPAIR SHOP AND THEY FIXED THE PROBLEM; BUT WITH A SLIGHTLY NEW PROBLEM ONE OF THE SCREWS WERE SO CORRODED THEY CHARGED ME $100.00 TO MAKE AN ACCESS PANEL FROM MY DRIVERS SIDE FLOOR PANEL UNDER MY FEET. THE TOTAL FOR JUST THOSE PARTS CAME TO $350.00 PLUS WHEEL ALIGNMENT. *TR

PASSENGER SIDE INNER FENDER WHERE THE STRUT IS MOUNTED IS GETTING RUSTED BADLY MAKING THE CAR UNSAFE TO DRIVE. CAR RUNS FINE BUT I CAN PUSH WITH THE FINGER FROM THE WHEEL SIDE AND SEE THE BODY MOVE. IF CAR GOES OVER A POT HOLE IT MIGHT MAKE THE STRUT FALL OFF AND CAUSE A MAJOR ACCIDENT. THIS IS STRUCTURE ISSUE. I CANT REPLACE ANYTHING. MAZDA SHOULD BUY IT BACK JUST LIKE NISSAN DID ON THEIR PATHFINDER. *TR

TL* THE CONTACT OWNS A 2003 MAZDA PROTEGE. THE CONTACT ATTEMPTED TO START THE VEHICLE BUT THE ENGINE FAILED TO START ACCOMPANIED BY AN ABNORMAL KNOCKING FROM THE ENGINE. THE CONTACT ALSO MENTIONED THAT THE FAILURE OCCURRED MORE OFTEN WHEN THE ENGINE WAS COLD. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOTIFIED. THE FAILURE MILEAGE WAS 13,200.

THE DRIVER SEAT BELT WILL NO LONGER WORK. THE MALE END WILL NOT CONNECT TO THE FEMALE END. I LOOKED WITH A FLASHLIGHT AND THERE WERE BROKEN PIECES INSIDE. IT LOOKS LIKE THE BUCKLE CAME APART. I NOW HAVE TO USE THE PASSENGER SIDE SEAT BELT BUCKLE. *TR