2020 MERCEDES-BENZ SPRINTER 2500 Complaints

The contact owns a 2020 Mercedes-Benz Sprinter 2500. The contact stated that after inclement weather, the cruise control, Forward Collision Avoidance, and Automatic Emergency braking feature failed to operate as needed. The contact restarted the vehicle however, the vehicle would intermittently return to normal operation. The contact had taken the vehicle to various different dealers where the camera, unknown sensors, and other unknown parts were replaced; however, the failure persisted. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 10,000.

Serpentine belt shredded, cooling fan separated from clutch, pulley screws missing and pulley completely freed from mount and loss of power steering. This seems very similar to previous recall which my vehicle was supposedly not impacted by. Losing power steering in a large vehicle like this is extremely dangerous. Loose components in engine bay has potential to cause more problems. Fan and pulley completely free to come off and fly around bay. This problem has been seen by 10+ Revel owners in the last few weeks. This topic is being openly discussed on public forums and social media. It is currently sitting at MB of Littleton in Littleton, CO and has yet to be inspected. There were no warnings.

There is a problem with the engine control parameters which occurs at higher altitudes. The vehicle will not produce adequate power. This is not simply normal power loss related to density altitude. This is a malfuntion where the vehicle does not respond to the throttle, and produces only about 2psi of turbo boost even upon extended application of full throttle. This problem occurs only on sprinter 4x4 models with the OM642 diesel motor. I experienced this problem for the first time yesterday when pulling onto a 2 lane highway at 7,000 feet in the sierra nevada. The vehicle began to move but as I turned uphill to cross the highway it produced no power and I was stuck straddling the center line on a blind curve. Extremely dangerous. Had to turn the vehicle off and restart it and it behaved normally until later in the day, on a steep remote 4x4 road. Unable to climb a small hill due to lack of power. Could not be resolved through any combination of turning off, waiting, warm-up periods, activating/de-activating traction control etc. Had to use winch to climb mild grade. This issue is well known to the Sprinter community and has been repeatedly reported to Mercedes Benz USA with no response or resolution. There are no warnings, messages, store error codes etc associated with this issue. Many descriptions of this behaviour can be found online: https://sprinter-source.com/forums/index.php?threads/106595/ https://windinmyface.com/Sprinter-Issues_Breakdowns-WillNotMove_RPMsDropEngineLugs.html https://sprinter-source.com/forums/index.php?threads/103019/#post-1130969 https://sprinter-source.com/forums/index.php?threads/94746/ There are many more. This is a known issue, relating to engine control software, that is very dangerous and the manufacturer has taken no steps to remedy. It is beyond time for regulatory intervention. Thank you.

This van is under recall for roll away incidents. The van did roll away and now has $9K worth of damage from hitting a stop sign and a wall. The van has been at MB Stockton Ca for months and months with out a resolution. Mercedes Benz sent us a letter yesterday stating they deny all responsibility and advising us to pick up the van. The recall is not complete. This vehicle is 100% unsafe and now prone to more incidents, we have refused to pick up the vehicle. Mercedes has advised us to appeal the case with them which we have done. They continue to stall the situation.

The contact owns a 2020 Mercedes-Benz Sprinter 2500. The contact received notification of NHTSA Campaign Number: 22V181000 (Seats) however, the part to do the recall repair was not yet available. The dealer was made aware of the issue. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact had not experienced a failure. VIN tool confirms parts not available”

Component that malfunctions: drivers (left) side fixed mirror, It is available for inspection upon request. Vehicle owner's safety and the safety of others is put at risk because the mirror image is distorted due to rattling/vibration: there is a noise produced as well when the vibration begins, distortion ensues immediately thereafter. The problem has been reproduced and confirmed by a Mercedes Benz Dealer. The vehicle should be inspected by the manufacturer as soon as possible since the unsafe condition should be addressed immediately for the benefit of all owners. There were no lamps, messages or other symptoms of the problem prior to the failure and the unsafe situation began immediately after purchase.

The closest authorized service center cannot inspect my vehicle for all three recalls for five months. Since the recall information states that the recall may effect the safety of the vehicle, this seems like an unacceptable time to wait.

cross wind assist too sensitive, kicking on randomly causing more mouvement than if it wasn't doing anything. Wind would normally move me sideways about 6" and this thing moves me by 2', slams on the brakes, slows down when trucks are in my ass. The swing it gives when kicking on with side winds lifted 2 wheels in the air and also did a couple tire marks on asphalt from blocking wheels.

Cross wind assist if really dangerous. Very little cross wind and it hit the brakes really hard, the van fish tails and slows down so much people will rear end me. Date is last time it happened but it's been doing this since we got this vehicule. Very well know problem across many Sprinter owners. There's currently no way to disable this feature for the driver. Also have an older sprinter without this feature and it's unnecessary.

I purchased my van Feb 5, 2021 with 8 miles on it. By April, it was hesitating intermittently at low speeds. It got progressively worse. MB of Athens could not diagnose it in 2 visits in May and June of 2021. By August, the Sprinter service manager at RBM of Atlanta, Charles told me on the phone that he was sure it was the EGR valve and none were available. ETA of a valve was Nov, 2021. The date then moved to Jan, 2022. It is April and there are no EGR valves in the world to be put on my van. The hesitation has progressed to higher speeds. I am going to be killed in this van, my only work van, as I never know when the hesitation will occur. It is dangerous. Mercedes knows they have a problem. I have 2 MB Customer Care complaint files and no results. This problem is a result of their faulty emissions system. I know they are fully aware and do not want to admit their issue and take liability. I bought this van on the MB reputation for quality and service as my job depends on it. I am scared to drive it, but must make a living. I need help. The public should be made aware. I know I am one on many, many with this issue and no resolve. They continue to manufacture new vans in Charleston, SC daily with EGR valves. This is wrong. Please respond. Thank you!