MERCEDES-BENZ Complaints

Panaramic glass roof exploded while traveling on highway sending glass all over the car and highway. Sounded like a gun shot right above my head. Fortunately the sunshade was closed at the time and I was able to safely exit the highway to clean up the mess and no one was injured but it could have been very dangerous!

I was driving along in my 2013 MB GL450 with the M278 engine when the engine stopped. I had it towed to my home and checked it out. I had a suspicion the engine was seized. I eventually had to towed to my closest MB dealership for evaluation. The engine was seized. Their further investigation revealed that a wrong oil filter had been installed when the oil was changed 5 months and 3000 miles earlier. I tried to find out what this wrong filter would cause. I asked the dealership and then MB and got no response. I suspect if this filter caused the issue it would have been an oil pressure issue. The car gave no indication of anything wrong prior to engine seizing. I got no message on the display and when switching on the switch there is no indicator on the dashboard to indicate anything about oil pressure. There is no "oil can" that pops up red indicating an oil pressure issue. To this day have no idea why the engine seized other than an improper oil filter.

The contact owns a 2021 Mercedes-Benz GLC300. The contact stated that the rear-view camera was not functioning properly. After restarting the vehicle, the camera operated as needed; however, several days later, the camera became inoperable. The contact referenced NHTSA Campaign Number: 21V354000 (Back Over Prevention, Electrical System); however, the VIN was not included in the recall. The dealer was not notified of the failure. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 96,000.

The contact owns a 2014 Mercedes-Benz ML63 AMG. The contact stated that the vehicle was experiencing front suspension, coolant, and oil leak failures. The contact stated that the front suspension unexpectedly lowered while the vehicle was parked or while driving. The message "Active Curve System Malfunction" was displayed. The vehicle was towed to the dealer, where unknown repairs were performed. Additionally, the contact noticed a coolant leak in the garage, where the vehicle was parked. The vehicle was taken to two certified independent mechanics, where unknown repairs were performed; however, the failure recurred. The vehicle was taken to the dealer, where the seals were inspected and corrected, and it was diagnosed that the front left cylinder and the lower and upper radiator hoses were leaking. Additionally, a leak was found at the firewall connection. The vehicle was repaired; however, the failure recurred. The vehicle was taken back to the dealer, where the same assessment was made, and the vehicle was repaired; however, the failure persisted. The contact stated while at a complete stop at the red traffic light, the vehicle stalled and failed to restart. The vehicle was pushed into a parking lot with assistance. A warning light for key fob battery drainage was illuminated. The vehicle was towed to an independent mechanic, where the failure was related to an unknown recall, and the contact was referred to the dealer. The contact stated that the dealer had previously completed the repair of NHTSA Campaign Number: 22V955000 (Fuel System, Diesel, Fuel System, Gasoline); however, the recall repair had failed to fix the vehicle. The vehicle recently stalled and was towed to the dealer, where it remained. The vehicle was not repaired. The manufacturer was notified of the failure, and the case was escalated to an Executive. The failure mileage was approximately 100,000.

The contact owns a 2021 Mercedes-Benz Sprinter 3500. The contact stated that while driving at an undisclosed speed, the message “Driver’s Side Air Bag Deactivated” was displayed. The vehicle was taken to a dealer, where it was diagnosed, and determined that the wiring harness needed to be rewired. The vehicle was repaired; however, the failure persisted, and the message was displayed. The vehicle was taken back to the dealer, where it was diagnosed with a voltage issue; however, the dealer stated that the vehicle was operating normally. The vehicle was not repaired. The vehicle was taken back to the dealer for another diagnostic test; however, the dealer was unable to determine the cause of the failure. The vehicle was not repaired. The vehicle was taken to the dealer to be diagnosed, and the contact was informed that there was a wiring issue that needed to be corrected and that the air bag needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 8,000.

Headlight is defective and is filled with condensation which has caused the entire light to fail. The problem has been confirmed by a independent service center. The light has not been inspected by a manufacturer however the manufacturer was contacted and denied that a recall exists however other purchasers have reported the same issue. There have been no apparent issues prior to this problem.

The contact owns a 2009 Mercedes-Benz C300. The contact stated that while starting the vehicle, the check engine, seat belt, and air bag warning lights illuminated. Additionally, the headlights and navigation lights failed to activate for a while. There was burning odor inside the vehicle with the heat activated or turned off. The contact also stated the vehicle failed to start for three days before eventually being able to start. The contact attempted to charge the battery, which resulted in a visible spark. The vehicle was taken to a dealer where it was diagnosed with a sound module and the Signal Acquisition Module (SAM) failures. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 217,000.

The contact owns a 2016 Mercedes-Benz GLC300. While driving at an undisclosed speed, there was an abnormal gasoline odor inside the vehicle. The gasoline odor was also outside the vehicle. No warning lights were illuminated. The vehicle was taken to the dealer but was not diagnosed or repaired. The dealer informed the contact that the failure was not under recall. The manufacturer was not notified of the failure. The contact related the failure to NHTSA Campaign Number: 21V961000 (Fuel System, Gasoline). The failure mileage was 38,000.

While driving the vehicle in normal road conditions the car suddenly stop and activated the seat belts. This incidents has happened 4 times. The vehicle has been taken to the Mercedez-Benz service and it gas been released with no findings. I am concerned with this safety issue on my leased vehicle and the risk to cause a collision or injury. The last incident occurred on 3/8/2026, while driving the car.

On December 6, 2025 I purchased a used 2013 Mercedes-Benz ML63 AMG from Jaguar Land Rover Willow Grove (Piazza Auto Group) in Pennsylvania. The delivery documentation for the vehicle included a written service commitment stating: “Replace air compressor for suspension system.” On January 23, 2026 at approximately 6:30 PM, while operating the vehicle at highway speed on the [XXX] in [XXX] , the vehicle experienced a sudden cooling system malfunction. An “Engine Overheat – Shut Off Engine” warning appeared on the instrument cluster and steam began emitting from the engine compartment. Because the failure occurred while traveling at highway speed, the driver was forced to execute an emergency maneuver across traffic lanes in order to reach the shoulder safely. The vehicle became disabled and required towing. The vehicle was transported to a Mercedes-Benz dealership for inspection. Initial repairs involved replacement of the coolant reservoir and hose assembly. Within several days the vehicle again displayed a low coolant warning and was returned for further inspection. At that time the radiator was found to contain a prior non-OEM epoxy repair and the radiator required replacement due to leakage. During a separate independent inspection, the air suspension compressor was observed to be mounted using plastic zip-tie fasteners rather than mechanical mounting hardware. The compressor is part of the vehicle’s AIRMATIC suspension system and is subject to vibration, pressure cycling, and heat during normal operation. Improper mounting of this component could allow the compressor assembly to move or detach during operation and may damage associated air lines or electrical connections. Because the air suspension system affects ride height and vehicle stability, this condition may present a safety risk during vehicle operation. Photographs and video documentation of the compressor mounting condition are available for inspection upon request. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.