1996 OLDSMOBILE 88 Complaints

FUEL GAUGE FAILURE--SENDING UNIT GOT SO HOT IT FUSED THE WIRES TOGETHER AND THEN SENT A JOLT OF ELECTRICITY TO THE INSTRUMENT CLUSTER BURNING OUT PART OF THE CLUSTER; IN ATTEMPTING TO REPAIR THESE PROBLEMS THE PLASTIC FUEL LINES WERE SO BRITTLE THAT THEY FELL APART THEREFORE, IT WOULD SEEM THAT EACH OF THESE PROBLEMS COULD LEAD TO A FIRE OR AN EXPLOSION. I HAVE THE SENDING UNIT OUT OF THE FUEL TANK WITH THE FUSED WIRES. *NM

DT: EARLIER IN THE DAY THE CAR WAS HARD TO START AND THE GAS GAUGE WAS LOWER THAN IT SHOULD HAVE BEEN. THE FUEL CENTER LINE LEAKED , AND THE REPAIR SHOP SAID IT RUSTED. THEY REPLACED THE FUEL CENTER LINE, AND THE TWO LINES LEADING UP TO THE CENTER LINE, FOR A TOTAL OF $720.00. *AK *JB

AFTER STARTING THE VEHICLE CONSUMER HEARD A LOUD POPPING NOISE, AND NOTICED SMOKE COMING FROM UNDER THE HOOD. CONSUMER OPENED THE HOOD, AND SAW THAT THE ENGINE WAS ON FIRE. THE LOCAL FIRE DEPARTMENT ARRIVED TO EXTINGUISH THE FIRE. THE CAUSE OF THE FIRE WAS NOT DETERMINED. DEALER AND THE MANUFACTURER WERE NOT NOTIFIED. *AK

VEHICLE IS LEAKING ANTIFREEZE OUT THE INTAKE MANIFOLD INTO THE ENGINE, WHICH COULD CAUSE THE VEHICLE TO OVERHEAT. MANUFACTURER WAS CONTACTED BY CONSUMER.*AK

A HOLE WITHIN INTAKE MANIFOLD CAUSED ANTIFREEZE TO LEAK INTO THE ENGINE COMPARTMENT. AS A RESULT VEHICLE HAD DIFFICULTY IN STARTING INTERMITTENTLY.*AK

WHEN THE TEMPERATURE WAS AT ZERO, THE VEHICLE ACCELERATED WHEN THE BRAKES WERE APPLIED. *AK *SC *JB

WHILE DRIVING, THE VEHICLE REACHED HIGH TEMPERATURES DUE TO INTAKE MANIFOLD FAILURE. COOLANT SEEPED INSIDE THE ENGINE. AN INDEPENDENT SHOP WILL REPLACE THE INTAKE MANIFOLD. *JB *JB

CONSUMER'S VEHICLE EXPERIENCED THE SAME PROBLEM AS DESCRIBED IN RECALL 95V204000 CONCERNING IGNITION ANTI THEFT CONTROLLER. HOWEVER, THIS VEHICLE WAS NOT INCLUDED IN THE RECALL DUE TO VIN. *AK

WHILE DRIVING AT AN UNDETERMINED SPEED ENGINE CHECK LIGHT APPEARED ON THE DASHBOARD. CONSUMER INFORMED DEALER ABOUT THIS ISSUE. HOWEVER, MECHANIC WAS UNABLE TO DUPLICATE THE PROBLEM. *AK

CONSUMER CITED THE POOR QUALITY OF MATERIALS USED FOR THE UPPER INTAKE MANIFOLD AND POOR DESIGN AROUND THE EGR STOVE PIPE. *LA THE UPPER AND LOWER INTAKE GASKETS WERE LEAKING, HOWEVER THE CONSUMER DID NOT BELIEVE THAT THE UPPER INTAKE PLENUM WAS REPLACED AND OVER TIME THE INTAKE GASKETS LEAKED AGAIN. *JB