2019 RAM 1500 Complaints

The contact owns a 2019 Ram 1500. The contact stated that while refueling the vehicle, the pump constantly shut-off independently before the tank was full. The contact was constantly squeezing the handle to continue refueling the vehicle. No warning lights were illuminated. The dealer was notified of the failure and acknowledged that the failure was a known issue; however, the contact was asked to take the vehicle in for a diagnostic test. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 96,000.

The AC was stuck on hot and would not defrost. Dealership said the blend actuator door needed replacement. Unfortunately this cost is 1700. In addition to this, the fuel line or gas tank keep clicking and stopping when trying to fill. This has been intermittent since we purchased vehicle. In addition, our infotainment center was hacked, someone was changing our settings repeatedly. Dealership refused to fix

The contact owns a 2019 Ram 1500. The contact stated that while changing the brakes, there was an abnormal sound coming from the brakes, with an abnormal amount of brake dust accumulating on the wheel. The contact stated that there was an abnormal resistance while driving. The contact stated that the brake pads were extremely hot, causing the back of the pads to be melted onto the piston of the caliper. The local dealer was contacted; however, the vehicle was not diagnosed. The contact was informed that the vehicle was not included in any recalls. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 70,000.

The RAM trailer brake controller has two problems, causing unsafe operation when connected to a camper or trailer with electric brakes. 1) When coming to a stop and feathering off the brake to stop smoothly, the trailer brakes are released too early, this causes the vehicle to be pushed forward, often into an intersection, pedestrian, or a vehicle opinion front of you! Care must be taken to avoid this! Alternatively, the trailer brake controller lever can be manually pressed to avoid the trailer brakes from being released early. The camper was tested by the camper dealer as OK This same camper does not have this problem if tested with other tow vehicles such as GMC, etc. 2) The RAM trailer brake controller does not output a full 12VDC to the connected trailer, even with the gain set to max (10) and full brakes are commanded either by the brake pedal, or the brake controller lever. This causes the trailer to not have full stopping powerm reducing the stopping distance, especially in an emergency stop. If the brake controller output is tested without a trailer connected, it will show 12V output. However, once a trailer is connected, the output drops to about 9.6 VDC. The camper has been tested by the camper dealer and was found to be ok. The camper was also tested with other brands of vehicles (Toyota, GMC, Chevrolet, Nissan), and no other vehicles except RAM exhibit this problem. This problem was also confirmed at a trailer dealer by using an independent trailer brake test meter (IPA #9107B Electric Brake Force Meter). The RAM has been taken to a RAM dealer multiple times since new, and each time the dealer said the RAM is working as designed. I have photos of the tests made on multiple RAM vehicles showing this issue, as well as other brands showing that they do not have the same issue.

Abs and traction control dash lights randomly illuminate briefly while accelerating, cruising or breaking. Stays illuminated for approx 20-30 secs then goes out. Have not noticed any effect to performance while actually braking. Speed varies* ...

The contact owns a 2019 Ram 1500. The contact stated that while driving at an undisclosed speed, the rear window fractured. The contact stated that there was a large crack on both sides of the rear window. The contact stated that there was no impact to have caused the window to crack. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The approximate failure mileage was 60,000.

Active grill shutters code u11e9 we replaced wire harness and actuator and still getting code that’s causing an engine light .Brought to dealer and they did a recall on the air dam. Asked dealer to diagnose engine light after the fixed air dam and still getting a code for active grill shutter they told me I needed to replace active grill shutter. I explained to dealer we replace all the components to the active grill shutter. We live in MA can’t get a inspection sticker because of the engine light.

The contact owns a 2019 RAM 1500. The contact stated while driving at 20 MPH, several unknown warning lights were illuminated. The contact also mentioned that the key fob failed to unlock or lock the driver and passenger side doors. The vehicle was not taken to an independent mechanic or dealer for diagnosis or repairs. The manufacturer was not notified of the failure. The contact was relating the failure to NHTSA Campaign Number: 24V653000 (SERVICE BRAKES, HYDRAULIC, ELECTRONIC STABILITY CONTROL (ESC)) however, the VIN was not included in the recall. The failure mileage was 74,977.

The contact owns a 2019 Ram 1500. The contact stated that while his wife was driving at 22 MPH, an unknown vehicle crashed into the side panel, however, the air bag did not deploy. There were no warning lights illuminated. There was no reported fire or injuries. A police report was filed. The vehicle was towed to a collision center. The local dealer was not contacted; the vehicle was not diagnosed or repaired. The manufacturer was not contacted. The failure mileage was approximately 30,000. Additionally, while driving 80 MPH, a semi-truck ran him off the road and crashed into a steel pole. The anti-lock brakes did not work. The occupants were wearing seatbelts. The airbags failed to deploy. The contact's face struck the front windshield. There were no warning lights illuminated. The driver hit the steering wheel. The contact and his daughter were taken to the hospital by ambulance, which provided medical attention. There was no reported fire. A police report was filed. The vehicle was able to be driven away. The vehicle was taken to the local dealer, who determined the vehicle was working as designed and the failure was a user error. The vehicle was not repaired. The manufacturer was contacted and referred to the NHTSA hotline. The failure mileage was approximately 99,800.

The contact owns a 2019 Ram 1500. The contact received notification of NHTSA Campaign Number: 24V653000 (SERVICE BRAKES, HYDRAULIC, ELECTRONIC STABILITY CONTROL (ESC); however, the part to do the recall repair was not yet available. The local dealer was made aware of the issue and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.