2025 RAM 1500 Complaints

9/25/25 My truck accelerated on its own, in drive, while turning and a downhill situation. It revved high, about 2000 RPM but I was able to pull over to get it in park to stop revving, and turned it off. It restarted and when I arrived to work that trip, it did the same in reverse while trying to park. Had to hold brake hard to get truck to stop. Took to dealer did who did SW update to transmission module. 1/13/26 truck again revved while pulling forward in Mc'D's drive through, worker mentioned "that could have been bad", I said yes I thought they had fixed. Had to hold brake hard and shift into park to stop it. 3/31/26 It revved to about 2000-2500 rpm while stopped at Moine Rd. and 585 with car waiting in front of me with 55MPH traffic crosswise. I was able finally get into to park to stop it while holding brake hard to keep from moving, and turned off truck. Took to dealer who had truck for a week, engineers said to return to me (4-10-26)because they could not duplicate or find error code or problem. 4/13/26 SEL light came on, threw evap code P!CEA-00, they did SW upgrade to PCM. Thought it was fixed. About 2400 miles later on 7/10/26, while waiting at red light with car in in front of me it lurched and revved to 4000 RPM, worst time ever, tires where spinning, would not go in park, Brakes fully engaged, put in neutral, and not 100% sure that stopped back tire from spinning. Thankfully it just rained so there was a loss of traction. Pushed off button that shut truck down. Drove home, is at dealership now. This is a VERY dangerous situation. Stellantis needs to address it. There were no codes for this or any time it happens. I really don't want to lemon law this truck as it can't be rebuilt now, but not sure it's worth risking my life or the life of others if they cannot find what is causing it. I shouldn't have to buy a dash cam for my tach and feet to prove this! I have seen on Ram forums this is happened to others as well. Sad & scary all 5 TIMES!

This vehicle has a severe safety defect in its Instrument Panel Cluster that is the subject of NHTSA Safety Recall 25V-826. Despite multiple repair attempts, including a complete hardware replacement of the entire Instrument Panel Cluster, the defect remains unresolved. To date, the vehicle has been out of service for a cumulative 86 days for this issue. On June 24, 2026, after the full component replacement, the instrument panel cluster suffered a complete blackout while I was operating the vehicle at highway speeds. This resulted in a total loss of the speedometer and all safety information. A subsequent power-cycle restart failed to initialize the system. This is a documented, ongoing highway safety hazard. Video evidence of this failure is on file with the Texas DMV (active Lemon Law Case No. 26-0011927) and has been provided directly to the manufacturer's legal counsel. The manufacturer has failed to resolve this safety defect. Videos available upon request.

Loses the memory seat position all the time and seat does not roll back to exit. Speed limit warning setting is forgotten and alerts at 2 mph default, parking camera view fail to come on and must be selected manually, door trim popped off driver door requiring 2 trips to dealer to fix and a third trip to dealer to get seat position memory buttons reconnected as they were forgotten on 2 nd visit.

THE RECALL IS FOR THE TRAILER BRAKE MODULE SYSTEM MAT FAIL. I HAVE CONTACTED MY DEALER ABOUT EVER 2 WEEKS OR SO ABOUT THIS . THEY SAY AND RAM PARTS SAYS THEY ARE OUT OF STOCK . THIS HAS BEEN GOING ON SENCE MARCH 2026 WHEN I FIRST RECIVED THE LETTER IT IS UNKNOWN IF SYSTEM IS WORKING OR NOT CAN'T TELL IF BRAKE LIGHTS WORK OR NOT. ONE TIME WE CODE A MESSAGE ON DASH THAT SAID TRAILER PLUNG NOT CONNECTED. THERE WAS ON TRAILER AT THE TIME.

The contact owns a 2025 Ram 1500. The contact stated that while driving with cruise control engaged, the cruise control system accelerated and failed to recognize objects or vehicles ahead. The contact was forced to manually override the cruise control system to regain control of the vehicle and prevent an accident. The contact stated that a "Driver Override" warning message appeared on the instrument panel as the vehicle accelerated without the contact depressing the accelerator pedal. A dealer was notified of the failure, and an appointment was scheduled to have the vehicle inspected. The manufacturer was not yet notified of the failure. The vehicle was not yet repaired. The failure mileage was approximately 17,000.

The contact owns a 2025 RAM 1500. The contact received notification of NHTSA Campaign Number: 26V059000 (Exterior Lighting, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.

My dash cluster has gone black twice now, first time being on May 22, 2025, causing major safety concerns. 5 codes are popping up, one being the trailer-tow malfunction that comes on while driving stating that out trailer is not secured while there is not a trailer attached to the truck. The Dodge Dealership says that there are no remedies to fix these issues.

The contact owns a 2025 Ram 1500. The contact stated that the engine experienced misfires during cold starts. The check engine warning light was illuminated. The vehicle was taken to a local dealer on three separate occasions, where diagnostic trouble code: P0300 was retrieved, indicating random or multiple cylinder misfires. The dealer advised that no repair was currently available, and the vehicle was not repaired.The dealer referred the contact to the manufacturer. The manufacturer was contacted but provided no assistance and referred the contact to the warranty company. Additionally, the manufacturer stated that the NHTSA was responsible for repairing the vehicle and directed the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 5,846.

The contact owns a 2025 RAM 1500. The contact stated that while driving on multiple occasions, a strong odor of exhaust fumes was detected inside the passenger cabin. During recent occurrences, the fumes grew progressively stronger, causing the contact to fall asleep while driving. The vehicle was taken to a local dealer, where an inspection identified an exhaust leak originating from the turbocharger and catalytic converter area. The dealer diagnosed the vehicle with defective exhaust clamps and gaskets, and the contact was informed that the issue was common with 2025 RAM models. The vehicle was repaired by replacing two gaskets. The manufacturer was not notified of the failure. The failure mileage was 14,000.

This vehicle received the 03D/NHTSA 26V-059 Trailer Controller replacement on 3/26/2026. Prior to that there were no indications of any trailer-related issues. It also received the 35D/NHTSA 26V-225 Instrument Panel update on 5/12/2026. The vehicle now is indicating a connected trailer with faulty wiring when no trailer is connected at all. When towing a trailer, the instrument will similarly display a recurring indication of a faulty trailer wiring, then the error disappears shortly thereafter. The dealer has been unable to diagnose the problem. It appears that Stellantis has a Case # S2623000029 which indicates a similar concern with Code B235C-64 set in the Integrated Trailer Module. This concern mentions a possible "service update" for the "3rd quarter of 2026" but the dealer is unable to confirm any timeline and is uninterested in pursuing further diagnostics. They admit the trouble codes are verified in the device database. This is a safety issue due to the fact that the vehicle notifications, while towing a load, appear to be false but can cause the vehicle operator to attempt corrections such as immediately stopping while in traffic lanes to confirm the problem. This is very risky business as is continuing on with a potential trailer electrical fault. One really doesn't know what to believe in this circumstance. In my opinion, the replacement trailer controller installed via the first recall stated above is more faulty then the original controller, which never yielded false information.