2019 RAM 2500 Complaints

Engine started to slip or misfire. Became worse and then light came on saying Exhaust Emission Service was needed. The truck lost power as it limped to the side of the road. The Service Electronic Ignition light then came on and truck turned off. Would not crank again.

Cp4 failed while driving down the road. Lost power and could not accelerate. Coasted to the side of the road. No warning. Was stranded on the side of IH310 in New Orleans area. Beings I was out of town I had to take it to a shop where they confirmed it was a cp4 pump failure and had to replace the pump and injectors out of pocket. Vehicle was inspected by a service provider and no issues before this.

In August 2020, while I was driving my vehicle at approximately 15 mph, with approximately 13,500 miles on the odometer, I noticed that the vehicle's transmission gauge was about 230-240 degrees. I pulled over and smelled smoke. Luckily, my passengers and I were able to get out of the vehicle. The vehicle was completely destroyed. I have video showing flames coming out of the passenger side engine compartment. I had previously taken my vehicle in for repair for recall W03 to have the transmission valve body replaced so the transmission wouldn't cause an engine fire. FCA had an expert inspect the vehicle and he found that "fire progression appears to be from engine compartment thru entire vehicle terminating at rear truck bed," that "possible source of ignition is hot surface of turbocharger/exhaust components. - Most likely method of ignition is transmission fluid expelled from dipstick tube," "origin appears to be in the engine compartment," and "possible cause appears to be transmission fluid expelled from dipstick tube onto turbocharger/exhaust components. The determination of possible cause is based on: 1. Owner/driver's description of events. 2. Transmission of dipstick is extended ~ 27.0 inch from the fill tube." Despite this, FCA refused to pay me for my destroyed vehicle (or the trailer that it destroyed) because: "After the inspection of your vehicle, the information at hand would not permit us to associate the fire with a manufacturing or assembly error. We are sure you will understand fires of this nature can and do occur for a number of reasons not associated with the manufacturing process. Therefore, we must respectfully decline any assistance associated with this matter. Based on this, we suggest that you refer this matter to your insurance carrier . . ." I already had the transmission fire recall performed and my truck still blew up. Luckily, I was not injured. I am worried that if FCA does not do another recall, other trucks will blow up too.

The contact owns a 2019 Ram 2500. The contact stated that while driving approximately 25 MPH, the engine started to knock. The contact took the vehicle to the dealer who diagnosed that the fuel injector pump had blown out and caused other damage to the engine. The engine needed to be replaced. The vehicle had not been repaired. The manufacturer was aware of the issue and opened a case. The approximate failure mileage was 48,000.

Driving home one evening and truck started losing power and downshifting and completely disabled on the road. Transmission was blowing fluid out of the dipstick tube and engine was running horribly then died all of a sudden and wouldn’t start back up. Come to find out after having transmission repaired by a shop because Ram refused to warranty it, that the CP4 high pressure fuel pump has Grenaded and sent metal all through my fuel system and my truck is completely disabled with a “void” warranty due to a dealer claiming I didn’t perform a service on my truck that isn’t due for another 17,000 miles.

Living in warmer climate area such as Central Valley in California the A/C does not blow cold enough to cool the cabin of the truck. My other vehicles I own all blow in the low to mid 30’s. The ram can’t get below 50 degrees which is very concerning when the outside temperature is 110+.

Update rrt 9 bullet 18-010-21 made grinding noise in transmission when vehicle down shifts right before coming to a stop.

The tailgate has issues closing and the supports meaning the wire that supports the tailgates when it is deployed one will have tension on it and the other is loose. The tailgate support cables are the same length. I think it has to do with the bed being worked. I have reported it to Huffines dodge dealer and they said there is no fix. The tale gate has opened when in use due to the latch / tail gate not closing correctly because of the out of square bed.

The contact owns a 2019 Ram 2500. The contact stated while attempting to enter the vehicle, the driver’s side front interior door handle failed and the contact nearly fell to the ground. The contact indicated that a plastic post piece used to bolt and secure the handle had failed. The local dealer and manufacturer were not notified of the failure. The failure mileage was 5,300.

THE DRIVERS SEAT BELT DOESN'T RETRACT ON IT OWN. I'M CONSTANTLY HAVING TO PULL THE EXTRA SLACK BACK TO ALLOW IT TO RETRACT. IT GET HUNG UP ON THE ADJUSTABLE LOOP ON THE PILLAR. THE EXTRA SLACK MAKES IT SO WHEN YO UNSTOP SHORT (OR CRASH) THE BELT WON'T LOCK TO KEEP YOU FROM FLYING FORWARD