2019 RAM 2500 Complaints

I have experienced unexpected loss of power during acceleration, lack of exhaust breaking and engine codes p003a and p006f which I believe are associated with the turbo actuator.

We took a trip from Daleville, Alabama to Las Vegas, Nevada. Before we left, We took my 2019 RAM 2500 Bighorn diesel pickup to our local Ram dealership, Mitchel Chrysler Dodge in Enterprise, Alabama to have it inspected, to make sure there wouldn't be any problems along the way. They cleared it, and said there was nothing wrong with the vehicle. On my way, the steering wheel position started slipping to the left. after that, I received a waning on my dash that said " electronic stability control". So I took it to the closest RAM dealership, in Lawton Oklahoma, and they stated "needs a steering Gearbox replacement" and it would take two weeks to get the part, and then fix it. They told me it would be safe to drive. When I got to Las Vegas, at that point it was at the seven O'clock position. We took it to Chapman RAM dealership and they told me it was a loose jam nut and it had stripped the drag link. During the diagnosis they broke they clockspring on the air bag. They quoted that to fix the vehicle it would cost over three thousand dollars! They said it would not be covered on my mopar extended warranty. So I began researching it and found the recall- V06/NHTSA 19V-021 drag link for 2017-2018 (DJ) RAM 2500 pickup. My RAM was built in June of 2019. How can this still be a problem 6 months later after the recall ended? My safety and the safety of others could have been compromised if the drag link would have completely pulled out. I could have lost control of the vehicle and it could have caused a serious crash ending in injury or death to myself, and others.

Parked vehicle for a week in driveway. Sometime during that week side curtain airbag inflator unit exploded causing significant damage to the roof and interior of the truck. Vehicle was powered off and was not involved in a collision when this incident occurred. Vehicle was not included in the recall for this problem and I was never notified this could be an issue. If there had been a passenger in the rear seat they would have likely been severely injured by the explosion of the inflator.

The surface on the front dash has separated from the component underneath. It is bubbled up and no longer glued to the underneath dash piece. It does not currently block driver's view but it could completely separate in the future causing the driver not to be able to see out of the front windshield. This is a widely reported and complained about issue on-line, primarily on year models 2019 through 2021. RAM has refused to do anything about it and extended warranties refuse to cover it in most cases stating that "it is a trim component that is designed to wear out and be replaced at the owner's expense." I object to this assessment of a dash as no other vehicle I have owned in 40+ years has done this. And my vehicles are always garaged and well maintained.

Two snap rings in transmission came loose and caused a catastrophic fail while I was driving . No warning or sounds before it happened. Almost caused a multi vehicle pileup on the interstate. This is an issue that has been happening to all these trucks.

Brake pedal became very soft and spongy and excessive travel. Need to pump brake pedal to restore pressure. No warning lamps. Dealer technician verified “low pedal”

The contact owns a 2019 Ram 2500. The contact stated that while driving 5 MPH, the brake pedal was inadvertently applied with the Forward Collision Avoidance message displayed. The contact depressed the brake pedal, and then the accelerator to start the vehicle. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 130,000.

The contact owns a 2019 Ram 2500. The contact stated that while her husband was reversing, there was an abnormal pop coming from the vehicle. In addition, the contact stated that while driving at an undisclosed speed, the steering wheel independently turned to the left. Upon further inspection, the contact's husband noticed that there was a bolt that was loosened on the driver’s side of the steering gearbox. No warning light was illuminated. The vehicle was taken to a local dealer, where it was diagnosed with a hairline fracture on the subframe due to rust. The vehicle was not repaired due to the cost. The manufacturer was made aware of the failure. The failure mileage was approximately 50,000. The VIN was not available.

Following completion of the Y78 (high-pressure fuel pump) and XQ1 (emissions) recall repairs in April 2024, our 2019 Ram 2500 immediately began experiencing misfires, fuel system issues, and ongoing performance problems. These symptoms have persisted for over a year and have never been resolved despite repeated service visits and escalations. The vehicle suffered multiple HPFP failures, including one that caused fuel to leak into the crankcase, resulting in approximately 19 quarts of fuel-contaminated engine oil. Despite technical service bulletins calling for specific system flushes and tests post-repair, the original dealership did not follow these protocols or provide documentation confirming that the required inspections (fuel pressure, contamination checks, EGR/DPF/DEF system functionality) were ever completed. A new dealership confirmed the presence of metal debris after the fuel filter, suggesting the system was still contaminated even after the prior recall-related flush and HPFP replacements. They also found non-functional emissions components covered under XQ1, including a failed DPF urea pump and a faulty NASA pressure sensor. These failures were not documented or addressed by the original repair facility. Despite these clear safety risks, the recall is considered “completed,” leaving us with a vehicle that is still experiencing symptoms consistent with the original recall condition. The failure to properly inspect, document, and address these defects has placed our safety at risk and caused prolonged loss of vehicle use. The issue, confirmed by a 2nd authorized dealership, identified fuel contamination & failure in multiple components of the emissions systems. The check engine light appeared prior to the initial failure and has recurred each time the vehicle was returned after service. Given the continued presence of recall-related symptoms and the lack of proper inspection & documentation, this unresolved recall should be reopened and investigated

The contact called on behalf of the owner of a 2019 Ram 2500. The contact stated that while driving 60 MPH in rainy weather, the windshield wipers became inoperable, causing the contact to slow down significantly to exit the expressway. The contact was able to drive to the residence. The vehicle was taken to the dealer, where it was diagnosed and determined that the totally integrated power module (TIPM) had failed, causing the body control module (BCM) to fail. The dealer replaced the TIPM and BCM. The vehicle was repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 87,000.