2021 RAM 2500 Complaints

Passenger side seatbelt locked in place and would not release. It continued to retract but would not release. We had to use the emergency release mechanism at the base to get the passenger free from the seatbelt. This was super scary. The seatbelt is in perfect condition, the truck has never been in an accident or had any other issues. It has been perfectly maintained. We took the vehicle into the closest dealer and they stated that it was a known issue and charged us $200 to replace a solenoid part. We googled the issue and found thousands of people that had the same issue. We called Chrysler Ram at 800-853-1403 and they said there wasn't a recall for this truck specifically, but it was very similar to several other recalls for seatbelts for the same year and model of truck; however there was nothing that they could do to help.

The leather dash cover is peeling/ separating from the dash panel. The way it is peeling I don’t believe the passenger airbag will deploy properly. There are seams that should split when the airbag deploys, but I think with the leather pealing it will just push the cover up and direct the airbag in the wrong direction.

When placing the truck in first gear to control speeds on steep declines both on and off road the vehicle's RPMS will climb significantly and the truck will accelerate abruptly under it's own power until it reaches 21-25mph. At which point the RPM's come down and truck begins to slow as expected. Once truck reaches a speed of 11mph the RPM's begin to climb again and the truck accelerates(Not due to gravity, but accelerates under it's own power) aggressively. It will continue to do this pattern until you either reach flat ground or switch gears. Safety is at risk due to uncontrolled descent down steep mountain passes. Constantly having to apply breaks to prevent the truck from going off the road. This safety liability is exacerbated when towing a trailer. I have reported the issue to the dealer multiple times with their claim that the vehicle is behaving as expected. I have not experienced this with any other vehicle. This is not common vehicle behavior. No warning Lamps, Messages or Other symptoms. Reproducible on any hill with steep enough descent.

The contact owns a 2021 Ram 2500. The contact received notification of NHTSA Campaign Number: 22V835000 (Power Train) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

The contact owned a 2021 Ram 2500. The contact stated that while driving 55-60 MPH, the vehicle crashed into a cow, causing the front bumpers to bend 2 ft. inward. The air bags failed to deploy. The contact sustained bruises on the left arm, on the shoulder, on the chest, on the right elbow and on the right knee. The contact did not seek medical assistance. A police report was filed. The vehicle was towed to a tow lot, where it was awaiting to be totaled. The dealer and the manufacturer were not notified of the failure. The failure mileage was approximately 70,500.

While driving in stop & go traffic traveling at speeds less than 15mph, when I stepped on the brake pedal to slow / stop my RAM, the brake pedal failed to activate the brakes and the vehicle continue in a forward motion causing my RAM to collide with the vehicle traveling in front of me. After the collision, my RAM pushed the vehicle I hit into the center shoulder of the freeway. My RAM continued its forward motion (up an shallow grade) for another 1/4 mi. My constant stabbing and continual pressure failed to stop or slow my RAM. I eventually I brought my vehicle to a stop by depressing the "emergency brake pedal". While I was attempting to stop my RAM in appeared the throttle continued to deliver the engine power even though my right foot was on the brake pedal.

My 2021 Ram 2500 6.7 truck quit on me driving down the road. When I raised the hood I could smell burned wires and see smoke. Luckily, it was raining or I think my truck would have burned up. I noticed melted plastic and burned wires on the drivers side of the truck. This particular truck had an Electrical system recall and shows to have been completed. (Safety Recall 13A/NHTSA 23V-060) If this recall was completed, maybe something else needs to be checked out. The truck is currently at a dealership to be repaired, but I will still be scared of it catching on fire because the dealership cannot tell me why or how the fire started. 03

The contact owns a 2021 Ram 2500. The contact stated that while driving at various speeds, on several occasions, the vehicle lost motive power. The vehicle was taken to a dealer where it was diagnosed that the ECM needed to be updated. The ECM was updated but the failure persisted. The manufacturer was notified of the failure. The failure mileage was 37,510.

3 months ago at around 23,000 miles, my truck had a P0302 Cylinder 2 misfire code, dealership “reset” the vehicle and code didn’t return. 3 weeks ago, cylinder 2 started having a loud tapping noise after the vehicle was fully warmed up. Vehicle has been at the dealership for 1 week with zero communication from the dealership or from the RAM caseworker. No rental car has been offered.

I have multiple safety recalls on my vehicle. I contacted the local dealership about 8 months ago and they said I was added to their waiting list. I hadn't heard anything so I contacted them today and they said it would be another 6 months. I then contacted FCA Recall Assistance Center as noted on the recall and they said they couldn't do anything since I was already on a waiting list. I'm find in unacceptable that it takes almost two years to get an "IMPORTANT SAFETY RECALL" resolved.