2022 RAM 3500 Complaints

Driver of the 2022 Ram 3500 pulled out of a driveway onto a street and ran over a pedestrian who was crossing in front of him. Driver states he did not see the pedestrian. I understand the 2022 Ram 3500 is equipped with front ParkSense Sensors, but these sensors failed to deploy. The pedestrian suffered very serious injuries requiring weeks of hospitalization and additional outpatient rehabilitation. The incident is caught on surveillance camera. The vehicle should be available for inspection upon request. The vehicle has not been inspected.

I have had the seal between the transmission and transfer case replaced 3 times due to leaking since new and after each repair within miles of each repair and all prior to the vehicle reaching 50,000 miles. The last time it was repaired at 65,000 miles they decided to replace the transmission with a new transmission - it also leaked between the transmission and transfer case within 1 day and less than 100 miles.

Every month I am receiving a check engine light for abs / traction control / failure. Dealer states HPU unit is bad, however I noticed all the fuses in the fuse box were loose. I pushed them in to reseat and the error cleared. This happens monthly. This last time happened during a snow storm and disabled abs.

***1*** The emissions system on this truck (2022 Ram 3500 with 34,435 miles) has been problematic since I acquired it 5 months ago. It continually attempts to regenerate and rid itself of ash/soot buildup. If it does not successfully regenerate, it will go into a state of reduced power, also known as limp mode. The truck is available for inspection and will be at Lithia CDJR in Corpus Christi tomorrow, 07 Jan 2026. ***2*** Today specifically, the truck flashed a message EXHAUST FILTER NEARING FULL SAFELY DRIVE AT CONSISTENT SPEED TO CLEAR. I got on the highway to achieve this and avoid lights and stop/go traffic. It typically takes around 25 minutes of consistent driving for it to clear. But today, shortly after I reached highway speeds, the truck entered limp mode, displaying EXHAUST FILTER FULL REDUCED POWER SEE DEALER. This was a very alarming incident that created a bottleneck on the highway and presumably for me to nearly be rear ended as it happened at 5:35pm. I was able to safely make it off of the highway, however this incident has put the lives of all motorists on the road around me today in danger. ***3*** The truck has been inspected numerous times by the dealership. The Diesel Particulate Filter was replaced on 01 October 2025 (this was the first time the truck went into limp mode on me). The frequent regenerations continued after the DPF replacement and a sensor was replaced on 29 October 2025. Regens continue at approximately 1 per week. ***4*** This is a known issue amongst the community of RAM truck owners. It's unfortunate that many do not report it because the safety issue could easily set off a chain reaction, especially if this heavy duty truck were to be towing a heavy load as it capable of doing.

The contact owns a 2022 Ram 3500. The contact stated that while driving at various speeds, the vehicle hesitated to accelerate while the accelerator pedal was depressed. The check engine warning light was illuminated. The vehicle was taken to a local dealer, where it was diagnosed; however, the cause of the failure was not determined. In addition, the contact stated that the vehicle was taken to the same dealer approximately eight times, and a loaner vehicle was provided; however, after several unknown repairs, the failure reoccurred. The vehicle was previously repaired under warranty. The manufacturer was made aware of the failure. The failure mileage was approximately 2,000.

The # 4 cam bearing seized to the camshaft. Upon further investigation the #4 main bearing was damaged from metal chips that were not removed during the manufacture of the engine. This damage from the manufacturing defect left the engine block damaged beyond repair. So a short block was ordered and installed.

Lifter tick issue on 2019 to 2024 ram 6.7 engines ....lifters failing casuing excessive wear on valve train known issue major costly repair

My pm sensors or particulate matter system malfunction and failed which lead to emissions issues and created my vehicle to drive in limp mode. Limp mode basically slowed downs the vehicle is slow as 5 mph as soon as this light displays at any time while driving on the highway. This put my safety in danger and the public as I transport what dot considers a type hazardous material. The sudden loss of power in the middle of the road has made vehicles around me extremely vulnerable to fatal collisions. I took my vehicle to the dealership where they confirmed this malfunction and problem with my vehicle but no recall has been issued as of yet no warning lamps appeared prior to the failure.

The contact owns a 2022 Ram Promaster 3500. The contact stated that while driving approximately 60 MPH, the steering wheel malfunctioned and jerked out of his hands and became difficult to turn in either direction. The vehicle was taken to the local dealer who diagnosed that the steering rack and steering rack wiring harness was faulty and needed to be replaced. The steering rack and steering rack wiring harness were replaced, and the vehicle was repaired. The contact stated that the vehicle had previously experienced the failure, and the steering rack wiring harness was replaced, but the failure reoccurred. The manufacturer was not yet contacted. The failure mileage was 60,910.

While driving on interstate leaving a construction zone started to accelerate to maybe 40mph and heard/felt a hard clang and lost all forward motion costed to side of interstate. Looked underneath truck, nothing visible broken or leaking. Restarted truck tried to move forward with no luck. Reverse worked, put back in drive loud noise again stomped on the accelerator and started moving forward very slow and difficult. Made it to an exit to look at things in a safer location than the busy interstate. Figured out that I had reverse and 5th gear so it was very hard/ slow to get moving. Check engine light on, gear ration incorrect, code P0731, Tran sensor failure, no 4x4 Transmission failure 1-4 gears not working