2008 SATURN OUTLOOK Complaints

HEADLIGHT WIRING ON THE SATURN OUTLOOK MODELS FAILS PREMATURELY AS THE HOUSING MELTS AND CAUSING THE HEADLIGHTS TO FAIL. THIS IS A SAFETY ISSUE FOR THE LIGHTS, COULD BE A FIRE HAZARD, HOWEVER, I HAVE NOT EXPERIENCED THAT. I WOULD THINK THIS IMPACTS THE CHEVY TRAVERSE AND GMC ACADIA TOO. *TR

PASSENGER HEADLIGHT FAILS INTERMITTENTLY. APPEARS TO BE DUE NOT TO THE BULB, BUT DUE TO SUB-GRADE WIRING HARNESS THAT MELTS OVER TIME. *TR

FRONT HEADLIGHT ON RIGHT SIDE STOPPED WORKING, REPLACED LOW BEAM BULB, LASTED ABOUT 2 WEEKS, REPLACED IT A 2ND TIME, AGAIN LASTING ABOUT 1 WEEK. BROUGHT TO DEALER, THEY STATED THAT IT WAS A FAULTY WIRING HARNESS TO THE HEAD LIGHT AND IS NOT COVERED UNDER WARRANTY. BROUGHT VEHICLE TO ANOTHER DEALER, WHO REPLACED WIRING HARNESS ON RIGHT SIDE UNDER WARRANTY. NOW THE LEFT SIDE IS OUT AND REPLACED BULB THAT LASTED 1 DAY. WIRING HARNESS NEEDS REPLACEMENT, WHICH I AM TOLD IS EXCESS OF $500.00. AS WARRANTY IS NOW EXPIRED. BOTH WIRING HARNESSES SHOULD HAVE BEEN REPLACED AT THE SAME TIME, GM KNOWS OF THIS PROBLEM AND SHOULD HAVE A RECALL OF ALL MODEL WITH THESE LIGHTING PROBLEMS. *TR

MAJOR SUNROOF LEAK. WHENEVER IT RAIN I HAVE A STEADY STREAM OF WATER LEAKING INTO THE CAR AND CREATING A PUDDLE OF STANDING WATER ON MY PASSENGER FLOOR BOARD. HAVE BEEN ON THE PHONE WITH HENDRICK CHEVROLET AND THEY ARE ADMIT THAT I WILL HAVE TO PAY THE REPAIRS. *KB

THE PASSENGER SIDE HEADLIGHT IS NOT FUNCTIONING. I HAVE CHECKED INTO REPLACING IT AND IT WILL COST $100 FOR ONE REPLACEMENT HEADLAMP! I HAVE ALSO HEARD THERE IS A PROBLEM WITH THE WIRING HARNESS FOR THIS MAKE/MODEL/YEAR, AND IT IS VERY DIFFICULT TO EVEN ACCESS THE LIGHT ASSEMBLY. THIS IS RIDICULOUS. *TR

AT APPROXIMATELY 35000 MILES, THE PASSENGER SIDE LOW BEAM HEADLAMP STOPPED LIGHTING. I ASSUMED THAT THE HEADLAMP HAD BLOWN, AND LEFT IT ALONE UNTIL MY STATE INSPECTION WAS DUE, 2 MONTHS LATER. WHEN I FINALLY ATTEMPTED TO REPLACE THE BULB, I LEARNED THAT THE BULB WAS FINE, BUT THE HARNESS HAD FAILED, AND MY 36000 MILE WARRANTY HAD EXPIRED.CLOSER INSPECTION REVEALED THAT THE WIRING HARNESS ON THE PASSENGER SIDE LOW BEAM HEADLAMP HAD MELTED, WHERE THE WIRES ENTER INTO THE LAMP BASE, AND ARE HELD INTO THE BASE WITH A POURED PLASTIC "BACKLIGHT" TYPE SEALER, LIKE THE TYPE SEEN POURED OVER CIRCUIT BOARDS, TO PREVENT TAMPERING. I ACCESSED THAT SOCKET, AND CUT THE FACTORY SOCKET OFF OF THE WIRE HARNESS. I REPLACED THE SOCKET WITH ONE THAT I PURCHASED ONLINE, WHICH WAS OF A MUCH HEAVIER GAUGE THAN THE INFERIOR GAUGE OF WIRE THAT CAME FROM THE FACTORY. IT IS NOW 1 YEAR LATER, AND THE EXACT SAME THING HAS OCCURRED ON THE DRIVER'S SIDE. WHEN I HOLD THE FACTORY LAMP SOCKET IN MY HAND, AND BEND THE WIRES AT THE SOCKET BASE, THE BULB WORKS ONLY INTERMITTENTLY, AS IF THE COPPER WIRE INSIDE THE INSULATION HAS DEGRADED SO SEVERELY THAT A GOOD CONTACT CAN NO LONGER BE MAINTAINED. I HAVE NOT YET ORDERED A REPLACEMENT SOCKET FOR THE DRIVER'S SIDE, AND DREAD THE LABOR THAT IS INVOLVED IN REMOVING THE TIRE, DROPPING THE FENDER COWL, CUTTING THE FACTORY HARNESS AWAY FROM THE FACTORY LAMP BASE, AND REWIRING THE NEW LAMP BASE TO THE FACTORY HARNESS.IT IS LABOR INTENSIVE, AND IT IS DANGEROUS. IT IS CLEAR TO ME THAT THE HEAT BUILD UP FROM THE BULB, IN COMBINATION WITH THE UNDERSIZED WIRING ENTERING THE BASE, HAS CREATED A MELT HAZARD, WHICH SUBSEQUENTLY ALLOWS MOISTURE INTO THE COPPER STRAND WIRE, ALLOWING THE COPPER TO CORRODE SIGNIFICANTLY, AND ULTIMATELY THE COPPER DISINTEGRATES COMPLETELY, LOSING ITS CONNECTION ALTOGETHER. *TR

THE PASSENGER HEADLIGHT BURNED OUT AND WAS REPLACED. TWO WEEKS LATER THE SAME LIGHT BURNED OUT. THIS TIME ALL THE WIRING WAS PULLED OUT AND IT WAS DISCOVERED THAT THE WIRING HARNESS WAS MELTED. LOOKING ON ONLINE IT HAS BEEN SHOWN TO BE A BIG PROBLEM. AS I AM DRIVING MY 3 CHILDREN AROUND, I WOULD LIKE MY HEADLIGHTS TO WORK AND NOT BE MELTING IN MY CAR. PLEASE HAVE GMC FIX THIS PROBLEM. A CAR THAT COST AS MUCH AS MINE SHOULD HAVE WORKING LIGHTS AND NON-MELTING PARTS. *TR

THE HEADLIGHT BURNED OUT. WHEN I WENT TO REPLACE IT I NOTICED THE WIRE WAS BURNT. AFTER READING ON THE INTERNET, MANY PEOPLE HAVE THIS PROBLEM WITH SATURN OUTLOOK. SHOULD BE A RECALL. I HAVE 40, 000 MILES AND MY WARRANTY JUST EXPIRED. THIS IS MY WIFE'S CAR, PLEASE DON'T WAIT UNTIL THERE IS A FIRE OR SOMEONE IS INJURED TO DO A RECALL. *TR

HEADLAMP FAILED, WIRING MELTED. NEXT TIME THE CAR MAY GO UP IN FLAMES. DANGEROUS!!!!! *TR

TL* THE CONTACT OWNS A 2008 SATURN OUTLOOK. THE CONTACT WAS DRIVING 25 MPH WHEN THE CHECK ENGINE, STABILITY AND TRACTION CONTROL WARNING LIGHTS ILLUMINATED FOLLOWED BY THE VEHICLE STALLING. THE VEHICLE WAS RESTARTED AFTER TWENTY MINUTES AND TAKEN TO THE DEALER. THE DEALER CONFIRMED THAT THE CRANKSHAFT SENSOR NEEDED TO BE REPLACED ALONG WITH THE COMPUTER MODULE. THE MANUFACTURER WAS NOT CONTACTED AND THE VEHICLE WAS NOT REPAIRED. THE FAILURE MILEAGE WAS 49,000 AND THE CURRENT MILEAGE WAS 49,712.