2010 SUBARU OUTBACK Complaints

This is not about my car, but instead many different cars. When a cars lights are set to it's parking lights or running lights position, often located on the turn signal stalk, at night it appears to the driver that their headlights are on, when in fact only the "parking lights are on in front. This is a problem, but not what I'm reporting. When in the parking light position (at night), it appears the headlights are on because there's some light out front AND the instrument cluster is lit up as well. Here's the defect in design, the brake lights are NOT on, completely dark at the rear of the vehicle, so drivers are driving on the highway thinking their headlights and brakes lights are on, when they're not. When the parking light position is active, it should include the brake lights. Can't imagine how many rear-enders are because of this design flaw. *The rotating light switch on turn signal stalks often get unknowingly rotated out of Auto or the headlight position when the turn signal is repeatedly used.

While driving at highway speed the tire separated at the seam of the sidewall and tread. Tire tread depth was between 9–9.5/32nd on the tire. 225/60 r17 tire. Because of the complete separation of the tire and how sudden the separation occurred, it caused the vehicle to lose control, thankfully the driver was able to get control of the vehicle and get it start safely. The safety of all occupants and vehicles on the roadway were put at risk. Tire was taken to the retailer (car dealership), retailer and consumer contacted the manufacturer who stated this is not a manufacture defect.

My daughter was concerned with the car making strange squeaking sounds on turning and braking and so I met her where her car was parked in a lot and drove it for less than 1 minute and could tell something was very wrong and that it didn't seem safe to drive home. My husband came to check as well and zeroed in on the problem being the front driver's side tire/suspension. Fortunately the Subaru dealership was less than .5 away and my husband drove it there (with flashers on). It was determined by the dealership that the subframe had rusted through (we have photos uploaded below) and a new one was ordered and replaced within the week. The materials and labor for that alone cost $1944.37. Control arm bushings, rear toe arms, and alignment were also completed. The total cost of the repair was $3281.14.

The contact owns a 2010 Subaru Outback. The contact stated that while his daughter was reversing out of the driveway, the vehicle was making an abnormal clicking sound. The contact's daughter was able to continue driving; however, the suspension was not stable. The contact and his wife test drove the vehicle and noticed that the suspension was unstable. The vehicle was taken to the dealer where it was diagnosed that the front subframe was severely corroded. The dealer diagnosed that the subframe, bushings, and the rear toe links needed to be replaced; and an alignment needed to be performed. The vehicle was not repaired. The manufacturer was notified of the failure and a case was opened. The failure mileage was approximately 114,000.

The car will die/stop working at stop signs and at abrupt stops. The problem has been confirmed by a Subaru dealer, and it is a known safety concern, as Subaru put out a safety bulletin but came up short in actually recalling the cars affected. It has been confirmed as a faulty torque converter by a dealership service department. There have been no warnings or messages prior to the problem happening. It is a HUGE safety concern, as the car will die at lights and busy intersections, causing traffic to stop abruptly. It is an accident waiting to happen!!! Because my vehicle is out of warranty, Subaru will not cover the cost of replacing this DANGEROUS system failure.

Recently, while driving home in traffic, with the car in drive while braking, my car stalled in the middle of the road. Since then, it has happened 4 times. Upon breaking while the car is in Drive, the car stalls and Check Engine Light, Battery, Engine Oil, Oil Temp, AWD, and Traction Control Warning Light come on. When I shift the car into Park, turn off the car, and restart, the lights go away and the car runs smoothly. This is a huge safety concern when the car fails while I am actively driving and has almost caused accidents. I took the car to the dealership and they said that it needs a new torque converter (see Subaru Service Bulletin 16-90-13R https://static.nhtsa.gov/odi/tsbs/2018/MC-10140492-9999.pdf). This is a huge safety liability and this issue should be recalled as the car stalling in the middle of traffic is dangerous.

I have a 2010 Subaru Outback that has significant corrosion on the rear four-way brake joint connector that can lead to a serious accident. There was a campaign that addressed this very issue (NHTSA ID: 14V-311) but it did not include 2010 Outback even though it had the same design. This issue is very serious.

Takata recall. The contact owns a 2010 Subaru Outback. The contact stated that he received notification of NHTSA Campaign Number: 19V007000 (Air Bags) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool showed no recall associated with the VIN. Consumer would like to cancel the investigation.

About three years ago; there was a recall for the headlights. Subaru did replace the headlights, but I have replaced the headlights two additional times since then. And I currently have a headlight out a marker light out. I also last year had all of my marker lights burn out.

I’m driving down the road and I hit a bump, then I go to brake and veers left, I take to my mechanic he says the my subframe cracked, car is not safe to drive, he says it happens a lot