2011 SUBARU OUTBACK Complaints

The rear brakes lines have rusted out to the point of leaking. Could of loss brakes on the road!

Transmission failure at 55mph my couldn't shift and the motor revved up all the way to the redline mark and wouldn't stop when I tried to stop it the reaction control lights came on the cruise control light was flashing the emergency break light was flashing every light on my dash was flashing there was a terrible vibration in the steering wheel the Transmission was humming really loud and just got worse the car just kept going and not stopping I could have hit someone another person a car I could have hit anything instead I choose the ditch and cornfield the car has been looked at by a repair shop and everything has been duplicated by them the problem hasn't gone away or changed all the codes were cleared and as soon as it starts up they all came back signaling the transmission and torque converter the sounds are still there also upon start up the engine starts fine but the car can't be driven can't get above 15 mph without vibration and loud noises and the motor revving up without notice this is very dangerous you can't control the car

The contact owns a 2011 Subaru Outback. The contact stated there was a clunking sound coming from the front suspension location and the vehicle started feeling unstable while driving approximately 30 MPH. The steering wheel began to sway towards the left causing the contact to use excessive force to steer the vehicle. There was no warning light illuminated. The contact took the vehicle to the dealer who diagnosed that the front subframe had fractured due to severe corrosion and needed to be replaced along with the front suspension. The front subframe and suspension was repaired; however, while doing so the dealer further diagnosed that the rear subframe and suspension had severe corrosion. The rear subframe and suspension was not repaired or replaced. The manufacturer was made aware of the failure and opened a case. The approximate failure mileage was 109,000.

The contact owns a 2011 Subaru Outback. The contact stated that the brake pedal went to the floorboard while depressed. The contact stated that the brake warning light was illuminated. The vehicle was taken to an independent mechanic and the contact was informed that subframe was severely corroded. Neither the dealer nor the manufacturer was notified of the failure. The vehicle was not repaired. The failure mileage was approximately 165,000.

My mechanic tells me my Outback's K frame/engine cradle is rotting out where the control arms are attached. This is obviously a common problem with this run of vehicles, and leads to catastrophic failure. Further, the rear brake lines have rotted, and the geniuses ran them above the fuel tank, which would have to be dropped in order to repair. I believe this is a common enough problem to warrant investigation.

Vehicle engine/transmission/torque converter dies when coming to a stop. This is especially an issue when having to stop suddenly and get going again quickly as the vehicle has to be put in neutral, restarted, and put back in drive. It is a safety issue at traffic lights, traffic signals, and in stop and go traffic that has resulted in a multitude of near-miss rear end collisions that put my life and my families lives in danger. There is a service bulletin from Subaru (Bulletin Number: 16-90-13R; Revised: 02/15/18) that addresses a similar issue, but fails to mention the vehicle engine dying and the inherent safety issues that comes with the engine shutting off.

October 2019 Torque Converter failed, with unexpected stall outs & difficulty re-starting at stops. This was potentially dangerous, as driver could not get out of way of approaching vehicles.

July 2023 badly leaking hard brake lines, apparently at Right Rear underbody 4-way connector. This caused radically diminished braking capability, rendering car not drivable.

My front subframe broke. I was driving the car and was exiting the highway. I heard a snap n then had no control. Had my mechanic look at car and said frame snapped and control arm broke. The week before i had my car alignment and new tires put on. Nothing was noticed then. Mechsaud rusted from inside out.. After talkwith many different repair shops, they all stated that the front subframe breaks on subarus. They need to change the design. I called subaru and asked them to fix. Said car was to old and to many miles. I have owned cars for over 40yrs , with well over 200k mils on them. I have never had a frame break. It's very unusual when mechanics says this is a problem with subaru. Plus the subframes are on backorder. Thats how many they are selling. Even the used parts dealers can't get them

Failure of front subframe while driving. Vehicle is unable to be driven. Vehicle pulled severely to drivers side while driving. Subframe had severe deterioration by rust . Vehicle is at Annen Brake Fond du Lac, Wi and available for inspection. Replacement part is unavailable and there is no ETA by manufacturer.