2011 SUBARU OUTBACK Complaints

rear break line failure at the junction box... complete rotten off... all other lines coating and integrity visually ok... defect in coating ..

Vehicle is failing to shift correctly causing low acceleration and road safety issues. Cruise control and manual shift paddles not working, multiple warning lights on.

Brake light came on while driving and brake pedal went to the floor..suddenly...NO brakes at all. Towed into repair facility and was informed the rear brake lines had rusted out and that the repair was major because of the routing of the rear lines under the rear seat and floor panel...a very bad rust area. Location is Maine. It was pointed out to me that there was a tech Bulletin and recall for Subaru Outbacks up to 2009....but the problem remained in the later models. MAJOR expense to access and replace the rear lines and route them properly with rust proofing! HELP!

2011 Subaru Outback has low rpm/idle stalling condition. This has caused a very dangerous safety issue while in traffic on the highway , while slowing in traffic. Several times I narrowly escaped an accident. This condition can prove deadly. There is currently a TSB 16-90-13r. This is not a recall and it should be. All years 2010-2012 especially on the Subaru Outback have been affected. The fix is a very expensive Torque converter replacement. The issue is so bad, Subaru changed the torque converter design for 2013, so again I say, why no recall and fix from Subaru? Thank you

In May, returning from VA, we noticed an odd noise coming from the right front side of the car. Then the noise stopped. Driving a week later, at about 40 mph, I again heard the noise and as I approached a yellow light and began to slow to a stop, the vehicle pulled sharply to the right. I was able to regain control, drove slowly home, called our repair shop and brought it in for evaluation. The front subframe had rusted out due to the air conditioner condenser dripping onto it. Our mechanic would not let us drive the car without repair, it was too dangerous. The subframe could have dropped at any moment. No inspections other than that of our mechanic were done. I took photos of the subframe that had been removed which are attached. It is not available for inspection as far as I know. The car sat at the mechanic's for a month waiting for parts from Subaru before being repaired.

The car got overheated on 8/20/2022, because of the mechanical and design issue, specifically the coolant pipe and hose connection which got disconnected and blew up with force ejecting hot coolant liquid. The incident almost killed my husband. The hot liquid burned his abdomen and my face. He got transported by an ambulance, got admitted to a hospital, and got a 2nd-degree burner. This entire incident endangered my entire family members while we were far from home on a road trip adventure. My kids are under 10, and they were worried and crying. The incident definitely was reproducible, because, within a 3 hours window, the hose got disconnected 4 times, where the 4th time it hit my husband and me. A Yosemite Park Ranger was helping us inspect the car on the 3rd and 4th failure. For our safety, we have not been driving the car since 8/21/2022. So, the vehicle has not been inspected by the manufacturer.

A/C Compressor locks up, and serpentine belt flies off and stops power steering. Stalls due to this locking up.

The 2011 Subaru Outback subframe (K-Frame) failed structurally while the vehicle was in operation. The bolted connection between the left side (driver side) control arm broke due to extensive corrosion of the K-frame allowing the bolt to pull through one side of the box-shaped frame. The vehicle exhibited a pronounced pull to the left and handled erratically. The vehicle was immediately driven to a local repair facility where the broken frame connections at the control arms was discovered. The vehicle has approximately 79,000 miles and has been regularly serviced. Evidence of heavy corrosion and metal fatigue were noted at several locations on the K-frame (photo attached). The 2011 Subaru Outback has been owned/operated in western NY State where roads are frequently treated with brime and salt throughout the winter season. Servicing mechanic noted that he had completed recent replacement of the K-Frame on an identical year, make, model Subaru within the previous 3 months. Comparison of the K-Frame removed from my vehicle with the identical model showed similar corrosion and failure points. The symptoms and causes of this structural failure are nearly identical to vehicle safety complaint filed by another 2011 Outback owner; NHTSA ID # 11474045. The failed subframe, along with a second subframe from an identical Subaru replaced earlier this summer are available for inspection at the motor vehicle repair facility. Photo attached. Insofar as this is the third reported structural failure on this model within a short span of a few months and Subaru has declined to address the matter responsibly, NHTSA intervention is warranted and necessary.

Upon application of the brakes approaching a stoplight, the vehicle pulled sharply to the right, entering the right lane from the left and was rendered unsafe to operate due to this condition. Had a vehicle been present at this time in the right lane, a collision would have likely occurred. Upon inspection by the mechanic, the front engine frame had broken on the right side. The broken area has two (2) large rust holes on the top and bottom sides of the box frame. Directly above the two (2) rust holes the drain for the air conditioning condenser is located. Illinois, like 22 other states in the U.S., uses road salt to combat icy road conditions. The combination of road salt with the location of the air conditioner drain tube directly above the frame failure point leads ut to reasonably conclude that this model has a design defect that led to the failure. A remedy for this issue would be to simply extend the drain tube approx. 5" so the water dripping from the air conditioning condenser does not drop onto the top, flat portion of the engine frame where road salt may accumulate over time. In addition, 1. I have possession of the original frame for inspection by the NHTSA. 2. At the time of the repair, the mechanic ordered the replacement dram from the local Subaru dealership. Our mechanic was informed that he was ordering the last remaining subframe assembly that Subaru of North America had in stock at that time.

The front subframe is rusted through on the driver's and passenger side. I am arranging to have it replaced now so it may not be available for inspection in the near future. A collapse of the subframe would obviously be a serious safety issue. I am a fairly competent amateur mechanic and found this issue myself. I've seen several instances of this discussed in online forums. This is the communication I exchanged with Subaru of America: From myself to SOA: ?Hi, I'm the owner of a very well maintained 2011 Outback. I was doing an oil change today and was looking to touch up what I thought was some surface rust on the front subframe. I was pretty upset when I saw that the front subframe was rusted through on both sides near the rear control arm mounts. This is obviously a safety issue. I know there have been issues with subframe rust on Subarus in the past and the company has replaced them. What can Subaru do to remedy this issue with our Outback? The reply from SOA: Dear [XXX], Thank you for contacting Subaru of America, Inc. We apologize for the delayed response. I am sorry to hear of the concern you are experiencing with your Outback. Subaru did issue a recall for much earlier, 2000-2002 models. This involved vehicles that may have been manufactured with improperly applied paint to the rear suspension subframe. The front subframe was not affected. Your 2011 Outback model is not affected by any warranty extensions, recalls, or service campaigns pertaining to this concern. Please know that we do track known issues through those publications. While we are always looking for ways to help our customers, your vehicle is currently outside of our warranty parameters for offering any type of repair assistance. Please let me know if you have any further questions. Sincerely, [XXX] Subaru of America, Inc. Customer Advocacy Department [XXX] INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).